49 research outputs found
Carrier concentration dependence of optical Kerr nonlinearity in indium tin oxide films
Optical Kerr nonlinearity (n2) in n-type indium tin oxide (ITO) films coated
on glass substrates has been measured using Z-scans with 200-fs laser pulses at
wavelengths ranging from 720 to 780 nm. The magnitudes of the measured
nonlinearity in the ITO films were found to be dependent on the carrier
concentration with a maximum n2-value of 4.1 x 10-5 cm2/GW at 720-nm wavelength
and an electron density of Nd = 5.8 x 1020 cm-3. The Kerr nonlinearity was also
observed to be varied with the laser wavelength. By employing a femtosecond
time-resolved optical Kerr effect (OKE) technique, the relaxation time of OKE
in the ITO films is determined to be ~1 ps. These findings suggest that the
Kerr nonlinearity in ITO can be tailored by controlling the carrier
concentration, which should be highly desirable in optoelectronic devices for
ultrafast all-optical switching.Comment: 15 pages, 1 table, 4 figure
Atomic Layer Deposition of ZnO on Multi-walled Carbon Nanotubes and Its Use for Synthesis of CNT–ZnO Heterostructures
In this article, direct coating of ZnO on PECVD-grown multi-walled carbon nanotubes (MWCNTs) is achieved using atomic layer deposition (ALD). Transmission electron microscopy investigation shows that the deposited ZnO shell is continuous and uniform, in contrast to the previously reported particle morphology. The ZnO layer has a good crystalline quality as indicated by Raman and photoluminescence (PL) measurements. We also show that such ZnO layer can be used as seed layer for subsequent hydrothermal growth of ZnO nanorods, resulting in branched CNT–inorganic hybrid nanostructures. Potentially, this method can also apply to the fabrication of ZnO-based hybrid nanostructures on other carbon nanomaterials
Synthesis, Characterization, and Microwave Absorption Property of the SnO2Nanowire/Paraffin Composites
In this article, SnO2nanowires (NWs) have been prepared and their microwave absorption properties have been investigated in detail. Complex permittivity and permeability of the SnO2NWs/paraffin composites have been measured in a frequency range of 0.1–18 GHz, and the measured results are compared with that calculated from effective medium theory. The value of maximum reflection loss for the composites with 20 vol.% SnO2NWs is approximately −32.5 dB at 14 GHz with a thickness of 5.0 mm
Investigation into Photoconductivity in Single CNF/TiO2-Dye Core–Shell Nanowire Devices
A vertically aligned carbon nanofiber array coated with anatase TiO2 (CNF/TiO2) is an attractive possible replacement for the sintered TiO2 nanoparticle network in the original dye-sensitized solar cell (DSSC) design due to the potential for improved charge transport and reduced charge recombination. Although the reported efficiency of 1.1% in these modified DSSC’s is encouraging, the limiting factors must be identified before a higher efficiency can be obtained. This work employs a single nanowire approach to investigate the charge transport in individual CNF/TiO2 core–shell nanowires with adsorbed N719 dye molecules in dark and under illumination. The results shed light on the role of charge traps and dye adsorption on the (photo) conductivity of nanocrystalline TiO2 CNF’s as related to dye-sensitized solar cell performance
Broadband luminescence in defect-engineered electrochemically produced porous Si/ZnO nanostructures
The fabrication, by an all electrochemical process, of porous Si/ZnO nanostructures with engineered structural defects, leading to strong and broadband deep level emission from ZnO, is presented. Such nanostructures are fabricated by a combination of metal-assisted chemical etching of Si and direct current electrodeposition of ZnO. It makes the whole fabrication process low-cost, compatible with Complementary Metal-Oxide Semiconductor technology, scalable and easily industrialised. The photoluminescence spectra of the porous Si/ZnO nanostructures reveal a correlation between the lineshape, as well as the strength of the emission, with the morphology of the underlying porous Si, that control the induced defects in the ZnO. Appropriate fabrication conditions of the porous Si lead to exceptionally bright Gaussian-type emission that covers almost the entire visible spectrum, indicating that porous Si/ZnO nanostructures could be a cornerstone material towards white-light-emitting devices