27,048 research outputs found
Induction motor control system with voltage controlled oscillator circuit
A voltage controlled oscillator circuit is reported in which there are employed first and second differential amplifiers. The first differential amplifier, being employed as an integrator, develops equal and opposite slopes proportional to an input voltage, and the second differential amplifier functions as a comparator to detect equal amplitude positive and negative selected limits and provides switching signals which gate a transistor switch. The integrating differential amplifier is switched between charging and discharging modes to provide an output of the first differential amplifier which upon the application of wave shaping provides a substantially sinusoidal output signal. A two phased version with a second integrator provides a second 90 deg phase shifted output for induction motor control
End-wall boundary layer measurements in a two-stage fan
Detailed flow measurements made in the casing boundary layer of a two-stage transonic fan are summarized. These measurements were taken at a station upstream of the fan, between all blade rows, and downstream of the last row. Conventional boundary layer parameters were calculated from the measured data. A classical two dimensional casing boundary layer was measured at the fan inlet and extended inward to approximately 15 percent of span. A highly three dimensional boundary layer was measured at the exit of each blade row and extended inward to approximately 10 percent of span. The steep radial gradient of axial velocity noted at the exit of the rotors was reduced substantially as the flow passed through the stators. This reduced gradient is attributed to flow mixing. The amount of flow mixing was reflected in the radial redistribution of total temperature as the flow passed through the stators. The blockage factors calculated from the measured data show an increase in blockage across the rotors and a decrease across the stators. For this fan the calculated blockages for the second stage were essentially the same as those for the first stage
High temperature materials study
High temperature operating electronic devices for vapor deposition reactor syste
Preparation and characterization of electrodes for the NASA Redox storage system
Electrodes for the Redox energy storage system based on iron and chromium chloride reactants is discussed. The physical properties of several lots of felt were determined. Procedures were developed for evaluating electrode performance in lab scale cells. Experimental procedures for evaluating electrodes by cyclic voltammetry are described which minimize the IR losses due to the high internal resistance in the felt (distributed resistance). Methods to prepare electrodes which reduced the coevolution of hydrogen at the chromium electrode and eleminate the drop in voltage on discharge occasionally seen with previous electrodes were discussed. Single cells of 0.3329 ft area with improved membranes and electrodes are operating at over 80% voltage efficiency and coulombic efficiencies of over 98% at current densities of 16 to 20 amp % ft
High-temperature-materials study
Chemical vapor deposition of aluminum phosphides onto single crystals of silicon and gallium arsenide for producing high temperature operating solid state electronic device
Numerical analysis of four-wave mixing between 2 ps mode-locked laser pulses in a tensile-strained bulk SOA
A numerical model of four-wave mixing between 2-ps pulses in a tensile-strained bulk semiconductor optical amplifier is presented. The model utilizes a modified Schrodinger equation to model the pulse propagation. The Schrodinger equation parameters such as the material gain first and second order dispersion, linewidth enhancement factors and optical loss coefficient are obtained using a previously developed steady-state model. The predicted four-wave mixing pulse characteristics show reasonably good agreement with experimental pulse characteristics obtained using frequency resolved optical gating
Symmetries of Differential Equations via Cartan's Method of Equivalence
We formulate a method of computing invariant 1-forms and structure equations
of symmetry pseudo-groups of differential equations based on Cartan's method of
equivalence and the moving coframe method introduced by Fels and Olver. Our
apparoach does not require a preliminary computation of infinitesimal defining
systems, their analysis and integration, and uses differentiation and linear
algebra operations only. Examples of its applications are given.Comment: 15 pages, LaTeX 2.0
- …