5,388 research outputs found
On the 2-categories of weak distributive laws
A weak mixed distributive law (also called weak entwining structure) in a
2-category consists of a monad and a comonad, together with a 2-cell relating
them in a way which generalizes a mixed distributive law due to Beck. We show
that a weak mixed distributive law can be described as a compatible pair of a
monad and a comonad, in 2-categories extending, respectively, the 2-category of
comonads and the 2-category of monads. Based on this observation, we define a
2-category whose 0-cells are weak mixed distributive laws. In a 2-category K
which admits Eilenberg-Moore constructions both for monads and comonads, and in
which idempotent 2-cells split, we construct a fully faithful 2-functor from
this 2-category of weak mixed distributive laws to K^{2 x 2}.Comment: 15 pages LaTeX source, final version to appear in Comm. Algebr
Design and analysis of a control system for an optical delay-line circuit used as reconfigurable gain equalizer
The design and analysis of a control system for a coherent two-port lattice-form optical delay-line circuit used as reconfigurable gain equalizer is presented. The design of the control system, which is based on a real device model and a least-square optimization method, is described in detail. Analysis on a five-stage device for the 32 possible solutions of phase parameters showed that, for some filter characteristics, the variations in power dissipation can vary up to a factor of 2. Furthermore, the solution selection has influence on the optimization result and number of iterations needed. A sensitivity analysis of the phase parameters showed that the allowable error in the phase parameters should not exceed a standard deviation of /spl pi//500 in order to achieve a total maximal absolute accuracy error not greater than approximately 0.6 dB. A five-stage device has been fabricated using planar lightwave circuit technology that uses the thermooptic effect. Excellent agreement between simulations and measurements has been achieved
X-ray polarimetry with an active-matrix pixel proportional counter
We report the first results from an X-ray polarimeter with a micropattern gas
proportional counter using an amorphous silicon active matrix readout. With
100% polarized X-rays at 4.5 keV, we obtain a modulation factor of 0.33 +/-
0.03, confirming previous reports of the high polarization sensitivity of a
finely segmented pixel proportional counter. The detector described here has a
geometry suitable for the focal plane of an astronomical X-ray telescope.
Amorphous silicon readout technology will enable additional extensions and
improvements.Comment: 4 pages, 4 figures, 1 tabl
Recombination in polymer-fullerene bulk heterojunction solar cells
Recombination of photogenerated charge carriers in polymer bulk
heterojunction (BHJ) solar cells reduces the short circuit current (Jsc) and
the fill factor (FF). Identifying the mechanism of recombination is, therefore,
fundamentally important for increasing the power conversion efficiency. Light
intensity and temperature dependent current-voltage measurements on polymer BHJ
cells made from a variety of different semiconducting polymers and fullerenes
show that the recombination kinetics are voltage dependent and evolve from
first order recombination at short circuit to bimolecular recombination at open
circuit as a result of increasing the voltage-dependent charge carrier density
in the cell. The "missing 0.3V" inferred from comparison of the band gaps of
the bulk heterojunction materials and the measured open circuit voltage at room
temperature results from the temperature dependence of the quasi-Fermi-levels
in the polymer and fullerene domains - a conclusion based upon the fundamental
statistics of Fermions.Comment: Accepted for publication in Physical Review B.
http://prb.aps.org/accepted/B/6b07cO3aHe71bd1b149e1425e58bf2868cda2384d?ajax=1&height=500&width=50
Intrinsic hole mobility and trapping in a regio-regular poly(thiophene)
The transport properties of high-performance thin-film transistors (TFT) made
with a regio-regular poly(thiophene) semiconductor (PQT-12) are reported. The
room-temperature field-effect mobility of the devices varied between 0.004
cm2/V s and 0.1 cm2/V s and was controlled through thermal processing of the
material, which modified the structural order. The transport properties of TFTs
were studied as a function of temperature. The field-effect mobility is
thermally activated in all films at T<200 K and the activation energy depends
on the charge density in the channel. The experimental data is compared to
theoretical models for transport, and we argue that a model based on the
existence of a mobility edge and an exponential distribution of traps provides
the best interpretation of the data. The differences in room-temperature
mobility are attributed to different widths of the shallow localized state
distribution at the edge of the valence band due to structural disorder in the
film. The free carrier mobility of the mobile states in the ordered regions of
the film is the same in all structural modifications and is estimated to be
between 1 and 4 cm2/V s.Comment: 20 pages, 8 figure
Construction and Measurements of an Improved Vacuum-Swing-Adsorption Radon-Mitigation System
In order to reduce backgrounds from radon-daughter plate-out onto detector
surfaces, an ultra-low-radon cleanroom is being commissioned at the South
Dakota School of Mines and Technology. An improved vacuum-swing-adsorption
radon mitigation system and cleanroom build upon a previous design implemented
at Syracuse University that achieved radon levels of
0.2Bqm. This improved system will employ a better pump and
larger carbon beds feeding a redesigned cleanroom with an internal HVAC unit
and aged water for humidification. With the rebuilt (original) radon mitigation
system, the new low-radon cleanroom has already achieved a 300
reduction from an input activity of Bqm to a
cleanroom activity of Bqm.Comment: 5 pages, 4 figures, Proceedings of Low Radioactivity Techniques (LRT)
2015, Seattle, WA, March 18-20, 201
Experimentally Constrained Molecular Relaxation: The case of hydrogenated amorphous silicon
We have extended our experimentally constrained molecular relaxation
technique (P. Biswas {\it et al}, Phys. Rev. B {\bf 71} 54204 (2005)) to
hydrogenated amorphous silicon: a 540-atom model with 7.4 % hydrogen and a
611-atom model with 22 % hydrogen were constructed. Starting from a random
configuration, using physically relevant constraints, {\it ab initio}
interactions and the experimental static structure factor, we construct
realistic models of hydrogenated amorphous silicon. Our models confirm the
presence of a high frequency localized band in the vibrational density of
states due to Si-H vibration that has been observed in a recent vibrational
transient grating measurements on plasma enhanced chemical vapor deposited
films of hydrogenated amorphous silicon.Comment: 13 pages, 4 figure
Spectrum of Sizes for Perfect Deletion-Correcting Codes
One peculiarity with deletion-correcting codes is that perfect
-deletion-correcting codes of the same length over the same alphabet can
have different numbers of codewords, because the balls of radius with
respect to the Levenshte\u{\i}n distance may be of different sizes. There is
interest, therefore, in determining all possible sizes of a perfect
-deletion-correcting code, given the length and the alphabet size~.
In this paper, we determine completely the spectrum of possible sizes for
perfect -ary 1-deletion-correcting codes of length three for all , and
perfect -ary 2-deletion-correcting codes of length four for almost all ,
leaving only a small finite number of cases in doubt.Comment: 23 page
Application of a dynamic subgrid-scale model to turbulent recirculating flows
The dynamic subgrid-scale model of Germano et al. is implemented in a finite volume formulation and applied to the simulation of turbulent flow in a three-dimensional lid-driven cavity at Reynolds number of 7500. The filtering operation is carried out in physical space, and the model coefficient is calculated locally. The computed mean and rms velocities as well as the Reynolds stress are compared with experimental data. It is shown that backscatter from small to large scales is necessary to sustain turbulent fluctuations. The model is being applied to the simulation of turbulent flows in a stratified and rotating environment in complex geometries
- …