Sub-chronic toxicological evaluation of cleistanthin A and cleistanthin B from the leaves of Cleistanthus collinus (Roxb.)

AbstractObjectiveTo investigate the toxicological effects of cleistanthin A and cleistanthin B using sub-chronic toxicity testing in rodents.MethodCleistanthins A and B were isolated from the leaves of Cleistanthus collinus. Both the compounds were administered orally for 90 days at the concentration of 12.5, 25 and 50 mg/kg, and the effects on blood pressure, biochemical parameters and histology were assessed. The dose for sub-chronic toxicology was determined by fixed dose method according to OECD guidelines.ResultSub-chronic toxicity study of cleistanthins A and B spanning over 90 days at the dose levels of 12.5, 25 and 50 mg/kg (once daily, per oral) revealed a significant dose dependant toxic effect in lungs. The compounds did not have any effect on the growth of the rats. The food and water intake of the animals were also not affected by both cleistanthins A and B. Both the compounds did not have any significant effect on liver and renal markers. The histopathological analysis of both cleistanthins A and B showed dose dependent morphological changes in the brain, heart, lung, liver and kidney. When compared to cleistanthin A, cleistanthin B had more toxic effect in Wistar rats. Both the compounds have produced a dose dependent increase of corpora amylacea in brain and induced acute tubular necrosis in kidneys. In addition, cleistanthin B caused spotty necrosis of liver in higher doses.ConclusionThe present study concludes that both cleistanthin A and cleistanthin B exert severe toxic effects on lungs, brain, liver, heart and kidneys. They do not cause any significant pathological change in the reproductive system; neither do they induce neurodegenerative changes in brain. When compared to cleistanthin A, cleistanthin B is more toxic in rats

A Total of 1,007 Percutaneous Coronary Interventions Without Onsite Cardiac Surgery Acute and Long-Term Outcomes

ObjectivesWe sought to compare clinical outcomes of elective percutaneous coronary intervention (PCI) and primary PCI for ST-segment elevation myocardial infarction (STEMI) at a community hospital without onsite cardiac surgery to those at a tertiary center with onsite cardiac surgery.BackgroundDisagreement exists about whether hospitals with cardiac catheterization laboratories, but without onsite cardiac surgery, should develop PCI programs. Primary PCI for STEMI at hospitals without onsite cardiac surgery have achieved satisfactory outcomes; however, elective PCI outcomes are not well defined.MethodsA total of 1,007 elective PCI and primary PCI procedures performed from March 1999 to August 2005 at the Immanuel St. Joseph’s Hospital–Mayo Health System (ISJ) in Mankato, Minnesota, were matched one-to-one with those performed at St. Mary’s Hospital (SMH) in Rochester, Minnesota. Strict protocols were followed for case selection and PCI program requirements. Clinical outcomes (in-hospital procedural success, death, any myocardial infarction, Q-wave myocardial infarction, and emergency coronary artery bypass surgery) and follow-up survival were compared between groups.ResultsAmong 722 elective PCIs, procedural success was 97% at ISJ compared with 95% at SMH (p = 0.046). Among 285 primary PCIs for STEMI, procedural success was 93% at ISJ and 96% at SMH (p = 0.085). No patients at ISJ undergoing PCI required emergent transfer for cardiac surgery. Survival at two years’ follow-up by treatment location was similar for patients with elective PCI and primary PCI.ConclusionsSimilar clinical outcomes for elective PCI and primary PCI were achieved at a community hospital without onsite cardiac surgery compared with those at a tertiary center with onsite cardiac surgery using a prospective, rigorous protocol for case selection and PCI program requirements

Segmental mobility studies of poly(N-isopropyl acrylamide) interactions with gold nanoparticles and its use as a thermally driven trapping system

YesThermal desolvation of poly(N‐isopropylacrylamide) (PNIPAM) in the presence of a low concentration of gold nanoparticles incorporates the nanoparticles resulting in suspended aggregates. By covalently incorporating 99.9% of the nanoparticles from their solutions and hence demonstrates that poly(N‐isopropylacrylamide) can act as an excellent scrubbing system to remove metallic nanomaterial pollutants from solution.Science Foundation Ireland's ETS. Grant Number: 11/W.I/12085; MRC. Grant Number: MR/N501888/

Multiview Laplacian semisupervised feature selection by leveraging shared knowledge among multiple tasks

Recently, considerable advancement has been achieved in semisupervised multitask feature selection methods, which they exploit the shared information from multiple related tasks. Besides, these algorithms have adopted manifold learning to leverage both the unlabeled and labeled data since its laborious to obtain adequate labeled training data. However, these semisupervised multitask selection feature algorithms are unable to naturally handle the multiview data since they are designed to deal single-view data. Existing studies have demonstrated that mining information enclosed in multiple views can drastically enhance the performance of feature selection. Multiview learning is capable of exploring the complementary and correlated knowledge from different views. In this paper, we incorporate multiview learning into semisupervised multitask feature selection framework and present a novel semisupervised multiview multitask feature selection framework. Our proposed algorithm is capable of exploiting complementary information from different feature views in each task while exploring the shared knowledge between multiple related tasks in a joint framework when the labeled training data is sparse. We develop an efficient iterative algorithm to optimize it since the objective function of the proposed method is non-smooth and difficult to solve. Experiment results on several multimedia applications have shown that the proposed algorithm is competitive compared with the other single-view feature selection algorithms

Adsorption characteristics and pore-development of biomass-pyrolysis char

Utilization of biomass-pyrolysis char for adsorption purposes is of bonus advantage and importance considering the ubiquitous need for a cheap source of carbon adsorbent for various small-scale industries for waste water treatment. Experimental studies were conducted in this context, to characterize the biomass-pyrolysis char to explain their specificity as conditioned by their individual adsorptive properties. The influence of ash elements was studied in detail; and a theory according with the various relevant literature is proposed for the interaction among the components-advocating that post-fusion pore-growth sustains the interaction among components that, in turn, influences the adsorption characteristics of biomass. A general correlation is further developed to explain the adsorption properties of char obtained from various treated and untreated biomass based upon (a) volatile yield and rate of pyrolysis, (b) average molecular weight of the products, and (c) the elemental H:C and O:C ratios. (C) 1998 .

Heating value of biomass and biomass pyrolysis products

Studies conducted on the heating value of various types of biomass components and their pyrolysis products such as char, liquids and gases are presented. Heating values of chars are comparable with those of lignite and coke; heating values of liquids are comparable with those of oxygenated fuels such as methanol and ethanol, which are much lower than those of petroleum fuels. Heating values of gases are comparable with those of producer gas or coal gas and are much lower than that of natural gas. It is also found that the heating values of products are functions of the initial composition of biomass; correlations are developed to express these. Also, correlations are developed which explain the influence of ash elements on heating values of the pyrolysis products and on percentage distribution of energy in the products. Copyright (C) 1996

Pyrolysis characteristics of biomass and biomass components

Biomass pyrolysis studies were conducted using both a thermogravimetric analyser and a packed-bed pyrolyser. Each kind of biomass has a characteristic pyrolysis behaviour which is explained based on its individual component characteristics. Studies on isolated biomass components as well as synthetic biomass show that the interactions among the components are not of as much significance as the composition of the biomass. Direct summative correlations based on biomass component pyrolysis adequately explain both the pyrolysis characteristics and product distribution of biomass. It is inferred that there is no detectable interaction among the components during pyrolysis in either the thermogravimetric analyser or the packed-bed pyrolyser. However, ash present in biomass seems to have a strong influence on both the pyrolysis characteristics and the product distribution. (C) 1996

RAPD markers for screening shoot gall maker (Betousa stylophora Swinhoe) tolerant genotypes of amla (Phyllanthus emblica L.)

Phyllanthus emblica Linn. is the most important medicinally useful tree crop in Asian Subcontinent and is severely infested by Betousa stylophora Swinhoe, known as shoot gall maker (SGM). This pest tunnels the shoots of seedlings and actively growing branches of trees and develops gall, leading to stunted growth, unusual branching and death of actively growing shoots. Our study revealed that trees possessing smooth bark were free from the attack of this pest than those with rough bark surface. Unfortunately, this character is not detectable either at seedling stage or during early growth of trees in the orchard. RAPD genetic fingerprinting of trees possessing smooth and rough bark revealed distinguishable and highly reproducible DNA banding pattern between the two genotypes. Of the 20 RAPD primers tested, five of them produced distinguishable RAPD bands between rough and smooth barked genotypes of P. emblica. Trees with smooth bark produced five unique RAPD bands with molecular weight ranging from 350 bp to 1500 bp and those with rough bark produced six RAPD bands (350 bp–650 bp) to utilize these DNA bands as potential DNA marker for screening tolerant genotypes of this crop against SGM. The utility of this finding in genetic improvement of this tree crop against SGM is discussed

Genetic enhancement of phosphorus starvation tolerance through marker assisted introgression of OsPSTOL1 gene in rice genotypes harbouring bacterial blight and blast resistance.

Phosphorus (P), an essential macronutrient, is a prerequisite for various plant-growth mechanisms including root establishment/development, early/late vegetative stage development and reproductive stage development. Rice (Oryza sativa) is very sensitive to P starvation. Most cultivated genotypes have poor tolerance levels to P deficiency and consequently the grain yield is severely affected by P starvation. Since P deficiency of soils is a major concern of rice production areas, it is necessary to develop new cultivars with enhanced P tolerance. This is also an expectation of farmers and the Agriculture ministry of southern states of India where rice cultivation is intensive. Our objective was to introgress the phosphorus starvation tolerance (OsPSTOL1) gene through marker-assisted backcross breeding (MABB) in to two intermediate genetic stocks of popular local-varieties namely, ASD 16 and ADT 43 which harbour bacterial blight and blast resistance (R) genes. To delve into the P starvation phenotypic effect, we have generated a set of four backcross inbred lines (BILs) with enhanced P starvation tolerance. The developed BILs showed altered root architecture pattern and greater root surface area with increased P uptake, confirming their adaptability to P deficient soil conditions. Further, a correlation between root traits and low/high P conditions indicates the function of introgressed OsPSTOL1 in BILs. The enhanced root characteristics, therefore, enabled the plants to access and effectively absorb available nutrients from soil. In summary, the unique features of the OsPSTOL1 BILs with bacterial blight and blast resistance can aid varietal development suitable for cultivation in P deficient soils

Clinical Study Avoiding the Learning Curve for Transcatheter Aortic Valve Replacement

Objectives. To evaluate whether collaboration between existing and new transcatheter aortic valve replacement (TAVR) programs could help reduce the number of cases needed to achieve optimal efficiency. Background. There is a well-documented learning curve for achieving procedural efficiency and safety in TAVR procedures. Methods. A multidisciplinary collaboration was established between the Minneapolis VA Medical Center (new program) and the University of Minnesota (established program since 2012, = 219) 1 year prior to launching the new program. Results. 269 patients treated with TAVR (50 treated in the first year at the new program). Mean age was 76 (±18) years and STS score was 6.8 (±6). Access included transfemoral ( = 35, 70%), transapical ( = 8, 16%), transaortic ( = 2, 4%), and subclavian ( = 5, 10%) types. Procedural efficiency (procedural time 158 ± 59 versus 148 ± 62, = 0.27), device success (96% versus 87%, = 0.08), length of stay (5 ± 3 versus 6 ± 7 days, = 0.10), and safety (in hospital mortality 4% versus 6%, = 0.75) were similar between programs. We found no difference in outcome measures between the first and last 25 patients treated during the first year of the new program. Conclusions. Establishing a partnership with an established program can help mitigate the learning curve associated with these complex procedures