2,114 research outputs found
Single Molecule as a Local Acoustic Detector for Mechanical Oscillators
Biological and Soft Matter Physic
A new method based on noise counting to monitor the frontend electronics of the LHCb muon detector
A new method has been developed to check the correct behaviour of the
frontend electronics of the LHCb muon detector. This method is based on the
measurement of the electronic noise rate at different thresholds of the
frontend discriminator. The method was used to choose the optimal discriminator
thresholds. A procedure based on this method was implemented in the detector
control system and allowed the detection of a small percentage of frontend
channels which had deteriorated. A Monte Carlo simulation has been performed to
check the validity of the method
Measurement of Muon Capture on the Proton to 1% Precision and Determination of the Pseudoscalar Coupling g_P
The MuCap experiment at the Paul Scherrer Institute has measured the rate L_S
of muon capture from the singlet state of the muonic hydrogen atom to a
precision of 1%. A muon beam was stopped in a time projection chamber filled
with 10-bar, ultra-pure hydrogen gas. Cylindrical wire chambers and a segmented
scintillator barrel detected electrons from muon decay. L_S is determined from
the difference between the mu- disappearance rate in hydrogen and the free muon
decay rate. The result is based on the analysis of 1.2 10^10 mu- decays, from
which we extract the capture rate L_S = (714.9 +- 5.4(stat) +- 5.1(syst)) s^-1
and derive the proton's pseudoscalar coupling g_P(q^2_0 = -0.88 m^2_mu) = 8.06
+- 0.55.Comment: Updated figure 1 and small changes in wording to match published
versio
Measurement of the Rate of Muon Capture in Hydrogen Gas and Determination of the Proton's Pseudoscalar Coupling
The rate of nuclear muon capture by the proton has been measured using a new
experimental technique based on a time projection chamber operating in
ultra-clean, deuterium-depleted hydrogen gas at 1 MPa pressure. The capture
rate was obtained from the difference between the measured
disappearance rate in hydrogen and the world average for the decay
rate. The target's low gas density of 1% compared to liquid hydrogen is key to
avoiding uncertainties that arise from the formation of muonic molecules. The
capture rate from the hyperfine singlet ground state of the atom is
measured to be , from which the induced
pseudoscalar coupling of the nucleon, , is
extracted. This result is consistent with theoretical predictions for
that are based on the approximate chiral symmetry of QCD.Comment: submitted to Phys.Rev.Let
A Precision Measurement of Nuclear Muon Capture on 3He
The muon capture rate in the reaction mu- 3He -> nu + 3H has been measured at
PSI using a modular high pressure ionization chamber. The rate corresponding to
statistical hyperfine population of the mu-3He atom is (1496.0 +- 4.0) s^-1.
This result confirms the PCAC prediction for the pseudoscalar form factors of
the 3He-3H system and the nucleon.Comment: 13 pages, 6 PostScript figure
Muon capture by 3He nuclei followed by proton and deuteron production
The paper describes an experiment aimed at studying muon capture by
nuclei in pure and mixtures at various densities. Energy distributions of
protons and deuterons produced via and are measured for the
energy intervals MeV and MeV, respectively. Muon capture
rates, and are obtained using two different analysis methods. The
least--squares methods gives , . The Bayes theorem
gives ,
. The experimental
differential capture rates, and , are compared with theoretical
calculations performed using the plane--wave impulse approximation (PWIA) with
the realistic NN interaction Bonn B potential. Extrapolation to the full energy
range yields total proton and deuteron capture rates in good agreement with
former results.Comment: 17 pages, 13 figures, accepted for publication in PR
Performance of the Muon Identification at LHCb
The performance of the muon identification in LHCb is extracted from data
using muons and hadrons produced in J/\psi->\mu\mu, \Lambda->p\pi and
D^{\star}->\pi D0(K\pi) decays. The muon identification procedure is based on
the pattern of hits in the muon chambers. A momentum dependent binary
requirement is used to reduce the probability of hadrons to be misidentified as
muons to the level of 1%, keeping the muon efficiency in the range of 95-98%.
As further refinement, a likelihood is built for the muon and non-muon
hypotheses. Adding a requirement on this likelihood that provides a total muon
efficiency at the level of 93%, the hadron misidentification rates are below
0.6%.Comment: 17 pages, 10 figure
- …