8,085 research outputs found
When corporate social responsibility matters: An empirical investigation of contingencies
Rather than re-examine the question of whether doing good generally helps a company to do well, this study draws on contingency theory to empirically examine when doing good helps a company do as well as possible. Using panel data, we examine the effects of industry life cycle, munificence, and instability on the relationship between corporate social responsibility (CSR) and corporate financial performance (CFP). Our findings indicate that life cycle has a significant impact on the CSR-CFP relationship, as does industry instability. These findings suggest that CSR helps the bottom line considerably – if it is applied at the right time
Processing, Microstructures, and Mechanical Behavior of High-Entropy Alloys
Recently, high-entropy alloys (HEAs) have attracted increasing attentions because of their unique compositions, microstructures, and adjustable properties. In this work, microstructure and phase composition of the AlCoCrFeNi high-entropy alloy (HEA) were studied in as-cast and heat-treated conditions. Using a combination of Electron Backscatter Diffraction (EBSD), X-ray energy spectroscopy analysis, and synchrotron X-ray diffraction techniques, two nonequilibrium phases were identified in the as-cast condition: BCC_A2 and B2. Long-term heat treatment transformed these nonequilibrium phases into four equilibrium phases: FCC_A1, BCC_A2, B2, and σ [sigma] phase. The electron microscopic results were consistent with thermodynamic simulations of the equilibrium and nonequilibrium conditions.
Tensile properties of AlCoCrFeNi high entropy alloy (HEA) in two conditions, (i) as-cast and (ii) heat-treated, were also reported. The heat treatment consisted of hot isostatic pressing at 1,373 K, 207 MPa for 1 hours followed by annealing at 1,423 K for 50 hours. A noticeable increase in the tensile ductility occurred after heat treatment. During deformation at 973 K, elongation of the heat-treated alloy was 11 %, while the as-cast alloy showed elongation of only ~ 0.9 %. The ultimate tensile strength was almost unaffected by heat treatment, and it was 407 ± 5 MPa at 973 K. The properties of the alloy were correlated to its as-cast and heat-treated microstructures. The fracture mechanisms were discussed in detail by analyzing the features on and below the fracture surface. The formation of FCC_A1 phase, less casting pores, and residual stresses removed, may contribute to the significant improvement of tensile behavior
Experimental study of the effectiveness of a water system in blocking fire-induced smoke and heat in reduced-scale tunnel tests
- …