Hydrogen absorption properties of amorphous (Ni0.6Nb0.4−yTay)100−xZrx membranes

Ni based amorphous materials have great potential as hydrogen purification membranes. In the present work the melt spun (Ni0.6Nb0.4−yTay)100−xZrx with y=0, 0.1 and x=20, 30 was studied. The result of X-ray diffraction spectra of the ribbons showed an amorphous nature of the alloys. Heating these ribbons below T < 400 °C, even in a hydrogen atmosphere (1−10 bar), the amorphous structure was retained. The crystallization process was characterized by differential thermal analysis and the activation energy of such process was obtained. The hydrogen absorption properties of the samples in their amorphous state were studied by the volumetric method, and the results showed that the addition of Ta did not significantly influence the absorption properties, a clear change of the hydrogen solubility was observed with the variation of the Zr content. The values of the hydrogenation enthalpy changed from ~37 kJ/mol for x=30 to ~9 kJ/mol for x=20. The analysis of the volumetric data provides the indications about the hydrogen occupation sites during hydrogenation, suggesting that at the beginning of the absorption process the deepest energy levels are occupied, while only shallower energy levels are available at higher hydrogen content, with the available interstitial sites forming a continuum of energy levels

Gravitational waves from inspiraling compact binaries: Second post-Newtonian waveforms as search templates II

We present further evidence that the second post-Newtonian (pN) approximation to the gravitational waves emitted by inspiraling compact binaries is sufficient for the detection of these systems. This is established by comparing the 2-pN wave forms to signals calculated from black hole perturbation theory. Results are presented for different detector noise curves. We also discuss the validity of this type of analysis.Comment: 5 pages, 3 Figures, RevTe

Can the post-Newtonian gravitational waveform of an inspiraling binary be improved by solving the energy balance equation numerically?

The detection of gravitational waves from inspiraling compact binaries using matched filtering depends crucially on the availability of accurate template waveforms. We determine whether the accuracy of the templates' phasing can be improved by solving the post-Newtonian energy balance equation numerically, rather than (as is normally done) analytically within the post-Newtonian perturbative expansion. By specializing to the limit of a small mass ratio, we find evidence that there is no gain in accuracy.Comment: 13 pages, RevTeX, 5 figures included via eps

A Comparison of search templates for gravitational waves from binary inspiral

We compare the performances of the templates defined by three different types of approaches: traditional post-Newtonian templates (Taylor-approximants), ``resummed'' post-Newtonian templates assuming the adiabatic approximation and stopping before the plunge (P-approximants), and further ``resummed'' post-Newtonian templates going beyond the adiabatic approximation and incorporating the plunge with its transition from the inspiral (Effective-one-body approximants). The signal to noise ratio is significantly enhanced (mainly because of the inclusion of the plunge signal) by using these new effective-one-body templates relative to the usual post-Newtonian ones for binary masses greater than $30 M_\odot$, the most likely sources for initial laser interferometers. Independently of the question of the plunge signal, the comparison of the various templates confirms the usefulness of using resummation methods. The paper also summarizes the key elements of the construction of various templates and thus can serve as a resource for those involved in writing inspiral search software.Comment: eta-dependent tail terms corrected after related errata by Blanchet (2005

Measuring gravitational waves from binary black hole coalescences: II. the waves' information and its extraction, with and without templates

We discuss the extraction of information from detected binary black hole (BBH) coalescence gravitational waves, focusing on the merger phase that occurs after the gradual inspiral and before the ringdown. Our results are: (1) If numerical relativity simulations have not produced template merger waveforms before BBH detections by LIGO/VIRGO, one can band-pass filter the merger waves. For BBHs smaller than about 40 solar masses detected via their inspiral waves, the band pass filtering signal to noise ratio indicates that the merger waves should typically be just barely visible in the noise for initial and advanced LIGO interferometers. (2) We derive an optimized (maximum likelihood) method for extracting a best-fit merger waveform from the noisy detector output; one "perpendicularly projects" this output onto a function space (specified using wavelets) that incorporates our prior knowledge of the waveforms. An extension of the method allows one to extract the BBH's two independent waveforms from outputs of several interferometers. (3) If numerical relativists produce codes for generating merger templates but running the codes is too expensive to allow an extensive survey of the merger parameter space, then a coarse survey of this parameter space, to determine the ranges of the several key parameters and to explore several qualitative issues which we describe, would be useful for data analysis purposes. (4) A complete set of templates could be used to test the nonlinear dynamics of general relativity and to measure some of the binary parameters. We estimate the number of bits of information obtainable from the merger waves (about 10 to 60 for LIGO/VIRGO, up to 200 for LISA), estimate the information loss due to template numerical errors or sparseness in the template grid, and infer approximate requirements on template accuracy and spacing.Comment: 33 pages, Rextex 3.1 macros, no figures, submitted to Phys Rev

Time-frequency detection algorithm for gravitational wave bursts

An efficient algorithm is presented for the identification of short bursts of gravitational radiation in the data from broad-band interferometric detectors. The algorithm consists of three steps: pixels of the time-frequency representation of the data that have power above a fixed threshold are first identified. Clusters of such pixels that conform to a set of rules on their size and their proximity to other clusters are formed, and a final threshold is applied on the power integrated over all pixels in such clusters. Formal arguments are given to support the conjecture that this algorithm is very efficient for a wide class of signals. A precise model for the false alarm rate of this algorithm is presented, and it is shown using a number of representative numerical simulations to be accurate at the 1% level for most values of the parameters, with maximal error around 10%.Comment: 26 pages, 15 figures, to appear in PR

Detecting gravitational waves from precessing binaries of spinning compact objects: Adiabatic limit

Black-hole (BH) binaries with single-BH masses m=5--20 Msun, moving on quasicircular orbits, are among the most promising sources for first-generation ground-based gravitational-wave (GW) detectors. Until now, the development of data-analysis techniques to detect GWs from these sources has been focused mostly on nonspinning BHs. The data-analysis problem for the spinning case is complicated by the necessity to model the precession-induced modulations of the GW signal, and by the large number of parameters needed to characterize the system, including the initial directions of the spins, and the position and orientation of the binary with respect to the GW detector. In this paper we consider binaries of maximally spinning BHs, and we work in the adiabatic-inspiral regime to build families of modulated detection templates that (i) are functions of very few physical and phenomenological parameters, (ii) model remarkably well the dynamical and precessional effects on the GW signal, with fitting factors on average >~ 0.97, but (iii) might require increasing the detection thresholds, offsetting at least partially the gains in the fitting factors. Our detection-template families are quite promising also for the case of neutron-star--black-hole binaries, with fitting factors on average ~ 0.93. For these binaries we also suggest (but do not test) a further template family, which would produce essentially exact waveforms written directly in terms of the physical spin parameters.Comment: 38 pages, 16 figures, RevTeX4. Final PRD version. Lingering typos corrected. Small corrections to GW flux terms as per Blanchet et al., PRD 71, 129902(E)-129904(E) (2005