1,319 research outputs found
Issues of Multicultural Supervision in the Korean Context
In a rapidly globalizing society like Korea, the traditional norms ofindividualism and collectivism cannot defie the cultural identities. There are many issues in this counseling and coaching center in Korea that need to be resolved. The article tells of some of the ways this center has been successful in Korea
Indentations on Air Plasma Sprayed Thermal Barrier Coatings Prepared by Different Starting Granules
The effect of starting granules on the indentation properties of air plasma sprayed thermal barrier coatings (TBCs) is investigated in this paper. Various kinds of spray-dried granules are prepared from different processing conditions, especially varying solvent and dispersant, showing a deformed hollow-typed and a filled spherical-typed granule. The similar coating thicknesses are prepared by adjusting process parameters during air plasma spray. All XRD peaks in phase analysis are tetragonal and cubic phases without any monoclinic phase after the starting granules were heat-treated. A relatively porous microstructure of the coating layer could be obtained from the monodisperse granules, while a relatively dense microstructure resulted from the hollow-typed granules. The morphology and distribution of the granules crucially affect the microstructure of thermal barrier coatings and thus have influences on indentation properties such as indentation stress-strain curves, contact damage, and hardness. The implication concerning microstructure design of TBCs for gas turbine applications is considered
Optimal set of grid size and angular increment for practical dose calculation using the dynamic conformal arc technique: a systematic evaluation of the dosimetric effects in lung stereotactic body radiation therapy
Purpose To recommend the optimal plan parameter set of grid size and angular increment for dose calculations in treatment planning for lung stereotactic body radiation therapy (SBRT) using dynamic conformal arc therapy (DCAT) considering both accuracy and computational efficiency.
Materials and methods Dose variations with varying grid sizes (2, 3, and 4 mm) and angular increments (2°, 4°, 6°, and 10°) were analyzed in a thorax phantom for 3 spherical target volumes and in 9 patient cases. A 2-mm grid size and 2° angular increment are assumed sufficient to serve as reference values. The dosimetric effect was evaluated using doseâvolume histograms, monitor units (MUs), and dose to organs at risk (OARs) for a definite volume corresponding to the doseâvolume constraint in lung SBRT. The times required for dose calculations using each parameter set were compared for clinical practicality.
Results Larger grid sizes caused a dose increase to the structures and required higher MUs to achieve the target coverage. The discrete beam arrangements at each angular increment led to over- and under-estimated OARs doses due to the undulating dose distribution. When a 2° angular increment was used in both studies, a 4-mm grid size changed the dose variation by up to 3â4% (50 cGy) for the heart and the spinal cord, while a 3-mm grid size produced a dose difference of \u3c1% (12 cGy) in all tested OARs. When a 3-mm grid size was employed, angular increments of 6° and 10° caused maximum dose variations of 3% (23 cGy) and 10% (61 cGy) in the spinal cord, respectively, while a 4° increment resulted in a dose difference of \u3c1% (8 cGy) in all cases except for that of one patient. The 3-mm grid size and 4° angular increment enabled a 78% savings in computation time without making any critical sacrifices to dose accuracy.
Conclusions A parameter set with a 3-mm grid size and a 4° angular increment is found to be appropriate for predicting patient dose distributions with a dose difference below 1% while reducing the computation time by more than half for lung SBRT using DCAT
Digital Workflow for Retrofitting a Surveyed Crown Using a Removable Partial Denture as an Antagonist
Digital workflow expedites the procedure of retrofitting a surveyed crown against an existing removable partial denture (RPD). This article describes a simple and straightforward technique of digital workflow where an existing RPD is scanned as an antagonist to design the rest seat, guide plane, and height of contour of a surveyed crown.Peer Reviewedhttp://deepblue.lib.umich.edu/bitstream/2027.42/156192/2/jopr13187_am.pdfhttp://deepblue.lib.umich.edu/bitstream/2027.42/156192/1/jopr13187.pd
Effects of Textural Properties on the Response of a SnO2-Based Gas Sensor for the Detection of Chemical Warfare Agents
The sensing behavior of SnO2-based thick film gas sensors in a flow system in the presence of a very low concentration (ppb level) of chemical agent simulants such as acetonitrile, dipropylene glycol methyl ether (DPGME), dimethyl methylphosphonate (DMMP), and dichloromethane (DCM) was investigated. Commercial SnO2 [SnO2(C)] and nano-SnO2 prepared by the precipitation method [SnO2(P)] were used to prepare the SnO2 sensor in this study. In the case of DCM and acetonitrile, the SnO2(P) sensor showed higher sensor response as compared with the SnO2(C) sensors. In the case of DMMP and DPGME, however, the SnO2(C) sensor showed higher responses than those of the SnO2(P) sensors. In particular, the response of the SnO2(P) sensor increased as the calcination temperature increased from 400 °C to 800 °C. These results can be explained by the fact that the response of the SnO2-based gas sensor depends on the textural properties of tin oxide and the molecular size of the chemical agent simulant in the detection of the simulant gases (0.1â0.5 ppm)
The limited immunomodulatory effects of escharectomy on the kinetics of endotoxin, cytokines, and adhesion molecules in major burns.
Escharectomy has been shown to improve the survival rates and the outcomes in burns. This observational study was conducted to assess the role of escharectomy on the inflammatory mediators in major burns. Seventeen ASA physical status II or status III adult surviving major burn patients were recruited. When the escharectomy was scheduled, a series of blood samples was obtained at -3 and -1 days preoperation, and +1 and +3 postoperation. The changing levels of endotoxin, cytokines, and adhesion molecules were measured with a quantitative sandwich immunoassay. Extensive escharectomy did not appear to have any significant impact on the levels of tumor necrosis factor alpha, interleukin-10, soluble intracellular adhesion molecule-1 and soluble vascular adhesion molecule-1. Meanwhile, endotoxin and E-selectin were significantly decreased after escharectomy. Escharectomy appeared to have a limited immunomodulatory effect on the inflammatory mediators in systemic inflammatory responses induced by major burns. This is probably related to the timing and extent of surgery, and the complex nature of burn-related inflammation
Donor-site closure using absorbable dermal staple for deep inferior epigastric artery perforator flaps: its efficacy and cosmetic outcomes
Effect of software version and parameter settings on the marginal and internal adaptation of crowns fabricated with the CAD/CAM system
Objective This study investigated the marginal and internal adaptation of individual dental crowns fabricated using a CAD/CAM system (Sironaâs BlueCam), also evaluating the effect of the software version used, and the specific parameter settings in the adaptation of crowns.Material and Methods Forty digital impressions of a master model previously prepared were acquired using an intraoral scanner and divided into four groups based on the software version and on the spacer settings used. The versions 3.8 and 4.2 of the software were used, and the spacer parameter was set at either 40 ÎŒm or 80 ÎŒm. The marginal and internal fit of the crowns were measured using the replica technique, which uses a low viscosity silicone material that simulates the thickness of the cement layer. The data were analyzed using a Friedman two-way analysis of variance (ANOVA) and paired t-tests with significance level set at
Infantile Vitreous Hemorrhage as the Initial Presentation of X-linked Juvenile Retinoschisis
The authors report two cases of X-linked juvenile retinoschisis (XLRS) manifested as bilateral vitreous hemorrhage as early as in an 1-month-old infant and in a 3-month-old infant. The one-month-old male infant showed massive bilateral vitreous hemorrhage. During vitrectomy, thin membrane representing an inner part of schisis cavity was excised and intraschisis hemorrhage was evacuated. As intraschisis cavities were cleared, the stump of inner layer appeared as the demarcation line between the outer layer of the schisis retina and non-schisis retina. The other three-month-old male infant presenting with esodeviation also showed bilateral vitreous hemorrhage. Typical bilateral retinoschisis involving maculae could be seen through vitreous hemorrhage in both eyes on fundus examination. Spontaneous absorption of hemorrhage was observed on regular follow-up. XLRS could be manifested as massive hemorrhage inside or outside of the schisis cavity early in infancy
- âŠ