30,822 research outputs found

    Irradiate-anneal screening of total dose effects in semiconductor devices

    Get PDF
    An extensive investigation of irradiate-anneal (IRAN) screening against total dose radiation effects was carried out as part of a program to harden the Mariner Jupiter/Saturn 1977 (MJS'77) spacecraft to survive the Jupiter radiation belts. The method consists of irradiating semiconductor devices with Cobalt-60 to a suitable total dose under representative bias conditions and of separating the parts in the undesired tail of the distribution from the bulk of the parts by means of a predetermined acceptance limit. The acceptable devices are then restored close to their preirradiation condition by annealing them at an elevated temperature. IRAN was used when lot screen methods were impracticable due to lack of time, and when members of a lot showed a diversity of radiation response. The feasibility of the technique was determined by testing of a number of types of linear bipolar integrated circuits, analog switches, n-channel JFETS and bipolar transistors. Based on the results of these experiments a number of device types were selected for IRAN of flight parts in the MJS'77 spacecraft systems. The part types, screening doses, acceptance criteria, number of parts tested and rejected as well as the program steps are detailed

    Analytical and experimental study of reentrant stream crossed-field amplifiers Final report

    Get PDF
    Computer simulation and noise measurements of reentrant stream crossed-field amplifier

    Voyager electronic parts radiation program, volume 1

    Get PDF
    The Voyager spacecraft is subject to radiation from external natural space, from radioisotope thermoelectric generators and heater units, and from the internal environment where penetrating electrons generate surface ionization effects in semiconductor devices. Methods for radiation hardening and tests for radiation sensitivity are described. Results of characterization testing and sample screening of over 200 semiconductor devices in a radiation environment are summarized

    Voyager electronic parts radiation program. Volume 2: Test requirements and procedures

    Get PDF
    Documents are presented outlining the conditions and requirements of the test program. The Appendixes are as follows: appendix A -- Electron Simulation Radiation Test Specification for Voyager Electronic Parts and Devices, appendix B -- Electronic Piece-Part Testing Program for Voyager, appendix C -- Test Procedure for Radiation Screening of Voyager Piece Parts, appendix D -- Boeing In Situ Test Fixture, and appendix E -- Irradiate - Anneal (IRAN) Screening Documents

    Design considerations and test facilities for accelerated radiation effects testing

    Get PDF
    Test design parameters for accelerated dose rate radiation effects tests for spacecraft parts and subsystems used in long term mission (years) are detailed. A facility for use in long term accelerated and unaccelerated testing is described

    Numerical simulation of liquid sloshing in a partially filled container with inclusion of compressibility effects

    No full text
    A numerical scheme of study is developed to model compressible two-fluid flows simulating liquid sloshing in a partially filled tank. For a two-fluid system separated by an interface as in the case of sloshing, not only a Mach-uniform scheme is required, but also an effective way to eliminate unphysical numerical oscillations near the interface. By introducing a preconditioner, the governing equations expressed in terms of primitive variables are solved for both fluids (i.e. water, air, gas etc.) in a unified manner. In order to keep the interface sharp and to eliminate unphysical numerical oscillations in unsteady fluid flows, the non-conservative implicit Split Coefficient Matrix Method (SCMM) is modified to construct a flux difference splitting scheme in the dual time formulation. The proposed numerical model is evaluated by comparisons between numerical results and measured data for sloshing in an 80% filled rectangular tank excited at resonance frequency. Through similar comparisons, the investigation is further extended by examining sloshing flows excited by forced sway motions in two different rectangular tanks with 20% and 83% filling ratios. These examples demonstrate that the proposed method is suitable to capture induced free surface waves and to evaluate sloshing pressure loads acting on the tank walls and ceiling

    Design considerations for a LORAN-C timing receiver in a hostile signal to noise environment

    Get PDF
    The environment in which a LORAN-C Timing Receiver may function effectively depends to a large extent on the techniques utilized to insure that interfering signals within the pass band of the unit are neutralized. The baseline performance manually operated timing receivers is discussed and the basic design considerations and necessary parameters for an automatic unit utilizing today's technology are established. Actual performance data is presented comparing the results obtained from a present generation timing receiver against a new generation microprocessor controlled automatic acquisition receiver. The achievements possible in a wide range of signal to noise situations are demonstrated

    Assessment of LANDSAT for rangeland mapping, Rush Valley, Utah

    Get PDF
    The feasibility of using LANDSAT MSS (multispectral scanner) data to identify and map cover types for rangeland, and to determine comparative condition of the ecotypes was assessed. A supporting objective is to assess the utility of various forms of aerial photography in the process. If rangelands can be efficiently mapped with Landsat data, as supported by appropriate aerial photography and field data, then uniform standards of cover classification and condition may be applied across the rangelands of the state. Further, a foundation may be established for long-term monitoring of range trend, using the same satellite system over time

    Burden of podoconiosis in poor rural communities in Guliso woreda, western Ethiopia

    Get PDF
    Background. Podoconiosis is an environmental lymphoedema affecting people living and working barefoot on irritant red clay soil. Podoconiosis is relatively well described in southern Ethiopia, but remains neglected in other parts of the Ethiopian highlands. This study aimed to assess the burden of podoconiosis in rural communities in western Ethiopia. Methodology/Principal Findings. A cross-sectional study was conducted in Gulliso woreda (district), west Ethiopia. A household survey in the 26 rural kebeles (villages) of this district was conducted to identify podoconiosis patients and to measure disease prevalence. A more detailed study was done in six randomly selected kebeles to describe clinical features of the disease, patients’ experiences of foot hygiene, and shoe wearing practice. 1,935 cases of podoconiosis were registered, giving a prevalence of 2.8%. The prevalence was higher in those aged 15 – 64 years (5.2%) and in females than males (prevalence ratio 2.6:1). 90.3% of patients were in the 15 – 64 year age group. In the detailed study, 335 cases were interviewed and their feet assessed. The majority of patients were farmers, uneducated, and poor. Two-third of patients developed the disease before the age of thirty. Almost all patients (97.0%) had experienced adenolymphangitis (ALA - red, hot legs, swollen and painful groin) at least once during the previous year. Patients experienced an average of 5.5 ALA episodes annually, each of average 4.4 days, thus 24 working days were lost annually. The incidence of ALA in podoconiosis patients was higher than that reported for filariasis in other countries. Shoe wearing was limited mainly due to financial problems. Conclusions. We have documented high podoconiosis prevalence, frequent adenolymphangitis and high disease-related morbidity in west Ethiopia. Interventions must be developed to prevent, treat and control podoconiosis, one of the core neglected tropical diseases in Ethiopia

    The cost of systemic corticosteroid-induced morbidity in severe asthma : a health economic analysis

    Get PDF
    The study data-set was supported by the Respiratory Effectiveness Group through their academic partnership with Optimum Patient Care. Ciaran O'Neill was funded under a HRB Research Leader Award (RL/13/16).Peer reviewedPublisher PD
    corecore