Plucked piezoelectric bimorphs for knee-joint energy harvesting: modelling and experimental validation

The modern drive towards mobility and wireless devices is motivating intensive research in energy harvesting technologies. To reduce the battery burden on people, we propose the adoption of a frequency up-conversion strategy for a new piezoelectric wearable energy harvester. Frequency up-conversion increases efficiency because the piezoelectric devices are permitted to vibrate at resonance even if the input excitation occurs at much lower frequency. Mechanical plucking-based frequency up-conversion is obtained by deflecting the piezoelectric bimorph via a plectrum, then rapidly releasing it so that it can vibrate unhindered; during the following oscillatory cycles, part of the mechanical energy is converted into electrical energy. In order to guide the design of such a harvester, we have modelled with finite element methods the response and power generation of a piezoelectric bimorph while it is plucked. The model permits the analysis of the effects of the speed of deflection as well as the prediction of the energy produced and its dependence on the electrical load. An experimental rig has been set up to observe the response of the bimorph in the harvester. A PZT-5H bimorph was used for the experiments. Measurements of tip velocity, voltage output and energy dissipated across a resistor are reported. Comparisons of the experimental results with the model predictions are very successful and prove the validity of the model

Pizzicato excitation for wearable energy harvesters

A new technique based on the plucking of flexible piezoelectric material can be used to boost energy harvested to power portable electronic devices

Characterizing Subcritical Assemblies with Time of Flight Fixed by Energy Estimation Distributions

We present the Time of Flight Fixed by Energy Estimation (TOFFEE) as a measure of the fission chain dynamics in subcritical assemblies. TOFFEE is the time between correlated gamma rays and neutrons, subtracted by the estimated travel time of the incident neutron from its proton recoil. The measured subcritical assembly was the BeRP ball, a 4.482 kg sphere of alpha-phase weapons grade plutonium metal, which came in five configurations: bare, 0.5, 1, and 1.5 in iron, and 1 in nickel closed fitting shell reflectors. We extend the measurement with MCNPX-PoliMi simulations of shells ranging up to 6 inches in thickness, and two new reflector materials: aluminum and tungsten. We also simulated the BeRP ball with different masses ranging from 1 to 8 kg. A two-region and single-region point kinetics models were used to model the behavior of the positive side of the TOFFEE distribution from 0 to 100 ns. The single region model of the bare cases gave positive linear correlations between estimated and expected neutron decay constants and leakage multiplications. The two-region model provided a way to estimate neutron multiplication for the reflected cases, which correlated positively with expected multiplication, but the nature of the correlation (sub or super linear) changed between material types. Finally, we found that the areal density of the reflector shells had a linear correlation with the integral of the two-region model fit. Therefore, we expect that with knowledge of reflector composition, one could determine the shell thickness, or vice versa. Furthermore, up to a certain amount and thickness of the reflector, the two-region model provides a way of distinguishing bare and reflected plutonium assemblies.Comment: 13 pages, 16 figures, 3 table

Impact of low-input meadows on arthropod diversity at habitat and landscape level

In Switzerland, in order to preserve and enhance arthopod diversity in grassland ecosystems (among others), farmers had to convert at least 7 % of their land to ecological compensation areas – ECA. Major ECA are low input grassland, traditional orchards, hedges and wild flower strips. In this paper the difference in species assemblages of 3 arthropod groups, namely spiders, carabid beetles and butterflies between intensively managed and low input meadows is stressed by means of multivariate statistics. On one hand, the consequences of these differences are analysed at the habitat level to promote good practices for the arthropod diversity in grassland ecosystems. On the other hand, the contribution of each meadow type to the regional diversity is investigated to widen the analysis at the landscape level