Method of predicting ionization-type vacuum gage sensitivity for various gases

Sensitivity of gage for one gas can be correlated to its sensitivity for other gases by the ratio of gas ionization cross sections. Ionization cross sections which best correlate with gage sensitivites vary according to gage type and ionization cross section energy level

Sensitivity of hot-cathode ionization vacuum gages in several gases

Four hot-cathode ionization vacuum gages were calibrated in 12 gases. The relative sensitivities of these gages were compared to several gas properties. Ionization cross section was the physical property which correlated best with gage sensitivity. The effects of gage accelerating voltage and ionization-cross-section energy level were analyzed. Recommendations for predicting gage sensitivity according to gage type were made

Analysis of thermoelectric properties of high-temperature complex alloys of nickel-base, iron-base and cobalt-base groups

The thermoelectric properties alloys of the nickel-base, iron-base, and cobalt-base groups containing from 1% to 25% 106 chromium were compared and correlated with the following material characteristics: atomic percent of the principle alloy constituent; ratio of concentration of two constituents; alloy physical property (electrical resistivity); alloy phase structure (percent precipitate or percent hardener content); alloy electronic structure (electron concentration). For solid-solution-type alloys the most consistent correlation was obtained with electron concentration, for precipitation-hardenable alloys of the nickel-base superalloy group, the thermoelectric potential correlated with hardener content in the alloy structure. For solid-solution-type alloys, no problems were found with thermoelectric stability to 1000; for precipitation-hardenable alloys, thermoelectric stability was dependent on phase stability. The effects of the compositional range of alloy constituents on temperature measurement uncertainty are discussed

Particle creation in a f(R) theory with cosmological constraints

In this paper we study the creation of super-massive real scalar particles in the framework of a $f(R)=R-\beta/R^n$ modified gravity theory, with parameters constrained by observational data. The analysis is restrict to a homogeneous and isotropic flat and radiation dominated universe. We compare the results to the standard Einstein gravity with cosmological constant ($\Lambda CDM$ model), and we show that the total number density of created particles in the $f(R)$ model is very close to the standard case. Another interesting result is that the spectrum of created particles is $\beta$ independent at early times.Comment: To appear in the General Relativity and Gravitation. arXiv admin note: text overlap with arXiv:1108.334

Reliability analysis of forty-five strain-gage systems mounted on the first fan stage of a YF-100 engine

The reliability of 45 state-of-the-art strain gage systems under full scale engine testing was investigated. The flame spray process was used to install 23 systems on the first fan rotor of a YF-100 engine; the others were epoxy cemented. A total of 56 percent of the systems failed in 11 hours of engine operation. Flame spray system failures were primarily due to high gage resistance, probably caused by high stress levels. Epoxy system failures were principally erosion failures, but only on the concave side of the blade. Lead-wire failures between the blade-to-disk jump and the control room could not be analyzed