Effect of shot peening on the fatigue life of a Zr-based bulk metallic glass

The fatigue lives of a Zr-based bulk metallic glass (BMG) in the as-cast and shot-peened conditions were evaluated. Results suggest that shot peening does not cause significant enhancement of the fatigue performance of the BMG. Cracks were observed to nucleate in subsurface regions. This was attributed to the domination of the compressive residual stress field on the surface over deformation-induced plastic flow softening that otherwise leads to easy nucleation of shear bands which act like microcracks

Effect of shot peening on the fatigue life of a Zr-based bulk metallic glass

The fatigue lives of a Zr-based bulk metallic glass (BMG) in the as-cast and shot-peened conditions were evaluated. Results suggest that shot peening does not cause significant enhancement of the fatigue performance of the BMG. Cracks were observed to nucleate in subsurface regions. This was attributed to the domination of the compressive residual stress field on the surface over deformation-induced plastic flow softening that otherwise leads to easy nucleation of shear bands which act like microcracks

Reciprocating wear mechanisms in a Zr-based bulk metallic glass

The dry sliding friction coefficient μ and the wear volume loss W, in a zirconium-based bulk metallic glass (BMG) under high-frequency (50 Hz) reciprocating conditions, were investigated with the objective of assessing the influence of free volume and crystallization on the wear behavior of amorphous metals. The BMG samples were annealed either below the glass transition temperature T<SUB>g</SUB> to induce structural relaxation and hence reduce the free volume that controls plasticity through shear-band formation or above T<SUB>g</SUB> to crystallize the amorphous BMG prior to wear testing. Results show that the wear behavior of both the as-cast and relaxed glasses was dominated by the oxidation of the surface layers. A sharp transition in the contact electrical resistance complemented by a marked increase in μ was noted. This was attributed to the formation of a thick tribo film with high oxygen concentration and its subsequent delamination. The μ values, before as well as after the transition, in the relaxed glasses were similar to those for the as-cast alloy. However, a gradual decrease in W with annealing temperature was observed. A good correlation between W and nanohardness was noted, implying that the intrinsic hardness in the BMGs controlled the wear rate