20 research outputs found

    FastIC: a fast integrated circuit for the readout of high performance detectors

    Full text link
    This work presents the 8-channel FastIC ASIC developed in CMOS 65 nm technology suitable for the readout of positive and negative polarity sensors in high energy physics experiments, Cherenkov detectors and time-of-flight systems. The front-end can be configured to perform analog summation of up to 4 single-ended channels before discrimination in view of improving time resolution when segmenting a SiPM. The outputs encode the time-of-arrival information and linear energy measurement which captures the peak amplitude of the input signal in the 5 µA–25 mA input peak current range. Power consumption of the ASIC is 12 mW/ch with default settings. Measurements of single photon time resolution with a red-light laser source and a HPK SiPM S13360-3050CS are ≈140 ps FWHM

    20-ps resolution Clock Distribution Network for a fast-timing single photon detector

    Get PDF
    The time resolution of active pixel sensors whose timestamp mechanism is based on Time-to-Digital Converters is critically linked to the accuracy in the distribution of the master clock signal that latches the timestamp values across the detector. The Clock Distribution Network that delivers the master clock signal must compensate process-voltage-temperature variations to reduce static time errors (skew), and minimize the power supply bounce to prevent dynamic time errors (jitter). To achieve sub-100ps time resolution within pixel detectors and thus enable a step forward in multiple imaging applications, the network latencies must be adjusted in steps well below that value. Power consumption must be kept as low as possible. In this work, a self-regulated Clock Distribution Network that fulfills these requirements is presented for the FastICpix single photon detector ¿ aiming at a 65nm process. A 40 MHz master clock is distributed to 64x64 pixels over an area of 2.4x2.4 cm2 using digital Delay-Locked Loops, achieving clock leaf skew below 20 ps with a power consumption of 26 mW. Guidelines are provided to adapt the system to arbitrary chip area and pixel pitch values, yielding a versatile design with very fine time resolution

    HRFlexToT: A High Dynamic Range ASIC for Time-of-Flight Positron Emission Tomography

    Get PDF
    Abstract: Time-of-Flight positron emission tomography scanners demand fast and efficient photo sensors and scintillators coupled to fast readout electronics. This article presents the high resolution flexible Time-over-Threshold (HRFlexToT), a 16-channel application-specific-integrated circuit for silicon photomultipliers (SiPM) anode readout manufactured using XFAB 0.18- μm CMOS technology. The main features of the HRFlexToT are a linear Time-over-Threshold with an extended dynamic range (10 bits) for energy measurement, low power consumption (≈ 3.5 mW/ch), and an excellent timing response. The experimental measurements show an energy linearity error of ≈ 3% and an energy resolution of about 12% at 511 keV. Single-photon time resolution measurements performed using an Fondazione Bruno Kessler (FBK) SiPM NUV-HD ( 4×4 mm2 pixel, 40- μm cell) and a Hamamatsu SiPM S13360-3050CS are around 142 and 167 ps full width at half maximum (FWHM), respectively. Coincidence time resolution (CTR) measurements with small cross-section pixelated crystals (LSO:Ce,Ca 0.4%, 2×2×5 mm3) coupled to the same Hamamatsu S13360-3050CS and FBK NUV-HD sensors yield a CTR of 117 ps and 119 ps, respectively. Measurements performed with a large cross-section monolithic crystal (LFS crystal measuring 25×25×20 mm3) and a Hamamatsu SiPM array S13361-6050NE-04 show a CTR of 324 ps FWHM after time-walk and time-skew correction

    HRFlexToT: A High Dynamic Range ASIC for Time-of-Flight Positron Emission Tomography

    Get PDF
    Time-of-Flight positron emission tomography scanners demand fast and efficient photo sensors and scintillators coupled to fast readout electronics. This article presents the high resolution flexible Time-over-Threshold (HRFlexToT), a 16-channel application-specific-integrated circuit for silicon photomultipliers (SiPM) anode readout manufactured using XFAB 0.18- \mu \text{m} CMOS technology. The main features of the HRFlexToT are a linear Time-over-Threshold with an extended dynamic range (10 bits) for energy measurement, low power consumption (≈ 3.5 mW/ch), and an excellent timing response. The experimental measurements show an energy linearity error of ≈ 3% and an energy resolution of about 12% at 511 keV. Single-photon time resolution measurements performed using an Fondazione Bruno Kessler (FBK) SiPM NUV-HD ( 4 \times 4 mm2 pixel, 40- \mu \text{m} cell) and a Hamamatsu SiPM S13360-3050CS are around 142 and 167 ps full width at half maximum (FWHM), respectively. Coincidence time resolution (CTR) measurements with small cross-section pixelated crystals (LSO:Ce,Ca 0.4%, 2 \times 2 \times 5 mm3) coupled to the same Hamamatsu S13360-3050CS and FBK NUV-HD sensors yield a CTR of 117 ps and 119 ps, respectively. Measurements performed with a large cross-section monolithic crystal (LFS crystal measuring 25 \times 25 \times 20 mm3) and a Hamamatsu SiPM array S13361-6050NE-04 show a CTR of 324 ps FWHM after time-walk and time-skew correction

    A High Dynamic Range ASIC for Time of Flight PET with monolithic crystals

    Get PDF
    The HRFlexToT is a 16-channel ASIC for SiPM anode readout designed for Positron Emission Tomography (PET) applications that features high dynamic range (>8 bits), low input impedance, common cathode connection, high speed and low power (~3.5 mW/ch). The ASIC has been manufactured using XFAB 0.18 mm CMOS technology. The main characteristics of the HRFlexToT, compared to its predecessor, are a new energy measurement readout providing a linear Time Over Threshold (ToT) with an extended dynamic range, lower power consumption and better timing response. Initial measurements show a linearity error below 3%. Single Photon Time Resolution (SPTR) measurements performed using a Hamamatsu MPPC S13360-3050CS (3x3 mm2 pixel, 50 umm cell) shows 30% improvement with respect to the previous version of the ASIC, setting this specification in the order of 141 ps FWHM and reducing 3 times power consumption. It is important to highlight that an SPTR of 141 ps FWHM is, according to the best of our knowledge, the best resolution achieved so far for this sensor. Coincidence Time Resolution (CTR) measurements are expected to be performed during 2018

    Unusual spontaneous cold auto-hemagglutination phenomenon in blood units stored under blood bank condition: A retrospective analysis

    No full text
    Background: Cold agglutinins (CA) are benign naturally occurring low titer autoantibodies present in most individuals. Those with moderate strength are found in infections, malignancies or autoimmune conditions with diagnostic importance. Aim: Present report deals with CA that brought spontaneous hemagglutination in blood units stored at 2-6°C. Study design: Over 32 months period between July 1993 and December 1995, blood units were inspected for spontaneous cold auto-hemagglutination (SpCA) phenomenon. The plasma from these units was separated and investigated for serological specificity using in house red cell panel and standard serological methods. Results: Among 51,671 blood units, 112 units showed SpCA phenomenon. A rising trend seen in first half of study period significantly fell in remaining half. Specificities of the antibodies detected include anti-I (27), anti-i (53), anti-Pr (21) with remaining few being undetermined specificity. Absorption of serum using enzyme-treated red cells revealed a presence of anti-Pr among the cases, the two of which with new specificities that reacted preferentially with red cells from either new-born or adults and were tentatively named as anti-Pr Fetal and anti-Pr adult , respectively. While 9 cases showed optimum reaction at neutral pH of 7, 68 (62%) cases reacted at pH 5.8 through 8.0, 28 (26%) cases preferred an acidic pH 5.8 and 4 cases opted an alkaline pH 8. Of 28 cases with antibodies preferentially reacting in acidic medium, 17 (60%) cases were anti-i and 7 (25%) cases were anti-Pr. Conclusion: Unique SpCA phenomenon observed in blood units stored under blood bank conditions seems to be due to CA developed in response to vector-borne infectious agents. Majority of the cases displayed their specificities, otherwise are rare to be encountered

    FastIC: A Highly Configurable ASIC for Fast Timing Applications

    No full text
    This work presents the 8-channel FastIC ASIC developed in CMOS 65 nm technology suitable for the readout of positive and negative polarity sensors with intrinsic amplification in High Energy Physics experiments, Positron Emission Tomography and other Time-of-Flight systems. The front-end can be configured to readout each input channel individually or perform analog summation of up to 4 single-ended channels before discrimination in view of extending precise timing to large and segmented areas. The outputs encode the Time-Of-Arrival information and linear Energy measurement in the 5 μA − 25 mA input range with a measured linearity error below 3%, and a power consumption of 12 mW/Ch with default settings. Measurements of Single Photon Time Resolution (SPTR) with a red-light laser source and a Hamamatsu SiPM S13360-3050CS have shown ~140 ps FWHM. Coincidence Time Resolution (CTR) measurements with LSO:Ce:Ca 0.2% measuring 2 × 2 × 5 mm 3 coupled to the same sensor resulted in ~ 104 ps FWHM. The FastIC is compared with the HRFlexToT ASIC under the same conditions, obtaining an SPTR and CTR improvement of 12.8% and 11.4%, respectively

    FastIC: a fast integrated circuit for the readout of high performance detectors

    No full text
    This work presents the 8-channel FastIC ASIC developed in CMOS 65 nm technology suitable for the readout of positive and negative polarity sensors in high energy physics experiments, Cherenkov detectors and time-of-flight systems. The front-end can be configured to perform analog summation of up to 4 single-ended channels before discrimination in view of improving time resolution when segmenting a SiPM. The outputs encode the time-of-arrival information and linear energy measurement which captures the peak amplitude of the input signal in the 5 µA–25 mA input peak current range. Power consumption of the ASIC is 12 mW/ch with default settings. Measurements of single photon time resolution with a red-light laser source and a HPK SiPM S13360-3050CS are ≈140 ps FWHM
    corecore