1,685 research outputs found
Engine isolation for structural-borne interior noise reduction in a general aviation aircraft
Engine vibration isolation for structural-borne interior noise reduction is investigated. A laboratory based test procedure to simulate engine induced structure-borne noise transmission, the testing of a range of candidate isolators for relative performance data, and the development of an analytical model of the transmission phenomena for isolator design evaluation are addressed. The isolator relative performance test data show that the elastomeric isolators do not appear to operate as single degree of freedom systems with respect to noise isolation. Noise isolation beyond 150 Hz levels off and begins to decrease somewhat above 600 Hz. Coupled analytical and empirical models were used to study the structure-borne noise transmission phenomena. Correlation of predicted results with measured data show that (1) the modeling procedures are reasonably accurate for isolator design evaluation, (2) the frequency dependent properties of the isolators must be included in the model if reasonably accurate noise prediction beyond 150 Hz is desired. The experimental and analytical studies were carried out in the frequency range from 10 Hz to 1000 Hz
Design and test of aircraft engine isolators for reduced interior noise
Improved engine vibration isolation was proposed to be the most weight and cost efficient retrofit structure-borne noise control measure for single engine general aviation aircraft. A study was carried out the objectives: (1) to develop an engine isolator design specification for reduced interior noise transmission, (2) select/design candidate isolators to meet a 15 dB noise reduction design goal, and (3) carry out a proof of concept evaluation test. Analytical model of the engine, vibration isolators and engine mount structure were coupled to an empirical model of the fuselage for noise transmission evaluation. The model was used to develop engine isolator dynamic properties design specification for reduced noise transmission. Candidate isolators ere chosen from available product literature and retrofit to a test aircraft. A laboratory based test procedure was then developed to simulate engine induced noise transmission in the aircraft for a proof of concept evaluation test. Three candidate isolator configurations were evaluated for reduced structure-borne noise transmission relative to the original equipment isolators
Visual, Motor and Attentional Influences on Proprioceptive Contributions to Perception of Hand Path Rectilinearity during Reaching
We examined how proprioceptive contributions to perception of hand path straightness are influenced by visual, motor and attentional sources of performance variability during horizontal planar reaching. Subjects held the handle of a robot that constrained goal-directed movements of the hand to the paths of controlled curvature. Subjects attempted to detect the presence of hand path curvature during both active (subject driven) and passive (robot driven) movements that either required active muscle force production or not. Subjects were less able to discriminate curved from straight paths when actively reaching for a target versus when the robot moved their hand through the same curved paths. This effect was especially evident during robot-driven movements requiring concurrent activation of lengthening but not shortening muscles. Subjects were less likely to report curvature and were more variable in reporting when movements appeared straight in a novel “visual channel” condition previously shown to block adaptive updating of motor commands in response to deviations from a straight-line hand path. Similarly, compromised performance was obtained when subjects simultaneously performed a distracting secondary task (key pressing with the contralateral hand). The effects compounded when these last two treatments were combined. It is concluded that environmental, intrinsic and attentional factors all impact the ability to detect deviations from a rectilinear hand path during goal-directed movement by decreasing proprioceptive contributions to limb state estimation. In contrast, response variability increased only in experimental conditions thought to impose additional attentional demands on the observer. Implications of these results for perception and other sensorimotor behaviors are discussed
Elastic, Viscous, and Mass Load Effects on Poststroke Muscle Recruitment and Co-contraction During Reaching: A Pilot Study
Background: Resistive exercise after stroke can improve strength (force-generating capacity) without increasing spasticity (velocity-dependent hypertonicity). However, the effect of resistive load type on muscle activation and co-contraction after stroke is not clear. Objective: The purpose of this study was to determine the effect of load type (elastic, viscous, or mass) on muscle activation and co-contraction during resisted forward reaching in the paretic and nonparetic arms after stroke. Design: This investigation was a single-session, mixed repeated-measures pilot study. Methods: Twenty participants (10 with hemiplegia and 10 without neurologic involvement) reached forward with each arm against equivalent elastic, viscous, and mass loads. Normalized shoulder and elbow electromyography impulses were analyzed to determine agonist muscle recruitment and agonist-antagonist muscle co-contraction. Results: Muscle activation and co-contraction levels were significantly higher on virtually all outcome measures for the paretic and nonparetic arms of the participants with stroke than for the matched control participants. Only the nonparetic shoulder responded to load type with similar activation levels but variable co-contraction responses relative to those of the control shoulder. Elastic and viscous loads were associated with strong activation; mass and viscous loads were associated with minimal co-contraction. Limitations: A reasonable, but limited, range of loads was available. Conclusions: Motor control deficits were evident in both the paretic and the nonparetic arms after stroke when forward reaching was resisted with viscous, elastic, or mass loads. The paretic arm responded with higher muscle activation and co-contraction levels across all load conditions than the matched control arm. Smaller increases in muscle activation and co-contraction levels that varied with load type were observed in the nonparetic arm. On the basis of the response of the nonparetic arm, this study provides preliminary evidence suggesting that viscous loads elicited strong muscle activation with minimal co-contraction. Further intervention studies are needed to determine whether viscous loads are preferable for poststroke resistive exercise programs
A Pneumatically Actuated Manipulandum for Neuromotor Control Research
Functional magnetic resonance imaging (fMRI) techniques have great potential for identifying which neural structures are involved in the control of goal-directed reaching movements. However, fMRI techniques alone are not capable of probing the neural mechanisms involved in acquisition of novel motor behaviors because such studies require that the moving limb be perturbed in a controlled fashion. We outline a plan to design and develop a non-metallic, pneumatically actuated tool that, along with systems identification techniques and functional magnetic resonance imaging (fMRI), will characterize and quantify how the human central nervous system uses sensory information during practice-based motor learning
Design and Validation of a MR-compatible Pneumatic Manipulandum
The combination of functional MR imaging and novel robotic tools may provide unique opportunities to probe the neural systems underlying motor control and learning. Here, we describe the design and validation of a MR-compatible, 1 degree-of-freedom pneumatic manipulandum along with experiments demonstrating its safety and efficacy. We first validated the robot\u27s ability to apply computer-controlled loads about the wrist, demonstrating that it possesses sufficient bandwidth to simulate torsional spring-like loads during point-to-point flexion movements. Next, we verified the MR-compatibility of the device by imaging a head phantom during robot operation. We observed no systematic differences in two measures of MRI signal quality (signal/noise and field homogeneity) when the robot was introduced into the scanner environment. Likewise, measurements of joint angle and actuator pressure were not adversely affected by scanning. Finally, we verified device efficacy by scanning 20 healthy human subjects performing rapid wrist flexions against a wide range of spring-like loads. We observed a linear relationship between joint torque at peak movement extent and perturbation magnitude, thus demonstrating the robot\u27s ability to simulate spring-like loads in situ. fMRI revealed task-related activation in regions known to contribute to the control of movement including the left primary sensorimotor cortex and right cerebellum
Engine-induced structural-borne noise in a general aviation aircraft
Structural borne interior noise in a single engine general aviation aircraft was studied to determine the importance of engine induced structural borne noise and to determine the necessary modeling requirements for the prediction of structural borne interior noise. Engine attached/detached ground test data show that engine induced structural borne noise is a primary interior noise source for the single engine test aircraft, cabin noise is highly influenced by responses at the propeller tone, and cabin acoustic resonances can influence overall noise levels. Results from structural and acoustic finite element coupled models of the test aircraft show that wall flexibility has a strong influence on fundamental cabin acoustic resonances, the lightweight fuselage structure has a high modal density, and finite element analysis procedures are appropriate for the prediction of structural borne noise
Analysis of debris from APG-3, the simulated destruct system test of a full-scale Rover/NERVA reactor
Analysis of debris from simulated destruction system test of full scale Rover/NERVA reacto
Using Participatory Action Research to Explore The Financial Literacy Needs of those Nearing Retirement
The purpose of “Using Participatory Action Research to Explore the Financial Literacy Needs of those nearing Retirement” was to explore the financial literacy needs of persons age 50 or above. If individuals nearing retirement have a sense of not saving sufficiently to retire on their own timing or to support the lifestyle desired in retirement, what are elements of a financial literacy program (workshop or series of workshops) that might help them positively change their financial situations between now and retirement? The methodology used in this study was participatory action research. Critical theory was used to examine power relationships and how inequities in those relationships may result in individuals feeling powerless. Interviews yielded information which contributed to the development of a workshop. The workshop was seen as a good beginning in becoming financially literate related to retirement planning; people left the workshop enthusiastic about taking control of their retirement planning. A series of workshops is needed. More hands-on involvement is desired by participants; other learning styles need to be addressed as this workshop focused on accessing online resources. Participants commented that becoming more active in that relationship and more knowledgeable in the exchange of information would result in changes in how they interacted with financial professionals. With needed training and support, individuals can and will take a more active role in their relationships with financial professionals
Impairments in Sensorimotor Control During Pursuit and Compensatory Tracking in Individuals with Multiple Sclerosis
- …