Wie viel Arbeit macht die Aufzucht von Ökologischen Junghennen? Arbeitwirtschaftlicher Vergleich der konventionellen und ökologischen Aufzucht von Legehennen

Organic pullets are reared with daylight and are not beak-trimmed. Therefore, certain provisions are needed in order to prevent feather-pecking and cannibalism. Respec-tive guidelines are set by the German Organic Associations. It was the goal of this study to investigate whether the higher rearing standards are associated with an increased labour demand compared to conventional rearing systems. Using a ques-tionnaire, data from 32 hen-houses (10 conventional and 6 organic barn systems, 10 conventional and 6 organic aviary systems) about duration and number of working procedures were collected and exemplary models calculated. Total labour demand was between 2.36 and 7.37 worker`s hours/100 pullets. It did not differ between or-ganic and conventional rearing when comparing similar flock sizes, but were partly differently allocated to the different working procedures. On average, organic farms had smaller flocks, and there was a large influence of flock size on labour demand with small houses requiring most labour per hen. Also aviaries were more labour demanding than barn systems, but were usually associated with higher flock sizes. Our results indicate that improved pullet rearing that allows the birds to perform their natural behaviour more completely, does not necessarily cause higher labour re-quirements

Junghennen - Arbeitszeitvergleich praxisüblicher Haltungsverfahren

Dieses KTBL-Heft informiert über den Arbeitszeitbedarf in der Junghennenhaltung. In Abhängigkeit vom Haltungssverfahren, der Bestandgröße und der Vermarktungsform für konventionell und ökologisch wirtschaftenden Betriebe wurden Arbeitszeitwerte in der Praxis erfasst und daraus auf der Basis von Modellrechnungen Arbeitszeitbedarfswerte abgeleitet. Die ermittelten Arbeitszeitbedarfswerte liefern Junghennenhaltern für Neu- und Umbaumaßnahmen Vergleichswerte und ermöglichen ihnen eine fundierte PLanung ihrer Arbeitskapazitäten

Electron-wall interaction in Hall thrusters

Electron-wall interaction effects in Hall thrusters are studied through measurements of the plasma response to variations of the thruster channel width and the discharge voltage. The discharge voltage threshold is shown to separate two thruster regimes. Below this threshold, the electron energy gain is constant in the acceleration region and therefore, secondary electron emission (SEE) from the channel walls is insufficient to enhance electron energy losses at the channel walls. Above this voltage threshold, the maximum electron temperature saturates. This result seemingly agrees with predictions of the temperature saturation, which recent Hall thruster models explain as a transition to space-charge saturated regime of the near-wall sheath. However, in the experiment, the maximum saturation temperature exceeds by almost three times the critical value estimated under the assumption of a Maxwellian electron energy distribution function. The channel narrowing, which should also enhance electron-wall collisions, causes unexpectedly larger changes of the plasma potential distribution than does the increase of the electron temperature with the discharge voltage. An enhanced anomalous crossed-field mobility (near wall or Bohm-type) is suggested by a hydrodynamic model as an explanation to the reduced electric field measured inside a narrow channel. We found, however, no experimental evidence of a coupling between the maximum electron temperature and the location of the accelerating voltage drop, which might have been expected due to the SEE-induced near-wall conductivity.Peer Reviewedhttp://deepblue.lib.umich.edu/bitstream/2027.42/87763/2/057104_1.pd

Triangulation network of 1929-1944 of the first 1:500 urban map of València

[EN] Triangulation is a surveying method on which earlier maps made were based. Although the origins of the method can be traced back to the 16th century, it is still used today, with minor changes, to adjust networks observed with modern geodetic techniques. In this paper we present the geodetic survey work that was carried out for the primary triangulation network of the first 1:500 urban map of the city of València (Spain). It spanned from 1929 to 1944 and resulted in 421 maps covering about 174 square kilometres. We focus on four key elements to define the geometric framework of a map: (1) the geodetic network, (2) the cartographic projection, (3) the baseline measurements, and (4) the primary triangulation. The paper is based on the interpretation of original documents and field books recovered from the archives of the València City Council. In order to check the accuracy and consistency of the survey work, we recomputed all calculations directly from the field data, following the mathematical procedures of the time. We obtained a set of transformation parameters to convert the coordinates of 1929 to current coordinates based on the European Terrestrial Reference System of 1989 (ETRS89). Results showed that the 1929 primary triangulation angles and coordinates are accurate to 8 s of arc and 35 cm respectively, and that the coordinates transform well into the current reference system with average residuals of 26 cm across nine control points, demonstrating the high quality of the 1929 work.Villar-Cano, M.; Marqués-Mateu, Á.; Jiménez-Martínez, MJ. (2020). Triangulation network of 1929-1944 of the first 1:500 urban map of València. Survey Review (Online). 52(373):317-329. https://doi.org/10.1080/00396265.2018.1564599S31732952373Bitelli, G., Cremonini, S., & Gatta, G. (2014). Cartographic heritage: Toward unconventional methods for quantitative analysis of pre-geodetic maps. Journal of Cultural Heritage, 15(2), 183-195. doi:10.1016/j.culher.2013.04.003Blachut, T. J., Chrzanowski, A., & Saastamoinen, J. H. (1979). Urban Surveying and Mapping. doi:10.1007/978-1-4612-6145-2Brinker, R. C., & Minnick, R. (Eds.). (1987). The Surveying Handbook. doi:10.1007/978-1-4757-1188-2Gatta, G. 2010. Valorizzazione di cartografia storica attraverso moderne tecniche geomatiche: recupero metrico, elaborazione e consultazione in ambiente digitale [Valuation of historic cartography using modern geomatics techniques: metric recovering, making and use in digital environment]. Doctoral thesis. Bologna: Universitá di Bologna. 295 pages. (In Italian).Gorse, C., Johnston, D., & Pritchard, M. (2012). A Dictionary of Construction, Surveying and Civil Engineering. doi:10.1093/acref/9780199534463.001.0001Hotine, M. (1939). THE RE-TRIANGULATION OF GREAT BRITAIN IV—BASE MEASUREMENT. Empire Survey Review, 5(34), 211-225. doi:10.1179/sre.1939.5.34.211Kahmen, H., & Faig, W. (1988). Surveying. doi:10.1515/9783110845716Leick, A., Rapoport, L., & Tatarnikov, D. (2015). GPS Satellite Surveying. doi:10.1002/9781119018612Murdin, P. (2009). Full Meridian of Glory. doi:10.1007/978-0-387-75534-2Schofield, W., & Breach, M. (2007). Engineering Surveying. doi:10.1201/b12847Seeber, G. (2003). Satellite Geodesy. doi:10.1515/9783110200089Snyder, J. P. (1987). Map projections: A working manual. Professional Paper. doi:10.3133/pp139

Space charge saturated sheath regime and electron temperature saturation in Hall thrusters

Secondary electron emission in Hall thrusters is predicted to lead to space charge saturated wall sheaths resulting in enhanced power losses in the thruster channel. Analysis of experimentally obtained electron-wall collision frequency suggests that the electron temperature saturation, which occurs at high discharge voltages, appears to be caused by a decrease of the Joule heating rather than by the enhancement of the electron energy loss at the walls due to a strong secondary electron emission

Insights on impact from the development, delivery and evaluation of the CLEAR IDEAS innovation training model

The increasing pressure on organisations to innovate more effectively in what they deliver and how they work means there is a distinct need for interventions that enhance the innovation capabilities of employees. This paper therefore describes insights from the development, delivery and impact evaluation of a research-based innovation training model (CLEAR IDEAS) designed to improve both the idea generation and idea implementation competencies of trainees. How key findings from the creativity and innovation literature were turned into a practical model and its operationalisation in practice are first discussed. This is followed by presenting a longitudinal evaluation of the training intervention with 151 public sector leaders. Findings showed that the model was well received, led to significant improvements in innovation competencies and resulted in certain trainees undertaking a range of actions to introduce innovations back in the workplace while others failed to apply their learning. Longer-term data provided several examples of subsequent notable ultimate impacts on organisations’ functioning and public service delivery. Finally, reflections on key training, trainee, task and work environment facilitators and inhibitors of innovation training impact are offered

Glucosinolates, myrosinase hydrolysis products, and flavonols found in rocket (Eruca sativa and Diplotaxis tenuifolia)

Rocket species have been shown to have very high concentrations of glucosinolates and flavonols, which have numerous positive health benefits with regular consumption. In this review we highlight how breeders and processors of rocket species can utilize genomic and phytochemical research to improve varieties and enhance the nutritive benefits to consumers. Plant breeders are increasingly looking to new technologies such as HPLC, UPLC, LC-MS and GC-MS to screen populations for their phytochemical content to inform plant selections. Here we collate the research that has been conducted to-date in rocket, and summarise all glucosinolate and flavonol compounds identified in the species. We emphasize the importance of the broad screening of populations for phytochemicals and myrosinase degradation products, as well as unique traits that may be found in underutilized gene bank resources. We also stress that collaboration with industrial partners is becoming essential for long-term plant breeding goals through research

High-performance liquid chromatography–tandem mass spectrometry in the identification and determination of phase I and phase II drug metabolites

Applications of tandem mass spectrometry (MS/MS) techniques coupled with high-performance liquid chromatography (HPLC) in the identification and determination of phase I and phase II drug metabolites are reviewed with an emphasis on recent papers published predominantly within the last 6 years (2002–2007) reporting the employment of atmospheric pressure ionization techniques as the most promising approach for a sensitive detection, positive identification and quantitation of metabolites in complex biological matrices. This review is devoted to in vitro and in vivo drug biotransformation in humans and animals. The first step preceding an HPLC-MS bioanalysis consists in the choice of suitable sample preparation procedures (biomatrix sampling, homogenization, internal standard addition, deproteination, centrifugation, extraction). The subsequent step is the right optimization of chromatographic conditions providing the required separation selectivity, analysis time and also good compatibility with the MS detection. This is usually not accessible without the employment of the parent drug and synthesized or isolated chemical standards of expected phase I and sometimes also phase II metabolites. The incorporation of additional detectors (photodiode-array UV, fluorescence, polarimetric and others) between the HPLC and MS instruments can result in valuable analytical information supplementing MS results. The relation among the structural changes caused by metabolic reactions and corresponding shifts in the retention behavior in reversed-phase systems is discussed as supporting information for identification of the metabolite. The first and basic step in the interpretation of mass spectra is always the molecular weight (MW) determination based on the presence of protonated molecules [M+H]+ and sometimes adducts with ammonium or alkali-metal ions, observed in the positive-ion full-scan mass spectra. The MW determination can be confirmed by the [M-H]- ion for metabolites providing a signal in negative-ion mass spectra. MS/MS is a worthy tool for further structural characterization because of the occurrence of characteristic fragment ions, either MSn analysis for studying the fragmentation patterns using trap-based analyzers or high mass accuracy measurements for elemental composition determination using time of flight based or Fourier transform mass analyzers. The correlation between typical functional groups found in phase I and phase II drug metabolites and corresponding neutral losses is generalized and illustrated for selected examples. The choice of a suitable ionization technique and polarity mode in relation to the metabolite structure is discussed as well