21 research outputs found

    Hydroxyapatite/Silver Nanoparticles Powders as Antimicrobial Agent for Bone Replacements

    Get PDF
    This paper reports a superficial morphological modification of the hydroxyapatite grains obtained by in situ deposition of Ag nanoparticles on natural origin calcium phosphate powder. Ceramic material was prepared in three stage bone treatment, including hydrolysis with a lactic acid, pre-calcination, and proper calcination. Subsequently, the Ag nanoparticles were synthesized by chemical reduction of Ag+ by sodium borohydride in a solution of polyvinylpyrrolidone and in presence of hydroxyapatite. Such-prepared materials were investigated with X-ray diffraction, Fourier-transformed infrared spectroscopy, atomic absorption spectrometry and scanning electron microscopy with energy dispersive spectroscopy. Furthermore, Ca/P molar ratio was calculated and microbiological tests were performed to investigate materials antimicrobial activity. The appearance of Ag nanoparticles located on phosphate surface was confirmed by SEM analysis, and no chemical bonding with hydroxyapatite was recorded by IR and XRD techniques. Additionally, the biological assessment revealed bactericidal effect on Escherichia coli and Staphylococcus aureus, while slightly affected on Enterococcus faecalis viability. This work is licensed under a Creative Commons Attribution 4.0 International License

    Propolis – beekeeping medicinal product

    Get PDF
    The paper presents the healing properties and biological activity of propolis, commonly known as bee glue. Propolis is a natural product collected by bees from buds of plants and bark of trees, then moistened with bee enzymes. Propolis is widely used for general treatment, skin affections, and as an anti-inflammatory agent for ulcers and hard-to-heal wounds. Propolis, due to its properties, is called an antibiotic of the 21st century

    Synthesis and characterization of polymer-based coatings modified with bioactive ceramic and bovine serum albumin

    Get PDF
    This study involves the synthesis of hydroxyapatite and describes the preparation and characterization of polymer coatings based on poly(ethylene glycol) diacrylate and poly(ethylene glycol) and modified with bovine serum albumin and hydroxyapatite. Hydroxyapatite was obtained by wet chemical synthesis and characterized by X-ray diffraction and FTIR spectroscopy, and its Ca/P molar ratio was determined (1.69 ± 0.08). The ceramic and bovine serum albumin were used in the preparation of composite materials with the polymeric matrix. The chemical composition of coatings was characterized with FTIR spectroscopy, and their morphology was recorded with SEM imaging. Moreover, the measurements of surface roughness parameters and stereometric research were performed. The prepared coatings were subjected to in vitro studies in simulated body fluid and artificial saliva. Changes in chemical composition and morphology after immersion were examined with FTIR spectroscopy and SEM imaging. Based on the conducted research, it can be stated that applied modifiers promote the biomineralization process. The roughness analysis confirmed prepared materials were characterized by the micrometer-scale topography. The materials morphology and roughness, and the morphology of the newly formed apatite deposit, were dependent on the type of the used modifier, and the artificial fluid used in in vitro studies

    Composites Based on Hydroxyapatite and Whey Protein Isolate for Applications in Bone Regeneration

    Get PDF
    The “Multifunctional biologically active composites for applications in bone regenerative medicine” project is carried out within the TEAM-NET program of the Foundation for Polish Science financed by the European Union under the European Regional Development Fund. The authors gratefully acknowledge the financial support. T.E.L.D. thanks N8 Agrifood for its financial support in the framework of the pump priming grant “Food2Bone”.Hydroxyapatite (HAp) is a bioactive ceramic with great potential for the regeneration of the skeletal system. However, its mechanical properties, especially its brittleness, limit its application. Therefore, in order to increase its ability to transmit stresses, it can be combined with a polymer phase, which increases its strength without eliminating the important aspect of bioactivity. The presented work focuses on obtaining organic–inorganic hydrogel materials based on whey protein isolate (WPI) reinforced with nano-HAp powder. The proportion of the ceramic phase was in the range of 0–15%. Firstly, a physicochemical analysis of the materials was performed using XRD, FT-IR and SEM. The hydrogel composites were subjected to swelling capacity measurements, potentiometric and conductivity analysis, and in vitro tests in four liquids: distilled water, Ringer’s fluid, artificial saliva, and simulated body fluid (SBF). The incubation results demonstrated the successful formation of new layers of apatite as a result of the interaction with the fluids. Additionally, the influence of the materials on the metabolic activity according to ISO 10993-5:2009 was evaluated by identifying direct contact cytotoxicity towards L-929 mouse fibroblasts, which served as a reference. Moreover, the stimulation of monocytes by hydrogels via the induction of nuclear factor (NF)-κB was investigated. The WPI/HAp composite hydrogels presented in this study therefore show great potential for use as novel bone substitutes

    Studies on sintering process of synthetic hydroxyapatite

    No full text
    In this study the effect of sintering process in different temperatures on microstructure and morphological properties of sintered hydroxyapatite (HAp) was investigated. HAp powder was prepared by wet precipitation method from following reagents: Ca(OH)2 + H3PO4 in an alkaline conditions. Thermal analysis (TA), X-Ray diffraction method (XRD), FT-IR spectrometry (FT-IR) and scanning electron microscopy (SEM) were used to elaborate the phase composition and properties of sintered HAp samples and raw HAp powder as well. The total and apparent density and total porosity of sintered compacts, shrinkage and weight loss during the sintering were also measured. The results show that there is a difference in sintering behavior of synthetic hydroxyapatites depending on sintering temperature. The main differences refer to the loss of mass, shrinkage, changes in porosity and density of the investigated materials

    SILVER NANOPARTICLES SYNTHESIS WITH DIFFERENT CONCENTRATIONS OF POLYVINYLPYRROLIDONE

    No full text
    The effect of poly(N-vinylpyrrolidone) (PVP) concentration on the synthesis and properties of silver nanoparticles (AgNPs) was investigated. Nanoparticles have been prepared by a chemical reduction method from the aqueous solution of silver nitrate and PVP as a stabilizing agent in the presence of sodium borohydride as a reducing agent. The nanosized silver colloids have been characterized using scanning electron microscopy (SEM), energy dispersive X-ray spectroscopy (EDS), UV-Vis spectroscopy and transformed infrared spectroscopy (FT-IR). Dynamic Light Scattering (DLS) measurements using Zetasizer Nano ZS were applied to size estimation of AgNPs. The results confirmed that silver nanoparticles were formed in each sample independently of PVP content, however the stabilizer concentration in range of 1.0 % to 10.0 % leads to the synthesis of AgNPs with a size in the narrow range of nano-scale and small amounts of larger clusters. The PVP content had a significant influence on silver nanoparticles morphology and optical properties

    Investigations on the Influence of Collagen Type on Physicochemical Properties of PVP/PVA Composites Enriched with Hydroxyapatite Developed for Biomedical Applications

    No full text
    Nowadays, a great attention is directed into development of innovative multifunctional composites which may support bone tissue regeneration. This may be achieved by combining collagen and hydroxyapatite showing bioactivity, osteoconductivity and osteoinductivity with such biocompatible polymers as polyvinylpyrrolidone (PVP) and poly(vinyl alcohol) (PVA). Here PVA/PVP-based composites modified with hydroxyapatite (HAp, 10 wt.%) and collagen (30 wt.%) were obtained via UV radiation while two types of collagen were used (fish and bovine) and crosslinking agents differing in the average molecular weight. Next, their chemical structure was characterized using Fourier transform infrared (FT-IR) spectroscopy, roughness of their surfaces was determined using a stylus contact profilometer while their wettability was evaluated by a sessile drop method followed by the measurements of their surface free energy. Subsequently, swelling properties of composites were verified in simulated physiological liquids as well as the behavior of composites in these liquids by pH measurements. It was proved that collagen-modified composites showed higher swelling ability (even 25% more) compared to unmodified ones, surface roughness, biocompatibility towards simulated physiological liquids and hydrophilicity (contact angles lower than 90°). Considering physicochemical properties of developed materials and a possibility of the preparation of their various shapes and sizes, it may be concluded that developed materials showed great application potential for biomedical use, e.g., as materials filling bone defects supporting their treatments and promoting bone tissue regeneration due to the presence of hydroxyapatite with osteoinductive and osteoconductive properties

    Review of the Applications of Biomedical Compositions Containing Hydroxyapatite and Collagen Modified by Bioactive Components

    No full text
    Regenerative medicine is becoming a rapidly evolving technique in today’s biomedical progress scenario. Scientists around the world suggest the use of naturally synthesized biomaterials to repair and heal damaged cells. Hydroxyapatite (HAp) has the potential to replace drugs in biomedical engineering and regenerative drugs. HAp is easily biodegradable, biocompatible, and correlated with macromolecules, which facilitates their incorporation into inorganic materials. This review article provides extensive knowledge on HAp and collagen-containing compositions modified with drugs, bioactive components, metals, and selected nanoparticles. Such compositions consisting of HAp and collagen modified with various additives are used in a variety of biomedical applications such as bone tissue engineering, vascular transplantation, cartilage, and other implantable biomedical devices

    Clindamycin-Loaded Nanosized Calcium Phosphates Powders as a Carrier of Active Substances

    No full text
    Bioactive calcium phosphate ceramics (CaPs) are one of the building components of the inorganic part of bones. Synthetic CaPs are frequently used as materials for filling bone defects in the form of pastes or composites; however, their porous structure allows modification with active substances and, thus, subsequent use as a drug carrier for the controlled release of active substances. In this study, four different ceramic powders were compared: commercial hydroxyapatite (HA), TCP, brushite, as well as HA obtained by wet precipitation methods. The ceramic powders were subjected to physicochemical analysis, including FTIR, XRD, and determination of Ca/P molar ratio or porosity. These techniques confirmed that the materials were phase-pure, and the molar ratios of calcium and phosphorus elements were in accordance with the literature. This confirmed the validity of the selected synthesis methods. CaPs were then modified with the antibiotic clindamycin. Drug release was determined on HPLC, and antimicrobial properties were tested against Staphylococcus aureus. The specific surface area of the ceramic has been demonstrated to be a factor in drug release efficiency
    corecore