An Evaluation of Herbicides for Broadleaf-Weed Control in Rapeseed: Efficacy, Phytotoxicity, and Soil Persistence Studies

At the recommended rates (1.0 lb/A for trifluralin, ethalfluralin, EL5261; 0.75 lb/A for dinitramine; 1.2 lb/A for nitrofen), none of the herbicides we evaluated in these studies reduced rapeseed stands, yields, or test weights. However, at higher rates (1. 5, 3.0 lb A), dinitramine reduced rapeseed stands, but this did not result in decreased yields. None of the other herbicides reduced rapeseed stand, yield, or test weights when applied at up to four times the recommended rate. No trifluralin residues were detected in rapeseed whole-plant or seed samples. All of the herbicides provided adequate control of common lambsquarters (Chenopodium album L.). Corn spurry (Spergula arvensis L.) was controlled by trifluralin. ethalfluralin. EL-5261, and nitrofen. All of the herbicides except nitrofen controlled chickweed [Stellaria media (L.) Cyrillo]. In 1979, 51 per cent of the trifluralin applied remained at the end of the growing season in one study while 26 per cent remained in another study. The rate of degradation at three sites in 1979 were as follows (greatest to least); Delta Junction, Matanuska Valley, Fairbanks. Degradation rates of trifluralin were not significantly different in three soil types or at two different application rates. Trifluralin showed no signs of leaching through the soil profile. In 1981, 25 per cent of the trifluralin, 8 per cent of the ethalfluralin, and 24 per cent of the EL-5261 applied remained at the end of the growing season. Despite the relatively long persistence of these preplant, incorporated herbicides, yields and test weights of barley planted in succeeding years were not reduced. A benefit of these persistent residues was control of broadleaf weeds in the succeeding barley crop

On the engineering of crucial software

The various aspects of the conventional software development cycle are examined. This cycle was the basis of the augmented approach contained in the original grant proposal. This cycle was found inadequate for crucial software development, and the justification for this opinion is presented. Several possible enhancements to the conventional software cycle are discussed. Software fault tolerance, a possible enhancement of major importance, is discussed separately. Formal verification using mathematical proof is considered. Automatic programming is a radical alternative to the conventional cycle and is discussed. Recommendations for a comprehensive approach are presented, and various experiments which could be conducted in AIRLAB are described

The potential of Antheraea pernyi silk for spinal cord repair

This work was supported by the Institute of Medical Sciences of the University of Aberdeen, Scottish Rugby Union and RS McDonald Charitable Trust. We are grateful to Mr Nicholas Hawkins from Oxford University and Ms Annette Raffan from the University of Aberdeen for assistance with tensile testing. We thank Ms Michelle Gniβ for her help with the microglial response experiments. We also thank Mr Gianluca Limodio for assisting with the MATLAB script for automation of tensile testing’s data analysis.Peer reviewedPublisher PD

A rotor-mounted digital instrumentation system for helicopter blade flight research measurements

A rotor mounted flight instrumentation system developed for helicopter rotor blade research is described. The system utilizes high speed digital techniques to acquire research data from miniature pressure transducers on advanced rotor airfoils which are flight tested on an AH-1G helicopter. The system employs microelectronic pulse code modulation (PCM) multiplexer digitizer stations located remotely on the blade and in a hub mounted metal canister. As many as 25 sensors can be remotely digitized by a 2.5 mm thick electronics package mounted on the blade near the tip to reduce blade wiring. The electronics contained in the canister digitizes up to 16 sensors, formats these data with serial PCM data from the remote stations, and transmits the data from the canister which is above the plane of the rotor. Data are transmitted over an RF link to the ground for real time monitoring and to the helicopter fuselage for tape recording. The complete system is powered by batteries located in the canister and requires no slip rings on the rotor shaft

Hot entanglement in a simple dynamical model

How mixed can one component of a bi-partite system be initially and still become entangled through interaction with a thermalized partner? We address this question here. In particular, we consider the question of how mixed a two-level system and a field mode may be such that free entanglement arises in the course of the time evolution according to a Jaynes-Cummings type interaction. We investigate the situation for which the two-level system is initially in mixed state taken from a one-parameter set, whereas the field has been prepared in an arbitrary thermal state. Depending on the particular choice for the initial state and the initial temperature of the quantised field mode, three cases can be distinguished: (i) free entanglement will be created immediately, (ii) free entanglement will be generated, but only at a later time different from zero, (iii) the partial transpose of the joint state remains positive at all times. It will be demonstrated that increasing the initial temperature of the field mode may cause the joint state to become distillable during the time evolution, in contrast to a non-distillable state at lower initial temperatures. We further assess the generated entanglement quantitatively, by evaluating the logarithmic negativity numerically, and by providing an analytical upper bound.Comment: 5 pages, 2 figures. Contribution to the proceedings of the 'International Conference on Quantum Information', Oviedo, July 13-18, 2002. Discusses sudden changes of entanglement properties in a dynamical quantum mode

Dissipation of Bromide and Metribuzin Affected by Tillage and Crop Residue Management in Subarctic Alaska

Prudent use of agricultural fertilizers and herbicides is paramount for sustaining or improving surface and ground water quality in Subarctic regions, but little information is available that documents the loss of chemicals from agricultural lands in the Subarctic. This study aimed to ascertain more clearly how time of application and land management practices affect the loss of bromide and metribuzin in a Subarctic soil. Potassium bromide (KBr), a surrogate for nitrate, and metribuzin, commonly used to control broadleaf weeds, were applied in the autumn of 1996 and the spring of 1997 to a silt loam that had been subjected to conventional tillage (CT), minimum tillage (disk once [DO]), and no tillage (NT) since 1983. Superimposed on the tillage treatments were the removal or retention of barley (Hordeum vulgare L.) stubble and loose straw. Loss of these chemicals was ascertained by sampling the soil profile at the time of heading of barley, before freeze-up of the soil in autumn, and after spring thaw until September 1998. Tillage and residue treatments did not influence the recovery of autumn-applied or spring-applied Br. However, recovery of Br diminished with time: about 30% of the Br applied in autumn and 45% of that applied in spring remained in the soil profile by September 1998. Tillage, but not residue, treatments influenced the recovery of metribuzin. Recovery of metribuzin at the termination of this study was 6% or more in NT soil and 2% or less in CT and DO soil; greater recovery in NT soil was presumably a result of slower degradation in NT than in CT and DO. This study suggests that bromide (and thus nitrate) and metribuzin are more prone to leaching when applied in autumn and that tillage practices affect retention of metribuzin, but not nitrate, in the soil of Subarctic Alaska.Une utilisation prudente des engrais et des herbicides est cruciale au maintien ou à l’amélioration de la qualité de l’eau de surface et de l’eau souterraine dans les régions subarctiques, mais il existe peu de documentation sur la déperdition des produits chimiques dans le sol des terres agricoles du Subarctique. Cette étude vise à établir avec plus de précision la façon dont le moment de l’application et les pratiques de gestion des terres affectent la déperdition du bromure et de la métribuzine dans un sol subarctique. Le bromure de potassium (KBr), un substitut du nitrate, et la métribuzine, couramment utilisée pour lutter contre les dicotylédones, ont été appliqués en automne 1996 et au printemps 1997 sur un loam limoneux qui avait subi un travail du sol classique (TC), un travail minimum (un seul passage du cultivateur à disque [TM]) et aucun travail (AT) depuis 1983. On a ajouté au travail du sol le déchaumage de l’orge (Hordeum vulgare L.) ou le maintien du chaume et de la paille. On a vérifié la déperdition de ces produits chimiques jusqu’en septembre 1998 en analysant le profil pédologique au moment de l’épiaison de l’orge, avant que le sol gèle à l’automne et après le dégel printanier. Le travail du sol et le traitement des résidus n’ont pas influencé la récupération du Br appliqué en automne ou au printemps. La récupération du Br a cependant diminué avec le temps: en septembre 1998, environ 30 % du Br appliqué à l’automne et 45 % de celui appliqué au printemps persistaient dans le profil pédologique. Le travail du sol, mais pas le traitement des résidus, influençait la récupération de la métribuzine. À la fin de l’étude, la récupération de la métribuzine était de 6 % ou plus dans le sol AT, et de 2 % ou moins dans les sols TC et TM; une récupération plus importante dans le sol AT résultait probablement d’une dégradation plus lente dans le AT que dans le TC et le TM. Cette étude suggère que le bromure (et, par conséquent, le nitrate) et la métribuzine sont plus sujets au lessivage quand ils sont appliqués en automne, et que les pratiques de travail du sol affectent la rétention de la métribuzine, mais pas celle du nitrate, dans le sol de l’Alaska subarctique

Introduction to the computational structural mechanics testbed

The Computational Structural Mechanics (CSM) testbed software system based on the SPAR finite element code and the NICE system is described. This software is denoted NICE/SPAR. NICE was developed at Lockheed Palo Alto Research Laboratory and contains data management utilities, a command language interpreter, and a command language definition for integrating engineering computational modules. SPAR is a system of programs used for finite element structural analysis developed for NASA by Lockheed and Engineering Information Systems, Inc. It includes many complementary structural analysis, thermal analysis, utility functions which communicate through a common database. The work on NICE/SPAR was motivated by requirements for a highly modular and flexible structural analysis system to use as a tool in carrying out research in computational methods and exploring computer hardware. Analysis examples are presented which demonstrate the benefits gained from a combination of the NICE command language with a SPAR computational modules

Self-consistency of relativistic observables with general relativity in the white dwarf-neutron star binary pulsar PSR J1141-6545

Here we report timing measurements of the relativistic binary pulsar PSR J1141-6545 that constrain the component masses and demonstrate that the orbital period derivative \dot Pb = (-4+/-1)x10^-13 is consistent with gravitational wave emission as described by the general theory of relativity. The mass of the neutron star and its companion are 1.30+/-0.02 Mo and 0.986+/-0.020 Mo respectively, suggesting a white dwarf companion, and extending the range of systems for which general relativity provides a correct description. On evolutionary grounds, the progenitor mass of PSR J1141-6545 should be near the minimum for neutron star production. Its mass is two standard deviations below the mean of the other neutron stars, suggesting a relationship between progenitor and remnant masses.Comment: 10 pages, 2 figures, revised version to Ap J Letter