1,078 research outputs found
Wind velocity probing device and method Patent
Free-fall body for obtaining wind velocity profiles by radar trackin
Prediction of pilot-aircraft stability boundaries and performance contours
Control-theoretic pilot models can provide important new insights regarding the stability and performance characteristics of the pilot-aircraft system. Optimal-control pilot models can be formed for a wide range of flight conditions, suggesting that the human pilot can maintain stability if he adapts his control strategy to the aircraft's changing dynamics. Of particular concern is the effect of sub-optimal pilot adaptation as an aircraft transitions from low to high angle-of-attack during rapid maneuvering, as the changes in aircraft stability and control response can be extreme. This paper examines the effects of optimal and sub-optimal effort during a typical 'high-g' maneuver, and it introduces the concept of minimum-control effort (MCE) adaptation. Limited experimental results tend to support the MCE adaptation concept
Stability and control of maneuvering high-performance aircraft
The stability and control of a high-performance aircraft was analyzed, and a design methodology for a departure prevention stability augmentation system (DPSAS) was developed. A general linear aircraft model was derived which includes maneuvering flight effects and trim calculation procedures for investigating highly dynamic trajectories. The stability and control analysis systematically explored the effects of flight condition and angular motion, as well as the stability of typical air combat trajectories. The effects of configuration variation also were examined
Longitudinal flying qualities criteria for single-pilot instrument flight operations
Modern estimation and control theory, flight testing, and statistical analysis were used to deduce flying qualities criteria for General Aviation Single Pilot Instrument Flight Rule (SPIFR) operations. The principal concern is that unsatisfactory aircraft dynamic response combined with high navigation/communication workload can produce problems of safety and efficiency. To alleviate these problems. The relative importance of these factors must be determined. This objective was achieved by flying SPIFR tasks with different aircraft dynamic configurations and assessing the effects of such variations under these conditions. The experimental results yielded quantitative indicators of pilot's performance and workload, and for each of them, multivariate regression was applied to evaluate several candidate flying qualities criteria
Technical notes and correspondence: Stochastic robustness of linear time-invariant control systems
A simple numerical procedure for estimating the stochastic robustness of a linear time-invariant system is described. Monte Carlo evaluations of the system's eigenvalues allows the probability of instability and the related stochastic root locus to be estimated. This analysis approach treats not only Gaussian parameter uncertainties but non-Gaussian cases, including uncertain-but-bounded variation. Confidence intervals for the scalar probability of instability address computational issues inherent in Monte Carlo simulation. Trivial extensions of the procedure admit consideration of alternate discriminants; thus, the probabilities that stipulated degrees of instability will be exceeded or that closed-loop roots will leave desirable regions can also be estimated. Results are particularly amenable to graphical presentation
The design of digital-adaptive controllers for VTOL aircraft
Design procedures for VTOL automatic control systems have been developed and are presented. Using linear-optimal estimation and control techniques as a starting point, digital-adaptive control laws have been designed for the VALT Research Aircraft, a tandem-rotor helicopter which is equipped for fully automatic flight in terminal area operations. These control laws are designed to interface with velocity-command and attitude-command guidance logic, which could be used in short-haul VTOL operations. Developments reported here include new algorithms for designing non-zero-set-point digital regulators, design procedures for rate-limited systems, and algorithms for dynamic control trim setting
Modern digital flight control system design for VTOL aircraft
Methods for and results from the design and evaluation of a digital flight control system (DFCS) for a CH-47B helicopter are presented. The DFCS employed proportional-integral control logic to provide rapid, precise response to automatic or manual guidance commands while following conventional or spiral-descent approach paths. It contained altitude- and velocity-command modes, and it adapted to varying flight conditions through gain scheduling. Extensive use was made of linear systems analysis techniques. The DFCS was designed, using linear-optimal estimation and control theory, and the effects of gain scheduling are assessed by examination of closed-loop eigenvalues and time responses
High angle-of-attack stability-and-control analysis
Methods of linear systems analysis were applied to mathematical models of aircraft flying at high angle of attack and maneuver rate. First order longitudinal and lateral directional coupling is obtained by linearizing the complete nonlinear equations of motion about a generalized (quasi steady) trim point. Open loop stability boundaries are defined using the linear dynamic equations, and pilot in the loop effects are presented. Stability augmentation structures for maneuvering flight conditions are shown to be defined readily using optimal control theory
Ab-initio theory of metal-insulator interfaces in a finite electric field
We present a novel technique for calculating the dielectric response of
metal/insulator heterostructures. This scheme allows, for the first time, the
fully first-principles calculation of the microscopic properties of thin-film
capacitors at finite bias potential. The method can be readily applied to pure
insulators, where it provides an interesting alternative to conventional
finite-field techniques based on the Berry-phase formalism. We demonstrate the
effectiveness of our method by performing comprehensive numerical tests on a
model Ag/MgO/Ag heterostructure.Comment: 10 pages, 5 figures, major revisio
Path integrals and symmetry breaking for optimal control theory
This paper considers linear-quadratic control of a non-linear dynamical
system subject to arbitrary cost. I show that for this class of stochastic
control problems the non-linear Hamilton-Jacobi-Bellman equation can be
transformed into a linear equation. The transformation is similar to the
transformation used to relate the classical Hamilton-Jacobi equation to the
Schr\"odinger equation. As a result of the linearity, the usual backward
computation can be replaced by a forward diffusion process, that can be
computed by stochastic integration or by the evaluation of a path integral. It
is shown, how in the deterministic limit the PMP formalism is recovered. The
significance of the path integral approach is that it forms the basis for a
number of efficient computational methods, such as MC sampling, the Laplace
approximation and the variational approximation. We show the effectiveness of
the first two methods in number of examples. Examples are given that show the
qualitative difference between stochastic and deterministic control and the
occurrence of symmetry breaking as a function of the noise.Comment: 21 pages, 6 figures, submitted to JSTA
- …