Diagnostics of Plasma Pencil Discharge for Chemical Analysis

We present diagnostics of plasma pencil discharge as alternative excitation source for analytical chemistry. The plasma pencil is special type of rf plasma nozzle at atmospheric pressure. Through this nozzle flows working gas argon with aerosol. The aerosol sample introduction system employed a double pass Scott spray chamber with a pneumatic concentric nebulizer. The parameters of the plasma were calculated by optical emission spectroscopy

Interfacial Tension of the Lipid Membrane Formed from Phosphatidylcholine–Decanoic Acid and Phosphatidylcholine–Decylamine Systems

Interfacial tension has been determined for phosphatidylcholine (PC)–decanoic acid (DA) and PC–decylamine (DE) membranes. PC (lecithin), DA and DE were used in the experiments; the interfacial tension values of the pure components are 1.62 × 10−3, −2.38 × 10−2 and −3.88 × 10−2 N/m (hypothetical values for DA and DE), respectively. The 1:1 complexes were formed during formation of PC–DA and PC–DE membranes. The following parameters describing the complexes were determined: the surface concentrations of the lipid membranes formed from these complexes, \documentclass[12pt]{minimal} \usepackage{amsmath} \usepackage{wasysym} \usepackage{amsfonts} \usepackage{amssymb} \usepackage{amsbsy} \usepackage{mathrsfs} \usepackage{upgreek} \setlength{\oddsidemargin}{-69pt} \begin{document}$$A_{3}^{ - 1}$$\end{document}; the interfacial tensions of such membranes, γ3; and the stability constants of these complexes, K

Influence of sample surface topography on laser ablation process

In this work we discuss how sample surface topography can significantly influence the laser ablation (LA) process and, in turn, the analytical response of the LA Inductively Coupled Plasma Mass Spectrometry (LA-ICP-MS) method. Six different surface topographies were prepared on a certified aluminium alloy sample BAM 311 and SRM NIST 610 to investigate the phenomenon. All the samples were repetitively measured by LA-ICP-MS using a spot by spot analysis. The effect of laser fluence in the range of 1–13 J/cm2 was studied. For majority of measured isotopes, the ICP-MS signal was amplified with roughening of the sample surface. A stronger effect was observed on the Al alloy sample, where the more than sixty-time enhancement was achieved in comparison to the polished surface of the sample. Since the effect of surface topography is different for each analyte, it can be stated that surface properties affect not only the ICP-MS response, but also elemental fractionation in LA. The presented results show that different surface topographies may lead to misleading data interpretation because even when applying ablation preshots, the signal of individual elements changes. The utmost care must be taken when preparing the surface for single shot analysis or chemical mapping. On the other hand, by roughening the sample surface, it is possible to significantly increase the sensitivity of the method for individual analytes and supress a matrix effect

Fmoc-diphenylalanine self-assembly mechanism induces apparent pk(a) shifts

We report the effect of pH on the self-assembly process of Fmoc-diphenylalanine (Fmoc-FF) into fibrils consisting of antiparallel β-sheets, and show that it results in two apparent pKa shifts of 6.4 and 2.2 pH units above the theoretical pKa (3.5). Using Fourier transform infrared (FTIR) spectroscopy, transmission electron microscopy (TEM), wide angle X-ray scattering (WAXS), and oscillatory rheology, these two transitions were shown to coincide with significant structural changes. An entangled network of flexible fibrils forming a weak hydrogel dominates at high pH, while nongelling flat rigid ribbons form at intermediate pH values. Overall, this study provides further understanding of the self-assembly mechanism of aromatic short peptide derivatives