13 research outputs found

    Investigating off-Hugoniot states using multi-layer ring-up targets

    Get PDF
    Laser compression has long been used as a method to study solids at high pressure. This is commonly achieved by sandwiching a sample between two diamond anvils and using a ramped laser pulse to slowly compress the sample, while keeping it cool enough to stay below the melt curve. We demonstrate a different approach, using a multilayer ‘ring up’ target whereby laser-ablation pressure compresses Pb up to 150 GPa while keeping it solid, over two times as high in pressure than where it would shock melt on the Hugoniot. We find that the efficiency of this approach compares favourably with the commonly used diamond sandwich technique and could be important for new facilities located at XFELs and synchrotrons which often have higher repetition rate, lower energy lasers which limits the achievable pressures that can be reached

    Lawson criterion for ignition exceeded in an inertial fusion experiment

    Get PDF
    For more than half a century, researchers around the world have been engaged in attempts to achieve fusion ignition as a proof of principle of various fusion concepts. Following the Lawson criterion, an ignited plasma is one where the fusion heating power is high enough to overcome all the physical processes that cool the fusion plasma, creating a positive thermodynamic feedback loop with rapidly increasing temperature. In inertially confined fusion, ignition is a state where the fusion plasma can begin "burn propagation" into surrounding cold fuel, enabling the possibility of high energy gain. While "scientific breakeven" (i.e., unity target gain) has not yet been achieved (here target gain is 0.72, 1.37 MJ of fusion for 1.92 MJ of laser energy), this Letter reports the first controlled fusion experiment, using laser indirect drive, on the National Ignition Facility to produce capsule gain (here 5.8) and reach ignition by nine different formulations of the Lawson criterion

    Multiple film plane diagnostic for shocked lattice measurements

    No full text
    Laser-based shock experiments have been conducted in thin Si and Cu crystals at pressures above the Hugoniot elastic limit. In these experiments, static film and x-ray streak cameras recorded x rays diffracted from lattice planes both parallel and perpendicular to the shock direction. These data, showed uniaxial compression of Si(100) along the shock direction and three.-dimensional compression of Cu(100). In the case of the Si diffraction, there was a multiple wave structure observed, which may be due to a one-dimensional phase transition or a time variation in the shock pressure. A new film-based detector has been developed for these in situ dynamic diffraction experiments. This large-angle detector consists of three film cassettes that are positioned to record x rays diffracted from a shocked crystal anywhere within a full pi steradian. It records x rays that are diffracted from multiple lattice planes both parallel and at oblique angles with respect to the shock direction. It is a time-integrating measurement, but time-resolved data may be recorded using a short duration laser pulse to create the diffraction source x rays. This new instrument,has been fielded at the OMEGA and Janus lasers to study single-crystal materials shock compressed by direct laser irradiation. In these experiments, a multiple wave structure was observed on many different lattice planes in Si. These data provide information on, the structure under compression. (C) 2003 American Institute of Physics

    Diagnosing direct-drive, shock-heated, and compressed plastic planar foils with noncollective spectrally resolved x-ray scattering

    No full text
    The electron temperature (Te) and average ionization (Z) of nearly Fermi-degenerate, direct-drive, shock-heated, and compressed plastic planar foils were investigated using noncollective spectrally resolved x-ray scattering on the OMEGA Laser System [T. R. Boehly, Opt. Commun. 133, 495 (1997)]. Plastic (CH) and Br-doped CH foils were driven with six beams, having an overlapped intensity of ∼1× 1014 W cm2 and generating ∼15 Mbar pressure in the foil. The plasma conditions of the foil predicted with a one-dimensional (1-D) hydrodynamics code are Te ∼10 eV, Z∼1, mass density ρ ∼4 g cm3, and electron density ne ∼3× 1023 cm-3. The uniformly compressed portion of the target was probed with 9.0-keV x rays from a Zn Heα backlighter created with 18 additional tightly focused beams. The x rays scattered at either 90° or 120° were dispersed with a Bragg crystal spectrometer and recorded with an x-ray framing camera. An examination of the scattered x-ray spectra reveals that an upper limit of Z∼2 and Te =20 eV are inferred from the spectral line shapes of the elastic Rayleigh and inelastic Compton components. Low average ionizations (i.e., Z<2) cannot be accurately diagnosed in this experiment due to the difficulties in distinguishing delocalized valence and free electrons. Trace amounts of Br in the CH foil (i.e., 2% atomic concentration) are shown to increase the sensitivity of the noncollective, spectrally resolved x-ray scattering to changes in the average ionization. The experimentally inferred electron temperatures are comparable to the 1-D predictions. © 2007 American Institute of Physics

    Inferring the electron temperature and density of shocked liquid deuterium using inelastic X-ray scattering

    No full text
    An experiment designed to launch laser-ablation-driven shock waves (10 to 70 Mbar) in a planar liquid-deuterium target on the OMEGA Laser System and to diagnose the shocked conditions using inelastic x-ray scattering is described. The electron temperature (T e) is inferred from the Doppler-broadened Compton-downshifted peak of the noncollective (α s = 1kλ D > 1) x-ray scattering for T e > T Fermi. The electron density (n e) is inferred from the downshifted plasmon peak of the collective (α scatter > 1) x-ray scattering. A cylindrical layer of liquid deuterium is formed in a cryogenic cell with 8-μm-thick polyimide windows. The polyimide ablator is irradiated with peak intensities in the range of 10 13 to 10 15 W/cm 2 and shock waves are launched. Predictions from a 1-D hydrodynamics code show the shocked deuterium has a thickness of ∼0.1 mm with spatially uniform conditions. For the drive intensities under consideration, electron density up to ∼5 × 10 23 cm -3 and electron temperature in the range of 10 to 25 eV are predicted. A laser-irradiated saran foil produces Cl Ly αemission. The spectrally resolved x-ray scattering is recorded at 90° for the noncollective scattering and at 40° for the collective scattering with a highly oriented pyrolytic graphite (HOPG) crystal spectrometer and an x-ray framing camera. © 2010 IOP Publishing Ltd

    Fast-ignition target design and experimental-concept validation on OMEGA

    No full text
    A comprehensive scientific program is being pursued at LLE to explore the physics of fast ignition. The OMEGA EP Laser was completed in April 2008, adjacent to the 60 beam, 30 kJ OMEGA Laser Facility. OMEGA EP consists of four beamlines with a NIF-like architecture, each delivering up to 6.5 kJ of UV laser energy in long pulse (ns) mode into the OMEGA EP target chamber. Two of the beamlines can operate as high-energy petawatt lasers, with up to 2.6 kJ each with 10 ps pulse duration. These beams can either be injected into the OMEGA EP target chamber or combined collinearly into the existing OMEGA target chamber for integrated fast-ignitor experiments. Fuel-assembly experiments on OMEGA have achieved high fuel areal densities, and the effects of a cone on the fuel assembly are being studied. Experiments on short-pulse laser systems in collaboration with other institutions are being pursued to investigate the conversion efficiency from laser energy to fast electrons. A coherent transition radiation diagnostic to study the transport of the electrons in high-density material is being developed. Integrated experiments with room-temperature targets on OMEGA will be performed in 2008. Simulations of these integrated experiments show significant heating of up to 1 keV due to the hot electrons from the short-pulse laser. © 2008 IOP Publishing Ltd

    Observation of finite-wavelength screening in high-energy-density matter

    Get PDF
    A key component for the description of charged particle systems is the screening of the Coulomb interaction between charge carriers. First investigated in the 1920s by Debye and Hückel for electrolytes, charge screening is important for determining the structural and transport properties of matter as diverse as astrophysical and laboratory plasmas, nuclear matter such as quark-gluon plasmas, electrons in solids, planetary cores and charged macromolecules. For systems with negligible dynamics, screening is still mostly described using a Debye–Hückel-type approach. Here, we report the novel observation of a significant departure from the Debye–Hückel-type model in high-energy-density matter by probing laser-driven, shock-compressed plastic with high-energy X-rays. We use spectrally resolved X-ray scattering in a geometry that enables direct investigation of the screening cloud, and demonstrate that the observed elastic scattering amplitude is only well described within a more general approach
    corecore