279,444 research outputs found
Shock and vibration response of multistage structure
Study of the shock and vibration response of a multistage structure employed analytically, lumped-mass, continuous-beam, multimode, and matrix-iteration methods. The study was made on the load paths, transmissibility, and attenuation properties along a longitudinal axis of a long, slender structure with increasing degree of complexity
Motion of a sphere in the presence of a plane interface. Part 2. An exact solution in bipolar co-ordinates
A general solution for Stokes’ equation in bipolar co-ordinates is derived, and then applied to the arbitrary motion of a sphere in the presence of a plane fluid/fluid interface. The drag force and hydrodynamic torque on the sphere are then calculated for four specific motions of the sphere; namely, translation perpendicular and parallel to the interface and rotation about an axis which is perpendicular and parallel, respectively, to the interface. The most significant result of the present work is the comparison between these numerically exact solutions and the approximate solutions from part 1. The latter can be generalized to a variety of particle shapes, and it is thus important to assess their accuracy for this case of spherical particles where an exact solution can be obtained. In addition to comparisons with the approximate solutions, we also examine the predicted changes in the velocity, pressure and vorticity fields due to the presence of the plane interface. One particularly interesting feature of the solutions is the fact that the direction of rotation of a freely suspended sphere moving parallel to the interface can either be the same as for a sphere rolling along the interface (as might be intuitively expected), or opposite depending upon the location of the sphere centre and the ratio of viscosities for the two fluids
The creeping motion of a spherical particle normal to a deformable interface
Numerical results are presented for the approach of a rigid sphere normal to a deformable fluid-fluid interface in the velocity range for which inertial effects may be neglected. Both the case of a sphere moving with constant velocity, and that of a sphere moving under the action of a constant non-hydrodynamic body force are considered for several values of the viscosity ratio, density difference and interfacial tension between the two fluids. Two distinct modes of interface deformation are demonstrated: a film drainage mode in which fluid drains away in front of the sphere leaving an ever-thinning film, and a tailing mode where the sphere passes several radii beyond the plane of the initially undeformed interface, while remaining encapsulated by the original surrounding fluid which is connected with its main body by a thin thread-like tail behind the sphere. We consider the influence of the viscosity ratio, density difference, interfacial tension and starting position of the sphere in deter-mining which of these two modes of deformation will occur
Large-N Yang-Mills Theory as Classical Mechanics
To formulate two-dimensional Yang-Mills theory with adjoint matter fields in
the large-N limit as classical mechanics, we derive a Poisson algebra for the
color-invariant observables involving adjoint matter fields. We showed
rigorously in J. Math. Phys. 40, 1870 (1999) that different quantum orderings
of the observables produce essentially the same Poisson algebra. Here we
explain, in a less precise but more pedagogical manner, the crucial topological
graphical observations underlying the formal proof.Comment: 8 pages, 3 eps figues, LaTeX2.09, aipproc macros needed; conference
proceeding of MRST '99 (10-12 May, 1999, Carleton University, Canada
Theoretical study of X-ray absorption of three-dimensional topological insulator
X-ray absorption edge singularity which is usually relevant for metals is
studied for the prototype topological insulator .
The generalized integral equation of Nozi\`eres and Dominicis type for X-ray
edge singularity is derived and solved. The spin texture of surfaces states
causes a component of singularity dependent on the helicity of the spin
texture. It also yields another component for which the singularity from
excitonic processes is absent.Comment: RevTeX 4.1. 4 pages, no figur
Swept shock/boundary layer interaction experiments in support of CFD code validation
Research on the topic of shock wave/turbulent boundary layer interaction was carried out. Skin friction and surface pressure measurements in fin-induced, swept interactions were conducted, and heat transfer measurements in the same flows are planned. The skin friction data for a strong interaction case (Mach 4, fin-angles equal 16 and 20 degrees) were obtained, and their comparison with computational results was published. Surface pressure data for weak-to-strong fin interactions were also obtained
Swept shock/boundary layer interaction experiments in support of CFD code validation
Research on the topic of shock wave/turbulent boundary-layer interaction was carried out during the past three years at the Penn State Gas Dynamics Laboratory. This report describes the experimental research program which provides basic knowledge and establishes new data on heat transfer in swept shock wave/boundary-layer interactions. An equilibrium turbulent boundary-layer on a flat plate is subjected to impingement by swept planar shock waves generated by a sharp fin. Five different interactions with fin angle ranging from 10 deg to 20 deg at freestream Mach numbers of 3.0 and 4.0 produce a variety of interaction strengths from weak to very strong. A foil heater generates a uniform heat flux over the flat plate surface, and miniature thin-film-resistance sensors mounted on it are used to measure the local surface temperature. The heat convection equation is then solved for the heat transfer distribution within an interaction, yielding a total uncertainty of about +/- 10 percent. These experimental data are compared with the results of numerical Navier-Stokes solutions which employ a k-epsilon turbulence model. Finally, a simplified form of the peak heat transfer correlation for fin interactions is suggested
A Lie Algebra for Closed Strings, Spin Chains and Gauge Theories
We consider quantum dynamical systems whose degrees of freedom are described
by matrices, in the planar limit . Examples are
gauge theoires and the M(atrix)-theory of strings. States invariant under U(N)
are `closed strings', modelled by traces of products of matrices. We have
discovered that the U(N)-invariant opertors acting on both open and closed
string states form a remarkable new Lie algebra which we will call the heterix
algebra. (The simplest special case, with one degree of freedom, is an
extension of the Virasoro algebra by the infinite-dimensional general linear
algebra.) Furthermore, these operators acting on closed string states only form
a quotient algebra of the heterix algebra. We will call this quotient algebra
the cyclix algebra. We express the Hamiltonian of some gauge field theories
(like those with adjoint matter fields and dimensionally reduced pure QCD
models) as elements of this Lie algebra. Finally, we apply this cyclix algebra
to establish an isomorphism between certain planar matrix models and quantum
spin chain systems. Thus we obtain some matrix models solvable in the planar
limit; e.g., matrix models associated with the Ising model, the XYZ model,
models satisfying the Dolan-Grady condition and the chiral Potts model. Thus
our cyclix Lie algebra described the dynamical symmetries of quantum spin chain
systems, large-N gauge field theories, and the M(atrix)-theory of strings.Comment: 52 pages, 8 eps figures, LaTeX2.09; this is the published versio
- …