Observation and its History

Recenze: Lorraine DASTON - Elizabeth LUNBECK, E., Histories of Scientific Observation. Chicago - London: University of Chicago Press 2011, 460 pp

Institutions and Dissent: Historical Geology in the Early Royal Society

The paper aims to ques- tion the traditional view of the early Royal Society of London, the oldest scientific institution in continuous existence. According to that view, the institutional life of the Society in the early decades of activity was characterized by a strictly Baconian methodology. But the re- construction of the discussions about fossils and natural history within the Society shows that this monolithic image is far from being correct. Despite the persistent reference to the Baconian Solomon House, the Society did not impose or support a common programme of research in the field of the natural history of the Earth

A thermodynamically consistent derivation of a frictional-damage cohesive-zone model with different mode i and mode II fracture energies

The present paper deals with the derivation of an interface model characterized by macroscopic fracture energies which are different in modes I and II, the macroscopic fracture energy being the total energy dissipated per unit of fracture area. It is first shown that thermo-dynamical consistency for a model governed by a single damage variable, combined with the choice of employing an equivalent relative displacement and of a linear softening in the stress-relative displacement law, leads to the coincidence of fracture energies in modes I and II. To retrieve the experimental evidence of a greater fracture energy in mode II, a micro-structured geometry is considered at the typical point of the interface where a Representative Interface Element (RIE) characterized by a periodic arrangement of distinct inclined planes is introduced. The interaction within each of these surfaces is governed by a coupled damage-friction law. A sensitivity analysis of the correlation between micromechanical parameters and the numerically computed single-point microstructural response in mode II is reported. An assessment of the capability of the model in predicting different mixed mode fracture energies is carried out both at the single microstructural interface point level and with a structural example. For the latter a double cantilever beam with uneven bending moments has been analyzed and numerical results are compared with experimental data reported in the literature for different values of mode mixity. © 2014 Elsevier Masson SAS. All rights reserved

The double population of Chamaeleon I detected by Gaia DR2

Context. Chamaeleon I represents an ideal laboratory to study the cluster formation in a low-mass environment. Recently, two sub clusters spatially located in the northern and southern parts of Chamaeleon I were found with different ages and radial velocities. Aims. In this letter we report new insights into the structural properties, age, and distance of Chamaeleon I based on the astrometric parameters from Gaia data-release 2 (DR2). Methods. We identified 140 sources with a reliable counterpart in the Gaia DR2 archive. We determined the median distance of the cluster using Gaia parallaxes and fitted the distribution of parallaxes and proper motions assuming the presence of two clusters. We derived the probability of each single source of belonging to the northern or southern sub-clusters, and compared the HR diagram of the most probable members to pre-main sequences isochrones. Results. The median distance of Chamaeleon I is ~190 pc. This is about 20 pc larger than the value commonly adopted in the literature. From a Kolmogorov-Smirnov test of the parallaxes and proper-motion distributions we conclude that the northern and southern clusters do not belong to the same parent population. The northern population has a distance dN = 192.7+/-0.4 pc, while the southern one dS = 186.5+/-0.7 pc. The two sub-clusters appear coeval, at variance with literature results, and most of the sources are younger than 3 Myr. The northern cluster is more elongated and extends towards the southern direction partially overlapping with the more compact cluster located in the south. A hint of a relative rotation between the two sub-clusters is also found.Comment: Letter accepted by A&

Bond-slip analysis via a cohesive-zone model simulating damage, friction and interlocking

A recently proposed cohesive-zone model which effectively combines damage, friction and mechanical interlocking has been revisited and further validated by numerically simulating the pull-out test, from a concrete block, of a ribbed steel bar in the post-yield deformation range. The simulated response is in good agreement with experimental measurements of the bond slip characteristics in the post-yield range of deformed bars reported in the literature. This study highlights the main features of the model: with physically justified and relatively simple arguments, and within the sound framework of thermodynamics with internal variables, the model effectively separates the three main sources of energy dissipation, i.e. loss of adhesion, friction along flat interfaces and mechanical interlocking. This study provides further evidence that the proposed approach allows easier and physically clearer procedures for the determination of the model parameters of such three elementary mechanical behaviours, and makes possible their interpretation and measurement as separate material property, as a viable alternative to lumping these parameters into single values of the fracture energy. In particular, the proposed approach allows to consider a single value of the adhesion energy for modes I and II

Evidence for Variable, Correlated X-ray and Optical/IR Extinction toward the Nearby, Pre-main Sequence Binary TWA 30

We present contemporaneous XMM-Newton X-ray and ground-based optical/near-IR spectroscopic observations of the nearby ($D \approx 42$ pc), low-mass (mid-M) binary system TWA 30A and 30B. The components of this wide (separation $\sim$3400 AU) binary are notable for their nearly edge-on disk viewing geometries, high levels of variability, and evidence for collimated stellar outflows. We obtained XMM-Newton X-ray observations of TWA 30A and 30B in 2011 June and July, accompanied (respectively) by IRTF SpeX (near-IR) and VLT XSHOOTER (visible/near-IR) spectroscopy obtained within $\sim$20 hours of the X-ray observations. TWA 30A was detected in both XMM-Newton observations at relatively faint intrinsic X-ray luminosities ($L_{X}$$\sim$$8\times10^{27}$ $erg$ $s^{-1}$) compared to stars of similar mass and age . The intrinsic (0.15-2.0 keV) X-ray luminosities measured in 2011 had decreased by a factor 20-100 relative to a 1990 (ROSAT) X-ray detection. TWA 30B was not detected, and we infer an upper limit of ($L_{X}$ $\lesssim$ 3.0 $\times$ $10^{27}$ erg s$^{-1}$). We measured a large change in visual extinction toward TWA 30A (from $A_V \approx 14.9$ to $A_V \approx 4.7$) between the two 2011 observing epochs, and we find evidence for a corresponding significant decrease in X-ray absorbing column ($N_H$). The apparent correlated change in $A_V$ and $N_H$ is suggestive of variable obscuration of the stellar photosphere by disk material composed of both gas and dust. However, in both observations, the inferred $N_{H}$ to $A_{V}$ ratio is lower than that typical of the ISM, suggesting that the disk is either depleted of gas or is deficient in metals in the gas phase.Comment: 10 pages, 7 figures, Accepted for publication in MNRA

The Multiple Young Stellar Objects of HBC 515: An X-ray and Millimeter-wave Imaging Study in (Pre-main Sequence) Diversity

We present Chandra X-ray Observatory and Submillimeter Array (SMA) imaging of HBC 515, a system consisting of multiple young stellar objects (YSOs). The five members of HBC 515 represent a remarkably diverse array of YSOs, ranging from the low-mass Class I/II protostar HBC 515B, through Class II and transition disk objects (HBC 515D and C, respectively), to the "diskless", intermediate- mass, pre-main sequence binary HBC 515A. Our Chandra/ACIS imaging establishes that all five components are X-ray sources, with HBC 515A - a subarcsecond-separation binary that is partially resolved by Chandra - being the dominant X-ray source. We detect an X-ray flare associated with HBC 515B. In the SMA imaging, HBC 515B is detected as a strong 1.3 mm continuum emission source; a second, weaker mm continuum source is coincident with the position of the transition disk object HBC 515C. These results strongly support the protostellar nature of HBC 515B, and firmly establish HBC 515A as a member of the rare class of relatively massive, X-ray luminous "weak-lined T Tauri stars" that are binaries and have shed their disks at very early stages of pre-MS evolution. The coexistence of two such disparate objects within a single, presumably coeval multiple YSO system highlights the influence of pre- MS star mass, binarity, and X-ray luminosity in regulating the lifetimes of circumstellar, planet-forming disks and the timescales of star-disk interactions.Comment: Accepted for publication in A&A; 11 pages, 5 figure

An Unbiased 1.3 mm Emission Line Survey of the Protoplanetary Disk Orbiting LkCa 15

The outer (>30 AU) regions of the dusty circumstellar disk orbiting the ~2-5 Myr-old, actively accreting solar analog LkCa 15 are known to be chemically rich, and the inner disk may host a young protoplanet within its central cavity. To obtain a complete census of the brightest molecular line emission emanating from the LkCa 15 disk over the 210-270 GHz (1.4 - 1.1 mm) range, we have conducted an unbiased radio spectroscopic survey with the Institute de Radioastronomie Millimetrique (IRAM) 30 meter telescope. The survey demonstrates that, in this spectral region, the most readily detectable lines are those of CO and its isotopologues 13CO and C18O, as well as HCO+, HCN, CN, C2H, CS, and H2CO. All of these species had been previously detected in the LkCa 15 disk; however, the present survey includes the first complete coverage of the CN (2-1) and C2H (3-2) hyperfine complexes. Modeling of these emission complexes indicates that the CN and C2H either reside in the coldest regions of the disk or are subthermally excited, and that their abundances are enhanced relative to molecular clouds and young stellar object environments. These results highlight the value of unbiased single-dish line surveys in guiding future high resolution interferometric imaging of disks.Comment: 35 pages, 9 figures, accepted for publication in The Astrophysical Journa

Chromium recovery by membranes for process reuse in the tannery industry

Leather tanning is a wide common industry all over the world. In leather processing, water is one of the most important medium, almost 40-45 L water kg-1 raw-hide or skin is used by tanneries for processing finished leathers. The composition of tannery wastewater presents considerable dissimilarities in the concentration range of pollutants both of inorganic (chlorides, with concentration ranging from several hundred to over 10,000 mg L-1 Cl–; sulphate (VI), ammonium ions and sulphide ions, exhibiting concentration that ranges from tens to several hundred mg L-1) and organic (the COD value is usually several thousand mg L-1 O2). Throughout the years, many conventional processes have been carried out to treat wastewater from tannery industry: unfortunately, in this case, biological treatment methods give rise to an excessive production of sludge, whereas physical and chemical methods are too expensive in terms of energy and reagent costs. In this work, a membrane process based on NF membrane modules was adopted to treat the tannery feedstock after primary conventional treatment. In a first step, the determination of all boundary flux parameters, in order to inhibit severe fouling formation during operation, were performed. After this, experimental work was carried out to validate the approach. The target of water purification was reached, that is the legal discharge to municipal sewer system in Italy of 90% of the initial wastewater stream volume. This allows having an immediate cost saving of 21%. Moreover, the developed process leads to a second benefit, that is the production of 5% of the initial volume as a highly chromium-rich concentrate at no cost suitable to tannery process recycle and reuse. In this case, cost saving rates exceeds 40%. At the end, scale-up of the investigated process will be discussed from technical and economic point of view