26,157 research outputs found
Volume-reflecting dielectric heat shield
White, volume-reflecting dielectric material absorbs essentially none of the incident radiant energy, and continues to reflect even though in severe environment its surface is melted and is being vaporized. Process of overall reflectance in dielectric material, involving internal refractions and reflections, is similar to process of reflection in paints
Review of solar fuel-producing quantum conversion processes
The status and potential of fuel-producing solar photochemical processes are discussed. Research focused on splitting water to produce dihydrogen and is at a relatively early stage of development. Current emphasis is primarily directed toward understanding the basic chemistry underlying such quantum conversion processes. Theoretical analyses by various investigators predict a limiting thermodynamic efficiency of 31% for devices with a single photosystem operating with unfocused sunlight at 300 K. When non-idealities are included, it appears unlikely that actual devices will have efficiencies greater than 12 to 15%. Observed efficiencies are well below theoretical limits. Cyclic homogeneous photochemical processes for splitting water have efficiencies considerably less than 1%. Efficiency can be significantly increased by addition of a sacrificial reagent; however, such systems are no longer cyclic and it is doubtful that they would be economical on a commercial scale. The observed efficiencies for photoelectrochemical processes are also low but such systems appear more promising than homogeneous photochemical systems. Operating and systems options, including operation at elevated temperature and hybrid and coupled quantum-thermal conversion processes, are also considered
Solar photochemical process engineering for production of fuels and chemicals
The engineering costs and performance of a nominal 25,000 scmd (883,000 scfd) photochemical plant to produce dihydrogen from water were studied. Two systems were considered, one based on flat-plate collector/reactors and the other on linear parabolic troughs. Engineering subsystems were specified including the collector/reactor, support hardware, field transport piping, gas compression equipment, and balance-of-plant (BOP) items. Overall plant efficiencies of 10.3 and 11.6% are estimated for the flat-plate and trough systems, respectively, based on assumed solar photochemical efficiencies of 12.9 and 14.6%. Because of the opposing effects of concentration ratio and operating temperature on efficiency, it was concluded that reactor cooling would be necessary with the trough system. Both active and passive cooling methods were considered. Capital costs and energy costs, for both concentrating and non-concentrating systems, were determined and their sensitivity to efficiency and economic parameters were analyzed. The overall plant efficiency is the single most important factor in determining the cost of the fuel
Evaluation of bistable systems versus matched filters in detecting bipolar pulse signals
This paper presents a thorough evaluation of a bistable system versus a
matched filter in detecting bipolar pulse signals. The detectability of the
bistable system can be optimized by adding noise, i.e. the stochastic resonance
(SR) phenomenon. This SR effect is also demonstrated by approximate statistical
detection theory of the bistable system and corresponding numerical
simulations. Furthermore, the performance comparison results between the
bistable system and the matched filter show that (a) the bistable system is
more robust than the matched filter in detecting signals with disturbed pulse
rates, and (b) the bistable system approaches the performance of the matched
filter in detecting unknown arrival times of received signals, with an
especially better computational efficiency. These significant results verify
the potential applicability of the bistable system in signal detection field.Comment: 15 pages, 9 figures, MikTex v2.
Near Infrared Spectroscopy of Young Brown Dwarfs in Upper Scorpius
Spectroscopic follow-up is a pre-requisite for studies of the formation and
early evolution of brown dwarfs. Here we present IRTF/SpeX near-infrared
spectroscopy of 30 candidate members of the young Upper Scorpius association,
selected from our previous survey work. All 24 high confidence members are
confirmed as young very low mass objects with spectral types from M5 to L1,
15-20 of them are likely brown dwarfs. This high yield confirms that brown
dwarfs in Upper Scorpius can be identified from photometry and proper motions
alone, with negligible contamination from field objects (<4%). Out of the 6
candidates with lower confidence, 5 might still be young very low mass members
of Upper Scorpius, according to our spectroscopy. We demonstrate that some very
low mass class II objects exhibit radically different near infrared (0.6 -
2.5micron) spectra from class III objects, with strong excess emission
increasing towards longer wavelengths and partially filled in features at
wavelengths shorter than 1.25micron. These characteristics can obscure the
contribution of the photosphere within such spectra. Therefore, we caution that
near infrared derived spectral types for objects with discs may be unreliable.
Furthermore, we show that the same characteristics can be seen to some extent
in all class II and even a significant fraction of class III objects (~40%),
indicating that some of them are still surrounded by traces of dust and gas.
Based on our spectra, we select a sample of objects with spectral types of M5
to L1, whose near-infrared emission represents the photosphere only. We
recommend the use of these objects as spectroscopic templates for young brown
dwarfs in the future.Comment: 12 pages, 9 figures, Accepted in MNRA
The creep of thorium near room temperature
The rate of plastic deformation of thorium has been investigated as a function of stress and strain at temperatures from 0 to 60°C. The rate of creep or plastic deformation was found to depend on the instantaneous values of the stress, strain and temperature and thus could be expressed by a mechanical equation of state. The yield point phenomenon was observed even at the lowest plastic strain rates. A critical stress was found below which no plastic deformation was observed
First Steps Toward Change in Teacher Preparation for Elementary Science
Unless introductory undergraduate science classes for prospective elementary teachers actively incorporate the philosophy of inquiry-based learning called for in K-l2 science education refom little will change in elementary science education. Thus, at James Madison University, we have developed a new integrated science core curriculum called Understanding our World [1]. This course sequence was not only designed to fulfill general education science requirements. but also to focus on content areas our students will need to know as teachers. The objectives of these courses are based on the National Science Education Standards and Virginia’s Science Standards of Learning, including earth and space science, chemistry, physics, life sciences, and environmental science [2,3]. As an integrated package, this course sequence addresses basic science content, calculation skills, the philosophy and history of science, the process of how science is done, the role of science in society, and applications of computers and technology in science. Keeping in mind that students tend to teach in the same way they were taught, Understanding our World core classes embrace the concepts associated with reform in elementary math and science
- …