9 research outputs found
Book Reviews
Critical Thinking and Intelligence Analysis. By David T.Moore. At The Center Of The Storm: The CIA During America's Time of Crisis. By George Tenet with Bill Harlow. Female Suicide Bombers. By Rosemarie Skaine. Information Operations: Doctrine and Practice. By Christopher Paul. The Secret Sentry: The Untold History of the National Security Agency. By Matthew M. Aid. The Blood of Lambs: A Former Terrorist's Memoir of Death and Redemption. By Kamal Saleem with Lynn Vincent. Attaché Extraordinaire: Vernon A. Walters in Brazil. By Frank Márcio De Oliveira
Recommended from our members
Validation data for models of contaminant dispersal : scaling laws and data needs.
Contaminant dispersal models for use at scales ranging from meters to miles are widely used for planning sensor locations, first-responder actions for release scenarios, etc. and are constantly being improved. Applications range from urban contaminant dispersal to locating buried targets from an exhaust signature. However, these models need detailed data for model improvement and validation. A small Sandia National Laboratories Laboratory Directed Research and Development (LDRD) program was funded in FY04 to examine the feasibility and usefulness of a scale-model capability for quantitative characterization of flow and contaminant dispersal in complex environments. This report summarizes the work performed in that LDRD. The basics of atmospheric dispersion and dispersion modeling are reviewed. We examine the need for model scale data, and the capability of existing model test methods. Currently, both full-scale and model scale experiments are performed in order to collect validation data for numerical models. Full-scale experiments are expensive, are difficult to repeat, and usually produce relatively sparse data fields. Model scale tests often employ wind tunnels, and the data collected is, in many cases, derived from single point measurements. We review the scaling assumptions and methods that are used to relate model and full scale flows. In particular, we examine how liquid flows may be used to examine the process of atmospheric dispersion. The scaling between liquid and gas flows is presented. Use of liquid as the test fluid has some advantages in terms of achieving fully turbulent Reynolds numbers and in seeding the flow with neutrally buoyant tracer particles. In general, using a liquid flow instead of a gas flow somewhat simplifies the use of full field diagnostics, such as Particle Image Velocimetry and Laser Induced Fluorescence. It is also possible to create stratified flows through mixtures of fluids (e.g., water, alcohol, and brine). Lastly, we describe our plan to create a small prototype water flume for the modeling of stratified atmospheric flows around complex objects. The incoming velocity profile could be tailored to produce a realistic atmospheric boundary layer for flow-in-urban-canyon measurements. The water tunnel would allow control of stratification to produce, for example, stable and unstable atmospheric conditions. Models ranging from a few buildings to cityscapes would be used as the test section. Existing noninvasive diagnostics would be applied, including particle image velocimetry for detailed full-field velocity measurement, and laser induced fluorescence for noninvasive concentration measurement. This scale-model facility will also be used as a test-bed for data acquisition and model testing related to the inverse problem, i.e., determination of source location from distributed, sparse measurement locations. In these experiments the velocity field would again be measured and data from single or multiple concentration monitors would be used to locate the continuous or transient source
Recommended from our members
Flow Mapping in a Gas-Solid Riser via Computer Automated Radioactive Particle Tracking (CARPT)
Statement of the Problem: Developing and disseminating a general and experimentally validated model for turbulent multiphase fluid dynamics suitable for engineering design purposes in industrial scale applications of riser reactors and pneumatic conveying, require collecting reliable data on solids trajectories, velocities ? averaged and instantaneous, solids holdup distribution and solids fluxes in the riser as a function of operating conditions. Such data are currently not available on the same system. Multiphase Fluid Dynamics Research Consortium (MFDRC) was established to address these issues on a chosen example of circulating fluidized bed (CFB) reactor, which is widely used in petroleum and chemical industry including coal combustion. This project addresses the problem of lacking reliable data to advance CFB technology. Project Objectives: The objective of this project is to advance the understanding of the solids flow pattern and mixing in a well-developed flow region of a gas-solid riser, operated at different gas flow rates and solids loading using the state-of-the-art non-intrusive measurements. This work creates an insight and reliable database for local solids fluid-dynamic quantities in a pilot-plant scale CFB, which can then be used to validate/develop phenomenological models for the riser. This study also attempts to provide benchmark data for validation of Computational Fluid Dynamic (CFD) codes and their current closures. Technical Approach: Non-Invasive Computer Automated Radioactive Particle Tracking (CARPT) technique provides complete Eulerian solids flow field (time average velocity map and various turbulence parameters such as the Reynolds stresses, turbulent kinetic energy, and eddy diffusivities). It also gives directly the Lagrangian information of solids flow and yields the true solids residence time distribution (RTD). Another radiation based technique, Computed Tomography (CT) yields detailed time averaged local holdup profiles at various planes. Together, these two techniques can provide the needed local solids flow dynamic information for the same setup under identical operating conditions, and the data obtained can be used as a benchmark for development, and refinement of the appropriate riser models. For the above reasons these two techniques were implemented in this study on a fully developed section of the riser. To derive the global mixing information in the riser, accurate solids RTD is needed and was obtained by monitoring the entry and exit of a single radioactive tracer. Other global parameters such as Cycle Time Distribution (CTD), overall solids holdup in the riser, solids recycle percentage at the bottom section of the riser were evaluated from different solids travel time distributions. Besides, to measure accurately and in-situ the overall solids mass flux, a novel method was applied
Recommended from our members
Quantitative tomographic measurements of opaque multiphase flows
An electrical-impedance tomography (EIT) system has been developed for quantitative measurements of radial phase distribution profiles in two-phase and three-phase vertical column flows. The EIT system is described along with the computer algorithm used for reconstructing phase volume fraction profiles. EIT measurements were validated by comparison with a gamma-densitometry tomography (GDT) system. The EIT system was used to accurately measure average solid volume fractions up to 0.05 in solid-liquid flows, and radial gas volume fraction profiles in gas-liquid flows with gas volume fractions up to 0.15. In both flows, average phase volume fractions and radial volume fraction profiles from GDT and EIT were in good agreement. A minor modification to the formula used to relate conductivity data to phase volume fractions was found to improve agreement between the methods. GDT and EIT were then applied together to simultaneously measure the solid, liquid, and gas radial distributions within several vertical three-phase flows. For average solid volume fractions up to 0.30, the gas distribution for each gas flow rate was approximately independent of the amount of solids in the column. Measurements made with this EIT system demonstrate that EIT may be used successfully for noninvasive, quantitative measurements of dispersed multiphase flows
Recommended from our members
A Gas-Solid Riser Experiment for Fundamental Studies of Turbulent Multiphase Flow
Recommended from our members
Circulating fluidized bed hydrodynamics experiments for the multiphase fluid dynamics research consortium (MFDRC).
An experimental program was conducted to study the multiphase gas-solid flow in a pilot-scale circulating fluidized bed (CFB). This report describes the CFB experimental facility assembled for this program, the diagnostics developed and/or applied to make measurements in the riser section of the CFB, and the data acquired for several different flow conditions. Primary data acquired included pressures around the flow loop and solids loadings at selected locations in the riser. Tomographic techniques using gamma radiation and electrical capacitance were used to determine radial profiles of solids volume fraction in the riser, and axial profiles of the integrated solids volume fraction were produced. Computer Aided Radioactive Particle Tracking was used to measure solids velocities, fluxes, and residence time distributions. In addition, a series of computational fluid dynamics simulations was performed using the commercial code Arenaflow{trademark}
Epidemiology, management and outcomes of Cryptococcus gattii infections: A 22-year cohort.
BackgroundCryptococcus gattii is a globally endemic pathogen causing disease in apparently immune-competent hosts. We describe a 22-year cohort study from Australia's Northern Territory to evaluate trends in epidemiology and management, and outcome predictors.MethodsA retrospective cohort study of all C. gattii infections at the northern Australian referral hospital 1996-2018 was conducted. Cases were defined as confirmed (culture-positive) or probable. Demographic, clinical and outcome data were extracted from medical records.Results45 individuals with C. gattii infection were included: 44 Aboriginal Australians; 35 with confirmed infection; none HIV positive out of 38 tested. Multifocal disease (pulmonary and central nervous system) occurred in 20/45 (44%). Nine people (20%) died within 12 months of diagnosis, five attributed directly to C. gattii. Significant residual disability was evident in 4/36 (11%) survivors. Predictors of mortality included: treatment before the year 2002 (4/11 versus 1/34); interruption to induction therapy (2/8 versus 3/37) and end-stage kidney disease (2/5 versus 3/40). Prolonged antifungal therapy was the standard approach in this cohort, with median treatment duration being 425 days (IQR 166-715). Ten individuals had adjunctive lung resection surgery for large pulmonary cryptococcomas (median diameter 6cm [range 2.2-10cm], versus 2.8cm [1.2-9cm] in those managed non-operatively). One died post-operatively, and 7 had thoracic surgical complications, but ultimately 9/10 (90%) treated surgically were cured compared with 10/15 (67%) who did not have lung surgery. Four patients were diagnosed with immune reconstitution inflammatory syndrome which was associated with age 1:512.ConclusionC. gattii infection remains a challenging condition but treatment outcomes have significantly improved over 2 decades, with eradication of infection the norm. Adjunctive surgery for the management of bulky pulmonary C. gattii infection appears to increase the likelihood of durable cure and likely reduces the required duration of antifungal therapy