Carbon Dioxide Sequestering Using Microalgal Systems

This project evaluated key design criteria, the technical feasibility, and the preliminary economic viability of a CO{sub 2}-sequestering system integrated with a coal-fired power plant based on microalgae biofixation. A review of relevant literature was conducted, and a bench-scale algal-based sequestration system was constructed and operated to verify algal growth capabilities using a simulated flue gas stream. The bench-scale system was a 20-gallon glass aquarium with a 16-gallon operating volume and was direct-sparged with a simulated flue gas. The flue gas composition was based on flue gas analyses for a 550-MW Coal Creek Power Station boiler in Underwood, North Dakota, which averaged 12.1% CO{sub 2}, 5.5% O{sub 2}, 423 ppm SO{sub 2}, 124 ppm NO{sub x}, and an estimated 50 mg/m{sup 3} fly ash loading. The algae were grown in Bold's basal growth medium. Lighting was provided using a two-tube fluorescent ''grow-light'' bulb fixture mounted directly above the tank. Algal growth appeared to be inhibited in the presence of SO{sub 2} using mixed cultures of green and blue-green cultures of algae. Samples of Monoraphidium strain MONOR02 and Nannochloropsis NANNO02 algal samples were obtained from the University of Hawaii Culture Collection. These samples did not exhibit inhibited growth in the presence of all the simulated flue gas constituents, but growth rates were somewhat lower than those expected, based on the review of literature. Samples of harvested algae were analyzed for protein, lipid, and carbohydrate content. A lipid content of 26% appeared to be fairly normal for algae, and it did not appear that large amounts of nitrogen were being fixed and promoting growth, nor were the algae starved for nitrogen. Proteins made up 41% of the total mass, and carbohydrates were assumed to be 33% (by difference). A preliminary economic analysis showed the costs of an integrated system based on microalgae biofixation to sequester 25% of the CO{sub 2} from a 550-MW coal-fired power plant could be recovered if the value recovered from the harvested algae was approximately $97. The analysis indicated the potential to produce 2427 tpd of algae at 12% moisture (2136 tpd dry weight). Of this, approximately 876 tpd of protein could be recovered and used as an animal feed. Similarly, an estimated 555 tpd of lipids could be recovered for use in the production of liquid fuels and chemicals. Approximately 705 tpd of carbohydrates would also be recovered. These carbohydrates may be suitable as a fermentation feedstock for the production of alcohols or organic acids

EERC Center for Biomass Utilization 2006

The Center for Biomass Utilization (CBUî) 2006 project at the Energy & Environmental Research Center (EERC) consisted of three tasks related to applied fundamental research focused on converting biomass feedstocks to energy, liquid transportation fuels, and chemicals. Task 1, entitled Thermochemical Conversion of Biomass to Syngas and Chemical Feedstocks, involved three activities. Task 2, entitled Crop Oil Biorefinery Process Development, involved four activities. Task 3, entitled Management, Education, and Outreach, focused on overall project management and providing educational outreach related to biomass technologies through workshops and conferences

RECOVERY OF LACTIC ACID FROM AMERICAN CRYSTAL SUGAR COMPANY WASTEWATER

This project has shown that the recovery of several valuable lactic acid products is both technically feasible and economically viable. One of the original objectives of this project was to recover lactic acid. However, the presence of a variety of indigenous bacteria in the wastewater stream and technical issues related to recovery and purification have resulted in the production of lactic acid esters. These esters could by hydrolyzed to lactic acid, but only with unacceptable product losses that would be economically prohibitive. The developed process is projected to produce approximately 200,000 lb per day of lactate esters from wastewater at a single factory at costs that compete with conventional solvents. The lactate esters are good solvents for polymers and resins and could replace acetone, methyl ethyl ketone, MIBK, and other polar solvents used in the polymer industry. Because of their low volatility and viscosity-lowering properties, they will be especially useful for inks for jet printers, alkyl resins, and high-solid paints. Owing to their efficiency in dissolving salts and flux as well as oils and sealants, lactate esters can be used in cleaning circuit boards and machine and engine parts. Unlike conventional solvents, lactate esters exhibit low toxicity, are biodegradable, and are not hazardous air pollutants. Another application for lactate esters is in the production of plasticizers. Severe health problems have been attributed to widely used phthalate ester plasticizers. The U.S. Department of Agriculture showed that replacement of these with inexpensive lactate esters is feasible, owing to their superior polymer compatibility properties. A very large market is projected for polymers prepared from lactic acid. These are called polylactides and are a type of polyester. Thermoplastics of this type have a variety of uses, including moldings, fibers, films, and packaging of both manufactured goods and food products. Polylactides form tough, orientable, self-supporting thin films and have, therefore, been used for adhesives, safety glass, and finishes. If the bacterial culture produces the L-lactic acid enanatiomer form exclusively, the L-lactide prepared from this form can be used for making polymers with good fiber-forming properties. We have not currently achieved the exclusive production of L-lactate in our efforts. However, markets in films and structural shapes are available for polymers and copolymers prepared from the mixed D,L-lactide forms that result from processing the D,L-lactic acid obtained from fermentation such as that occurring naturally in sugar beet wastewater. These materials are slowly biodegraded to harmless compounds in the environment, and they burn with a clean blue flame when incinerated. These materials represent excellent opportunities for utilization of the D,L-lactic mixture produced from natural fermentation of the ACS flume water. Esters can be converted into a lactide, and the alcohol released from the ester can be recycled with no net consumption of the alcohol. Lactide intermediates could be produced locally and shipped to polymer producers elsewhere. The polymer and copolymer markets are extremely large, and the role of lactides in these markets is continuously expanding. The overall process can be readily integrated into existing factory wastewater operations. There are several environmental benefits that would be realized at the factories with incorporation of the lactate recovery process. The process reduces the organic loading to the existing wastewater treatment system that should result in enhanced operability with respect to both solids handling and treated-water quality. A higher-quality treated water will also help reduce odor levels from holding ponds. Several water reuse opportunities are probable, depending on the quality of treated water from the FT process

The Weakening Position of University Graduates in Singapore's Labor Market: Causes and Consequences

Pulled along by global developments, Singapore is rapidly developing a "knowledge-based economy." Between 1990 and 2000, gross domestic product more than doubled (in constant dollars), and the number of managerial and professional jobs almost doubled. Such advances should be a boon to middle-class Singaporeans, but, instead, they find themselves under increasing economic pressure despite the increased need for educated labor and the surplus of manual labor. On the basis of analysis of available data, the article documents the deteriorating relative position of the well-educated in the labor market and explores the role of migration in that process. Copyright 2005 The Population Council, Inc..