Silver nanoparticles augment releasing of pyrogenic factors by blood cells stimulated with LPS

Silver nanoparticles (AgNPs) have cytotoxic properties via generation of reactive oxygen species which are involved in the generalized sickness behavior of the host including fever and lethargy among others. The aim of the present study was to investigate the impact of AgNPs on the ability of rat peripheral blood mononuclear cells (PBMCs) to release fever mediating factors after stimulation with lipopolysaccharide (LPS). Body temperature and motor activity of the Wistar rats were measured by biotelemetry system. Rat PBMCs were stimulated with LPS and after that, the cells were washed and incubated alone or with AgNPs. The final supernatants were injected intraperitoneally. The levels of endogenous pyrogens such as interleukin-1β (IL-1β), IL-6 and tumor necrosis factor-α (TNF-α) released from the PBMCs into the final supernatants were also estimated. The results indicated that injection of the supernatants from the cells stimulated with LPS induced fever and inhibited motor activity. These effects were potentiated by the presence of AgNPs during the final incubation. The presence of the AgNPs also resulted in significant increases in levels of endogenous pyrogens. The augmentation of fever in the rats by the AgNPs treatment of the cultures seemed to be primarily associated with the changes in interleukin-1β levels

Polysaccharide peptide induces a tumor necrosis factor-α-dependent drop of body temperature in rats

Polysaccharide peptide (PSP) extracted from the Coriolus versicolor mushroom is frequently suggested as an adjunct to the chemo- or radiotherapy in cancer patients. It improves quality of the patients‟ life by decreasing pain, fatigue, loss of appetite, nausea, and vomiting. However, the effect of PSP on body temperature has not thus far been studied, although it is well known that treatment with other polysaccharide adjuvants, such as lipopolysaccharides, may induce fever. The aim of the present study, therefore, was to investigate the influence of PSP on temperature regulation in rats. We report that intraperitoneal injection of PSP provoked a dose-dependent decrease of temperature in male Wistar rats equipped with biotelemetry devices to monitor deep body temperature (Tb). The response was rapid (i.e., with latency of 15-20 minutes), transient (lasting up to 5 hours post-injection), and accompanied by a significant elevation of the blood tumor necrosis factor- α (TNF-α) level. Pretreatment of the rats with anti-TNF-α antibody prevented the PSP-induced drop in Tb. Based on these data, we conclude that rats may develop an anapyrexia-like response to the injection of peptidopolysaccharide rather than fever, and the response was TNF-α-dependent

Fabrication of corrugated Ge-doped silica fibers

We present a method of fabricating Ge-doped SiO2 fibers with corrugations around their full circumference for a desired length in the longitudinal direction. The procedure comprises three steps: hydrogenation of Ge-doped SiO2 fibers to increase photosensitivity, recording of Bragg gratings with ultraviolet light to achieve modulation of refractive index, and chemical etching. Finite-length, radially corrugated fibers may be used as couplers. Corrugated tapered fibers are used as high energy throughput probes in scanning near-field optical microscopy

Polysaccharide peptide from Coriolus versicolor induces interleukin 6-related extension of endotoxin fever in rats

Purpose: Polysaccharide peptide (PSP) extracted from the Coriolus versicolor mushroom is frequently suggested as an adjunct to the chemo- or radiotherapy in cancer patients. In a previous study we showed that PSP induced a tumour necrosis factor-a (TNF-a)-dependent anapyrexia-like response in rats. Thus, PSP appears to be a factor which modifies a number of pathophysiological responses. Because of this, PSP is suggested as a potential adjuvant for cancer therapy during which cancer patients frequently contract microbial infections accompanied by fever. The aim of the present study was to investigate whether or not PSP can modulate the course of the fever in response to an antigen such as lipopolysaccharide (LPS). Materials and methods: Body temperature (Tb) of male Wistar rats was measured by biotelemetry. PSP was injected intraperitoneally (i.p.) at a dose of 100mgkg 1, 2 h before LPS administration (50 mgkg 1, i.p.). The levels of interleukin (IL)-6 and TNF-a in the plasma of rats were estimated 3 h and 14 h post-injection of PSP using a standard sandwich ELISA kit. Results: We report that i.p. pre-injection of PSP 2 h before LPS administration expanded the duration of endotoxin fever in rats. This phenomenon was accompanied by a significant elevation of the blood IL-6 level of rats both 3 h and 14 h post-injection of PSP. Pre-treatment i.p. of the rats with anti-IL-6 antibody (30 mg/rat) prevented the PSP-induced prolongation of endotoxin fever. Conclusions: Based on these data, we conclude that PSP modifies the LPS-induced fever in IL-6-related fashion

Fabrication of corrugated probes for scanning near-field optical microscopy

We present a method of fabricating aperture tapered-fiber metal-coated SNOM probes with a corrugated core surface which assures efficient photon-to-plasmon conversion and thus high energy throughput. High energy throughput allows for a small apex aperture and high resolution. The procedure consists of recording of Bragg grating in the to-be-tapered part of a Ge-doped silica fiber and chemical etching with the Turner method. Bragg gratings are recorded with UV light through nearly sinusoidal phase masks of chosen lattice constants. The refractive index contrast in the Bragg grating differentiates the etch rate of the Ge-doped hydrogenated fiber core in exposed and unexposed parts by about 100 nm/min at room temperature

Preparation of high energy throughput SNOM probes

In this technical note we present technological steps of fabrication of high energy throughput SNOM probes. The core-metal coating interface of probes is corrugated what enhances photon-to-plasmon coupling. A strong evanescent field allows for reduction of aperture diameter, which together with skin depth of metal used for coating decide upon resolution. Probes are made of Ge-doped silica glass fibre, which is hydrogenated to increase its photosensitivity. A Bragg grating is recorded in the cores with UV light diffracted into +1 st/1st diffraction orders on a sinusoidal phase mask. Modulation of the refractive index is connected with different etch rates. Etching with the Turner method is made in aqueous solution of HF acid. A corrugated tapered fibre is then coated with aluminium in a special rotating holder. We present results of this novel multi step technology

A Hybrid Fiber Optic Sensing System for Simultaneous Strain and Temperature Measurement and its Application

A hybrid fiber optic sensor by integrating polarimetric fiber sensors and fiber Bragg grating sensors for simultaneous strain and temperature measurement is presented in this paper. Two types of polarimetric fiber sensors are used; a Panda fiber and a polarization maintaining photonic crystal fiber. The polarimetric strain sensors give the average strain and temperature information, while the fiber Bragg grating sensors give localized strain information. Two applications of the proposed configuration are also demonstrated in this paper. In the composite materials three fiber sensors are used while for other engineering applications a temperature insensitive polarimetric fiber sensor can be used together with an FBG sensor to measure strain and temperature simultaneously

Comprehensive Evaluation of the Biological Properties of Surface-Modified Titanium Alloy Implants

An increasing interest in the fabrication of implants made of titanium and its alloys results from their capacity to be integrated into the bone system. This integration is facilitated by different modifications of the implant surface. Here, we assessed the bioactivity of amorphous titania nanoporous and nanotubular coatings (TNTs), produced by electrochemical oxidation of Ti6Al4V orthopedic implants' surface. The chemical composition and microstructure of TNT layers was analyzed by X-ray photoelectron spectroscopy (XPS) and X-ray diffraction (XRD). To increase their antimicrobial activity, TNT coatings were enriched with silver nanoparticles (AgNPs) with the chemical vapor deposition (CVD) method and tested against various bacterial and fungal strains for their ability to form a biofilm. The biointegrity and anti-inflammatory properties of these layers were assessed with the use of fibroblast, osteoblast, and macrophage cell lines. To assess and exclude potential genotoxicity issues of the fabricated systems, a mutation reversal test was performed (Ames Assay MPF, OECD TG 471), showing that none of the TNT coatings released mutagenic substances in long-term incubation experiments. The thorough analysis performed in this study indicates that the TNT5 and TNT5/AgNPs coatings (TNT5-the layer obtained upon applying a 5 V potential) present the most suitable physicochemical and biological properties for their potential use in the fabrication of implants for orthopedics. For this reason, their mechanical properties were measured to obtain full system characteristics