172 research outputs found

    DIAGNOSTIC POSSIBILITIES OF ELECTROROENTGENOGRAPHY IN POSTPHLEBITIC SYNDROME

    Get PDF
    No abstrac

    Measurement of crack opening stresses and crack closure stress profiles from heat generation in vibrating cracks

    Get PDF
    A method is described to measure crack opening stresses and closure stress profiles of a surface-breaking crack. Vibration is used to generate frictional heat by rubbing crack face asperities. Heat is generated at regions of contacting crack asperities under low, but nonzero, closure stress. Increasing force is applied to incrementally open the crack and measure the locations of crack heating as a function of applied load. Surface crack closure stresses are approximated from the heating locations as the load is varied and the crack opening stress is measured from the load required to fully open the crack and terminate heat generatio

    CeOx/Al2O3 thin films on stainless steel substrate - Dynamical X-ray photoelectron spectroscopy investigations

    Get PDF
    Cataloged from PDF version of article.The CeOx/Al2O3 thin films on stainless steel with different ceria loading were subjected to a. c. ( square wave) pulses at various frequencies in the range 10(-3) to 100 kHz while recording X-ray photoelectron spectra. The resulting binding energy differences were derived from the frequency dependence of the corresponding Al2p, Ce3d and O1s peaks. At low ceria loadings the main constituent on the surface is CeAlO3 phase, while for high ceria loading the film is constructed from CeO2 and CeAlO3 phases spread over the Al2O3. Accordingly, it was observed that the ceria loading determines the conductivities of the investigated thin oxide films. (C) 2013 Elsevier B.V. All rights reserved

    Power dependent switching of nonlinear trapping by local photonic potentials

    Full text link
    We study experimentally and numerically the nonlinear scattering of wave packets by local multi-site guiding centers embedded in a continuous dielectric medium, as a function of the input power and angle of incidence. The extent of trapping into the linear modes of different sites is manipulated as a function of both the input power and incidence angle, demonstrating power-controlled switching of nonlinear trapping by local photonic potentials.Comment: Submitted to Optics Letter

    Cavity ring-down spectroscopy for molecular trace gas detection using a pulsed DFB QCL emitting at 6.8 \u3bcm

    Get PDF
    A trace gas sensor based on pulsed cavity ring-down spectroscopy (CRDS) was developed for measurement of the \u3bd4 fundamental vibrational band of ammonia (NH3) centered at 1468.898 cm-1. A pulsed distributed feedback quantum cascade laser (DFB-QCL) operating at 6.8 \u3bcm (1470.58 cm-1) quite well covered the absorption band of the ammonia and strong fundamental vibrational absorption bands of different molecular gases in this unexplored region. The cavity was partially evacuated down to 0.4 Atm by a turbo-molecular pump to reduce the partial interference between the NH3 spectra and water near the absorption peak of ammonia. A sensitivity of nine parts per billion was reached for a measurement time of 120 s as well as an optical path length of 226 m. The device demonstrated high spectral performance and versatility due to its wide tuning range, narrow linewidth, and comparatively high-energy mid-IR radiation in the relatively unexplored 6.8 \u3bcm region, which is very important for high-resolution spectroscopy of a variety of gases

    CeOx/Al2O3 thin films on stainless steel substrate - Dynamical X-ray photoelectron spectroscopy investigations

    Get PDF
    The CeOx/Al2O3 thin films on stainless steel with different ceria loading were subjected to a.c. (square wave) pulses at various frequencies in the range 10- 3 to 100 kHz while recording X-ray photoelectron spectra. The resulting binding energy differences were derived from the frequency dependence of the corresponding Al2p, Ce3d and O1s peaks. At low ceria loadings the main constituent on the surface is CeAlO 3 phase, while for high ceria loading the film is constructed from CeO2 and CeAlO3 phases spread over the Al 2O3. Accordingly, it was observed that the ceria loading determines the conductivities of the investigated thin oxide films. © 2013 Elsevier B.V. All Rights Reserved

    Intensity distribution for waves in disordered media: deviations from Rayleigh statistics

    Full text link
    We study the intensity distribution function, P(I), for monochromatic waves propagating in quasi one-dimensional disordered medium, assuming that a point source and a point detector are embedded in the bulk of the medium. We find deviations from the Rayleigh statistics at moderately large I and a logarithmically-normal asymptotic behavior of P(I). When the radiation source and the detector are located close to the opposite edges of the sample (on a distance much less then the sample length), an intermediate regime with a stretched-exponential behavior of P(I) emerges.Comment: 4 pages Revtex, 3 figures included as eps file
    corecore