138 research outputs found
Semi-continuous mono-digestion of OFMSW and Co-digestion of OFMSW with beech sawdust: Assessment of the maximum operational total solid content
In this study, mono-digestion of the organic fraction of municipal solid waste (OFMSW) and co-digestion of OFMSW with beech sawdust, simulating green waste, were used to investigate the maximum operational total solid (TS) content in semi-continuous high-solids anaerobic digestion (HS-AD). To alleviate substrate overloading in HS-AD, the effluent mass was relatively reduced compared to the influent mass, extending the mass retention time. To this aim, the reactor mass was daily evaluated, permitting to assess the reactor content removal by biogas production. During mono-digestion of OFMSW, the NH3 inhibition and the rapid TS removal prevented to maintain HS-AD conditions (i.e. TS ≥ 10%), without exacerbating the risk of reactor acidification. In contrast, the inclusion of sawdust in OFMSW permitted to operate HS-AD up to 30% TS, before acidification occurred. Therefore, including a lignocellulosic substrate in OFMSW can prevent acidification and stabilize HS-AD at very high TS contents (i.e. 20-30%)
High-solids anaerobic digestion requires a trade-off between total solids, inoculum-to-substrate ratio and ammonia inhibition
Increasing total solids in anaerobic digestion can reduce the methane yield by highly complex bio-physical–chemical mechanisms.
Therefore, understanding those mechanisms and their main drivers becomes crucial to optimize this waste treatment
biotechnology. In this study, seven batch experiments were conducted to investigate the effects of increasing the initial
total solids in high-solids anaerobic digestion of the organic fraction of municipal solid waste. With inoculum-to-substrate
ratio = 1.5 g VS/g VS and maximum total solids ≤ 19.6%, mono-digestion of the organic fraction of municipal solid waste
showed a methane yield = 174–236 NmL CH4/
g VS. With inoculum-to-substrate ratio ≤ 1.0 g VS/g VS and maximum total
solids ≥ 24.0%, mono-digestion experiments acidified. Co-digestion of the organic fraction of municipal solid waste and beech
sawdust permitted to reduce the inoculum-to-substrate ratio to 0.16 g VS/g VS while increasing total solids up to 30.2%,
though achieving a lower methane yield (117–156 NmL CH4/
g VS). At each inoculum-to-substrate ratio, higher total solids
corresponded to higher ammonia and volatile fatty acid accumulation. Thus, a 40% lower methane yield for mono-digestion
was observed at a NH3
concentration ≥ 2.3 g N–NH3/kg reactor content and total solids = 15.0%. Meanwhile, co-digestion
lowered the nitrogen content, being the risk of acidification exacerbated only at total solids ≥ 20.0%. Therefore, the biodegradability
of the substrate, as well as the operational total solids and inoculum-to-substrate ratio, are closely interrelated parameters
determining the success of methanogenesis, but also the risk of ammonia inhibition in high-solids anaerobic digestion
High-solids anaerobic digestion model for homogenized reactors
During high-solids anaerobic digestion (HS-AD) of the organic fraction of municipal solid waste (OFMSW), an important total solid (TS) removal occurs, leading to the modification of the reactor content mass/volume, in contrast to ‘wet’ anaerobic digestion (AD). Therefore, HS-AD mathematical simulations need to be approached differently than ‘wet’ AD simulations. This study aimed to develop a modelling tool based on the anaerobic digestion model 1 (ADM1) capable of simulating the TS and the reactor mass/volume dynamics in the HS-AD of OFMSW. Four hypotheses were used, including the effects of apparent concentrations at high TS. The model simulated adequately HS-AD of OFMSW in batch and continuous mode, particularly the evolution of TS, reactor mass, ammonia and volatile fatty acids. By adequately simulating the reactor content mass/volume and the TS, this model might bring further insight about potentially inhibitory mechanisms (i.e. NH3 buildup and/or acidification) occurring in HS-AD of OFMSW
Modelling non-ideal bio-physical-chemical effects on high-solids anaerobic digestion of the organic fraction of municipal solid waste
This study evaluates the main effects of including ‘non-ideal’ bio-physical-chemical corrections in high-solids anaerobic digestion (HS-AD) of the organic fraction of municipal solid waste (OFMSW), at total solid (TS) between 10 and 40%. As a novel approach, a simple ‘non-ideal’ module, accounting for the effects of ionic strength (I) on the main acid-base equilibriums, was coupled to a HS-AD model, to jointly evaluate the effects of ‘non-ideality’ and the TS content dynamics on the HS-AD bio-physical-chemistry. ‘Non-ideality’ influenced the pH, concentration of inhibitors (i.e. NH3), and liquid-gas transfer (i.e. CO2), particularly at higher TS (i.e. ≥ 20%). Meanwhile, fitting the experimental data for batch assays at 15% TS showed that HS-AD of OFMSW might be operated at I ≥ 0.5 M. Therefore, all HS-AD simulations should account for ‘non-ideal’ corrections, when assessing the main inhibitory mechanisms (i.e. NH3 buildup and acidification) potentially occurring in HS-AD of OFMSW
Assessing practical identifiability during calibration and cross-validation of a structured model for high-solids anaerobic digestion
High-solids anaerobic digestion (HS-AD) of the organic fraction of municipal solid waste (OFMSW) is operated at a total solid (TS) content ≥ 10% to enhance the waste treatment economy, though it might be associated to free ammonia (NH3) inhibition. This study aimed to calibrate and cross-validate a HS-AD model for homogenized reactors in order to assess the effects of high NH3 levels in HS-AD of OFMSW, but also to evaluate the suitability of the reversible non-competitive inhibition function to reproduce the effect of NH3 on the main acetogenic and methanogenic populations. The practical identifiability of structural/biochemical parameters (i.e. 35) and initial conditions (i.e. 32) was evaluated using batch experiments at different TS and/or inoculum-to-substrate ratios. Variance-based global sensitivity analysis and approximate Bayesian computation were used for parameter optimization. The experimental data in this study permitted to estimate up to 8 biochemical parameters, whereas the rest of parameters and biomass contents were poorly identifiable. The study also showed the relatively high levels of NH3 (i.e. up to 2.3 g N/L) and ionic strength (i.e. up to 0.9 M) when increasing TS in HS-AD of OFMSW. However, the NH3 non-competitive function was unable to capture the acetogenic/methanogenic inhibition. Therefore, the calibration emphasized the need for target-oriented experimental data to enhance the practical identifiability and the predictive capabilities of structured HS-AD models, but also the need for further testing the NH3 inhibition function used in these simulations
Anaerobic Removal of Trace Organic Contaminants in Sewage Sludge: 15 Years of Experience
Trace organic contaminants (TOCs) correspond to a broad range of molecules generated either directly or indirectly by human activity. Even though TOCs are found at low concentrations in the environment, they often accumulate by biomagnification and bioaccumulation into biological organisms and cause irreversible damages in biological systems through direct or indirect toxic effects such as endocrine disruption and tumour initiation. This manuscript presents the main findings of over fifteen years of research focusing on biological removal of various TOCs found in sewage sludge from urban treatment plants. A special focus of the research was made on microbial processes in complex anaerobic ecosystems. Four families of compounds mostly retrieved in urban plants were studied: the polycyclic aromatic hydrocarbons (PAHs), the polychlorobiphenyls (PCBs), the phthalic acid esters (PAEs), and the nonylphenol ethoxylates (NPEs). It was observed that the microbial capability for removing low amounts of TOCs required a long adaptation time and was often limited by the bioavailability of these compounds. In fact, the overall biodegradation resulted from the numerous interactions existing between the matrix (organic matter) and the microbial ecosystems according to the physico-chemical sorption properties of these compounds. Mechanistic aspects were also tackled in depth and specific models were developed for better understanding the network of interactions between TOCs, microorganisms, and organic matter. These findings could be extrapolated to other ecosystems such as soils and sediments. Finally, it was shown that microbial cometabolism was essential for TOC removal, and the concept of bioavailability was not only dependent on the nature, the level, and the sorption properties of TOCs but was also strongly dependent on the nature and the concentration of the sludge organic matter. Specific parameters were proposed for better evaluating the fate of TOCs in microbial anaerobic processes and technological solutions for efficient removal of these compounds were also proposed
Enhanced Fermentative Hydrogen Production from Food Waste in Continuous Reactor after Butyric Acid Treatment
End-product accumulation during dark fermentation leads to process instability and hydrogen production inhibition. To overcome this constraint, microbial community adaptation to butyric acid can induce acid tolerance and thus enhance the hydrogen yields; however, adaptation and selection of appropriate microbial communities remains uncertain when dealing with complex substrates in a continuous fermentation mode. To address this question, a reactor fed in continuous mode with food waste (organic loading rate of 60 gVS·L·d−1; 12 h hydraulic retention time) was first stressed for 48 h with increasing concentrations of butyric acid (up to 8.7 g·L−1). Performances were compared with a control reactor (unstressed) for 13 days. During 6 days in a steady-state, the pre-stressed reactor produced 2.2 ± 0.2 LH2·L·d−1, which was 48% higher than in the control reactor (1.5 ± 0.2 LH2·L·d−1). The pretreatment also affected the metabolites’ distribution. The pre-stressed reactor presented a higher production of butyric acid (+44%) achieving up to 3.8 ± 0.3 g·L−1, a lower production of lactic acid (−56%), and an enhancement of substrate conversion (+9%). The performance improvement was attributed to the promotion of Clostridium guangxiense, a hydrogen -producer, with a relative abundance increasing from 22% in the unstressed reactor to 52% in the stressed reactor
- …