Comparison of free-piston Stirling engine model predictions with RE1000 engine test data

Predictions of a free-piston Stirling engine model are compared with RE1000 engine test data taken at NASA-Lewis Research Center. The model validation and the engine testing are being done under a joint interagency agreement between the Department of Energy's Oak Ridge National Laboratory and NASA-Lewis. A kinematic code developed at Lewis was upgraded to permit simulation of free-piston engine performance; it was further upgraded and modified at Lewis and is currently being validated. The model predicts engine performance by numerical integration of equations for each control volume in the working space. Piston motions are determined by numerical integration of the force balance on each piston or can be specified as Fourier series. In addition, the model Fourier analyzes the various piston forces to permit the construction of phasor force diagrams. The paper compares predicted and experimental values of power and efficiency and shows phasor force diagrams for the RE1000 engine displacer and piston. Further development plans for the model are also discussed

Digital computer study of nuclear reactor thermal transients during startup of 60-kWe Brayton power conversion system

A digital computer study was made of reactor thermal transients during startup of the Brayton power conversion loop of a 60-kWe reactor Brayton power system. A startup procedure requiring the least Brayton system complication was tried first; this procedure caused violations of design limits on key reactor variables. Several modifications of this procedure were then found which caused no design limit violations. These modifications involved: (1) using a slower rate of increase in gas flow; (2) increasing the initial reactor power level to make the reactor respond faster; and (3) appropriate reactor control drum manipulation during the startup transient

Analysis of regenerated single-shaft ceramic gas-turbine engines and resulting fuel economy in a compact car

Ranges in design and off-design operating conditions of an advanced gas turbine and their effects on fuel economy were analyzed. The assumed engine incorporated a single stage radial flow turbine and compressor with fixed geometry. Fuel economies were calculated over the composite driving cycle with gasoline as the fuel. At a constant turbine-inlet temperature, with a regenerator sized for a full power effectiveness the best fuel economies ranged from 11.1 to 10.2 km/liter (26.2 to 22.5 mpg) for full power turbine tip speeds of 770 to 488m/sec (2530 to 1600ft/sec), respectively

Downsizing assessment of automotive Stirling engines

A 67 kW (90 hp) Stirling engine design, sized for use in a 1984 1440 kg (3170 lb) automobile was the focal point for developing automotive Stirling engine technology. Since recent trends are towards lighter vehicles, an assessment was made of the applicability of the Stirling technology being developed for smaller, lower power engines. Using both the Philips scaling laws and a Lewis Research Center (Lewis) Stirling engine performance code, dimensional and performance characteristics were determined for a 26 kW (35 hp) and a 37 kW (50 hp) engine for use in a nominal 907 kg (2000 lb) vehicle. Key engine elements were sized and stressed and mechanical layouts were made to ensure mechanical fit and integrity of the engines. Fuel economy estimates indicated that the Stirling engine would maintain a 30 to 45 percent fuel economy advantage comparable spark ignition and diesel powered vehicles in the 1984 period

Initial Comparison of Single Cylinder Stirling Engine Computer Model Predictions with Test Results

A Stirling engine digital computer model developed at NASA Lewis Research Center was configured to predict the performance of the GPU-3 single-cylinder rhombic drive engine. Revisions to the basic equations and assumptions are discussed. Model predictions with the early results of the Lewis Research Center GPU-3 tests are compared

Mobile radio propagation prediction using ray tracing methods

The basic problem is to solve the two-dimensional scalar Helmholtz equation for a point source (the antenna) situated in the vicinity of an array of scatterers (such as the houses and any other relevant objects in 1 square km of urban environment). The wavelength is a few centimeters and the houses a few metres across, so there are three disparate length scales in the problem. The question posed by BT concerned ray counting on the assumptions that: (i) rays were subject to a reflection coefficient of about 0.5 when bouncing off a house wall and (ii) that diffraction at corners reduced their energy by 90%. The quantity of particular interest was the number of rays that need to be accounted for at any particular point in order for those neglected to only contribute 10% of the field at that point; a secondary question concerned the use of rays to predict regions where the field was less than 1% of that in the region directly illuminated by the antenna. The progress made in answering these two questions is described in the next two sections and possibly useful representations of the solution of the Helmholtz equations in terms other than rays are given in the final section

Semiclassical transmission across transition states

It is shown that the probability of quantum-mechanical transmission across a phase space bottleneck can be compactly approximated using an operator derived from a complex Poincar\'e return map. This result uniformly incorporates tunnelling effects with classically-allowed transmission and generalises a result previously derived for a classically small region of phase space.Comment: To appear in Nonlinearit

H₃P⋯AgI:Generation by laser-ablation and characterization by rotational spectroscopy and: Ab initio calculations

The new compound H(3)P···AgI has been synthesized in the gas phase by means of the reaction of laser-ablated silver metal with a pulse of gas consisting of a dilute mixture of ICF(3) and PH(3) in argon. Ground-state rotational spectra were detected and assigned for the two isotopologues H(3)P···(107)AgI and H(3)P···(109)AgI in their natural abundance by means of a chirped-pulse, Fourier-transform, microwave spectrometer. Both isotopologues exhibit rotational spectra of the symmetric-top type, analysis of which led to accurate values of the rotational constant B (0), the quartic centrifugal distortion constants D (J) and D (JK), and the iodine nuclear quadrupole coupling constant χ (aa)(I) = eQq (aa). Ab initio calculations at the explicitly-correlated level of theory CCSD(T)(F12*)/aug-cc-pVDZ confirmed that the atoms P···Ag–I lie on the C (3) axis in that order. The experimental rotational constants were interpreted to give the bond lengths r (0)(P···Ag) = 2.3488(20) Å and r (0)(Ag–I) = 2.5483(1) Å, in good agreement with the equilibrium lengths of 2.3387 Å and 2.5537 Å, respectively, obtained in the ab initio calculations. Measures of the strength of the interaction of PH(3) and AgI (the dissociation energy D (e) for the process H(3)P···AgI = H(3)P + AgI and the intermolecular stretching force constant F (P···Ag)) are presented and are interpreted to show that the order of binding strength is H(3)P···HI < H(3)P···ICl < H(3)P···AgI for these metal-bonded molecules and their halogen-bonded and hydrogen-bonded analogues

Problem gambling: a suitable case for social work?

Problem gambling attracts little attention from health and social care agencies in the UK. Prevalence surveys suggest that 0.6% of the population are problem gamblers and it is suggested that for each of these individuals, 10–17 other people, including children and other family members, are affected. Problem gambling is linked to many individual and social problems including: depression, suicide, significant debt, bankruptcy, family conflict, domestic violence, neglect and maltreatment of children and offending. This makes the issue central to social work territory. Yet, the training of social workers in the UK has consistently neglected issues of addictive behaviour. Whilst some attention has been paid in recent years to substance abuse issues, there has remained a silence in relation to gambling problems. Social workers provide more help for problems relating to addictions than other helping professions. There is good evidence that treatment, and early intervention for gambling problems, including psycho-social and public health approaches, can be very effective. This paper argues that problem gambling should be moved onto the radar of the social work profession, via inclusion on qualifying and post-qualifying training programmes and via research and dissemination of good practice via institutions such as the Social Care Institute for Excellence (SCIE). Keywords: problem gambling; addictive behaviour; socia