Influence of microwave polymerization method and thickness on porosity of acrylic resin

Purpose: This study evaluated the influence of polymerization cycle and thickness of maxillary complete denture bases on the porosity of acrylic resin. Materials and Methods: Two heat-activated denture base resins - one conventional (Clássico) and one designed for microwave polymerization (Onda-Cryl) - were used. Four groups were established, according to polymerization cycles: A (Onda-Cryl, short microwave cycle), B (Onda-Cryl, long microwave cycle), C (Onda-Cryl, manufacturing microwave cycle), and T (Clássico, water bath). Porosity was evaluated for different thicknesses (2.0, 3.5, and 5.0 mm; thicknesses I, II, and III, respectively) by measurement of the specimen volume before and after its immersion in water. The percent porosity data were submitted to Kruskal-Wallis for comparison among the groups. Results: The Kruskal-Wallis test detected that the combinations of the different cycles and thicknesses showed significant differences, and the mean ranks of percent porosity showed differences only in the thinnest (2.0 mm) microwave-polymerized specimens (A = 53.55, B = 40.80, and C = 90.70). Thickness did not affect the results for cycle T (I = 96.15, II = 70.20, and III = 82.70), because porosity values were similar in the three thicknesses. Conclusions: Microwave polymerization cycles and the specimen thickness of acrylic resin influenced porosity. Porosity differences were not observed in the polymerized resin bases in the water bath cycle for any thickness. © 2007 by The American College of Prosthodontists

Hybrids membranes with potential for fuel cells – Part 3: extruded films of nanocomposites based on sepiolite and PC/sulfonated PC blends

<div><p>Abstract Fuel Cells based in polymers are an alternative for the conventional energetic matrices. However, materials currently available still present disadvantages to overcome. Membranes of polycarbonate (PC)/sulfonated polycarbonate (PCs) blend/sepiolite nanocomposites have previously been studied by the authors, resulting in good mechanical properties and promising properties of vapor transmission and ionic migration resistance. However, their production in large scale is still a challenge. The aim of this work was the development further the formulation and processing of the previously studied material. Films of PC/PCs blends (50/50 wt%) with different content of sepiolite clay, with and without chemical modification, have been prepared in an extruder and evaluated by FTIR, XRD, DSC, TGA, DMA, tension strength and water vapor transmission (WVT). Even after two processing steps, the blend-based nanocomposites keep good thermal and mechanical properties. However, changes in WVT were observed with respect to data obtained in previous studies.</p></div