Structure change of the insulating composite

Modern power electric drives brought advantages in induction motor control. In the same time appeared problems with high frequency square waveform voltage (pulse stress) produced by the voltage converters. Voltage converters produce repetitive pulses with high level of voltage rise fronts (slew rates). Rise fronts attained values of up to tens kilovolts per microsecond and voltage pulse repetition frequency up to some tens of kilohertz. This technology is an advantage for a drive control. Significant is the impact of these voltage waveforms on the motor insulations. Degradation of the main wall insulation can reduce the reliability of the electric motor and whole drive. In this paper is discussed one possible solution. The promising modification in the insulation material structure is presented in the paper

New developments in onshore paleoseismic methods, and their impact on Quaternary tectonic studies

Since the publication of Paleoseismology (2nd Edition) in 2009, there has been no comprehensive survey of new trends in Quaternary tectonics. This paper seeks to remedy that situation, by describing the new technologies and interpretations that arose over the past decade. The major technological advances have been in remote sending, e.g., unpiloted aerial vehicles (drones); airborne laser scanning (lidar); terrestrial laser scanning; 3D topographic surveys from Structure-from-Motion; and satellite geodesy such as D-InSAR. Advances have also been made in dating Quaternary deposits, including single-grain luminescence dating (in the laboratory), and portable optically-stimulated luminescence dating (in the field). Geophysical surveys are now a common component of neotectonic investigations, permitting a more formal, 3D integration of subsurface data with surface data. These techniques have lowered the threshold of recognition to smaller and smaller earthquakes, and allowed detection of off-fault deformation such as distributed faulting and folding. We are now collecting so much data that quality control of coseismic field measurements has become an issue, especially when assembling data sets made of old and new data. Soon this data problem will force a reassessment of our time-honored interpretive paradigms, most of which originated in the 1970s and 80s in the early days of neotectonics

Acceleration of late pleistocene activity of a central European fault driven by ice loading

We studied the southern part of the NW-SE trending Sudetic Marginal fault (SMF), situated at the northeastern limit of the Bohemian Massif in central Europe, to assess its Quaternary activity. Eighteen trenches and thirty-four electric resistivity profiles were performed at Bílá Voda to study the fault zone and 3-dimensional distribution of a beheaded alluvial fan on the NE side of the fault. We interpret a small drainage, located about 29–45 m to the SE of the fan apex, as the only plausible source channel implying a similar amount of left-lateral offset. The alluvial fan deposits’ radiometric ages range between about 24 and 63 ka, but postglacial deposits younger than 11 ka are not displaced, indicating that all motion occurred in the late Pleistocene. The site lies ∼150 km south of the late Pleistocene Weichselian maximum (∼20 ka) ice sheet front. We model the effects of the ice load on lithospheric flexure and resolved fault stresses, and show that slip on the SMF was promoted by the presence of the ice sheet, resulting in a late Pleistocene slip rate of ∼1.1+2.3/−0.6 mm/yr. As the most favorable time for glacial loading-induced slip would be during the glacial maximum between about 24 and 12 ka, it is doubtful that the slip rate remained constant during the entire period of activity, and if most slip occurred during this period, the short-term rate may have been even higher. Considering that the modern maximum principal stress (σ1) is oriented nearly parallel to the Sudetic Marginal fault (NNW-SSE) and is thus unfavorable for fault motion, our observations suggest that the likelihood of continued motion and earthquake production is much lower in the absence of an ice sheet