1,215 research outputs found

    Validation of the Harvard Lyman-α in situ water vapor instrument: Implications for the mechanisms that control stratospheric water vapor

    Get PDF
    Building on previously published details of the laboratory calibrations of the Harvard Lyman-α photofragment fluorescence hygrometer (HWV) on the NASA ER-2 and WB-57 aircraft, we describe here the validation process for HWV, which includes laboratory calibrations and intercomparisons with other Harvard water vapor instruments at water vapor mixing ratios from 0 to 10 ppmv, followed by in-flight intercomparisons with the same Harvard hygrometers. The observed agreement exhibited in the laboratory and during intercomparisons helps corroborate the accuracy of HWV. In light of the validated accuracy of HWV, we present and evaluate a series of intercomparisons with satellite and balloon borne water vapor instruments made from the upper troposphere to the lower stratosphere in the tropics and midlatitudes. Whether on the NASA ER-2 or WB-57 aircraft, HWV has consistently measured about 1–1.5 ppmv higher than the balloon-borne NOAA/ESRL/GMD frost point hygrometer (CMDL), the NOAA Cryogenic Frost point Hygrometer (CFH), and the Microwave Limb Sounder (MLS) on the Aura satellite in regions of the atmosphere where water vapor is <10 ppmv. Comparisons in the tropics with the Halogen Occultation Experiment (HALOE) on the Upper Atmosphere Research Satellite show large variable differences near the tropopause that converge to ~10% above 460 K, with HWV higher. Results we show from the Aqua Validation and Intercomparison Experiment (AquaVIT) at the AIDA chamber in Karlsruhe do not reflect the observed in-flight differences. We illustrate that the interpretation of the results of comparisons between modeled and measured representations of the seasonal cycle of water entering the lower tropical stratosphere is dictated by which data set is used

    Demonstration of Feed-Forward Control for Linear Optics Quantum Computation

    Get PDF
    One of the main requirements in linear optics quantum computing is the ability to perform single-qubit operations that are controlled by classical information fed forward from the output of single photon detectors. These operations correspond to pre-determined combinations of phase corrections and bit-flips that are applied to the post-selected output modes of non-deterministic quantum logic devices. Corrections of this kind are required in order to obtain the correct logical output for certain detection events, and their use can increase the overall success probability of the devices. In this paper, we report on the experimental demonstration of the use of this type of feed-forward system to increase the probability of success of a simple non-deterministic quantum logic operation from approximately 1/4 to 1/2. This logic operation involves the use of one target qubit and one ancilla qubit which, in this experiment, are derived from a parametric down-conversion photon pair. Classical information describing the detection of the ancilla photon is fed-forward in real-time and used to alter the quantum state of the output photon. A fiber optic delay line is used to store the output photon until a polarization-dependent phase shift can be applied using a high speed Pockels cell

    An Algebraic Approach to Linear-Optical Schemes for Deterministic Quantum Computing

    Full text link
    Linear-Optical Passive (LOP) devices and photon counters are sufficient to implement universal quantum computation with single photons, and particular schemes have already been proposed. In this paper we discuss the link between the algebraic structure of LOP transformations and quantum computing. We first show how to decompose the Fock space of N optical modes in finite-dimensional subspaces that are suitable for encoding strings of qubits and invariant under LOP transformations (these subspaces are related to the spaces of irreducible unitary representations of U(N)). Next we show how to design in algorithmic fashion LOP circuits which implement any quantum circuit deterministically. We also present some simple examples, such as the circuits implementing a CNOT gate and a Bell-State Generator/Analyzer.Comment: new version with minor modification

    Two-photon imaging and quantum holography

    Get PDF
    It has been claimed that ``the use of entangled photons in an imaging system can exhibit effects that cannot be mimicked by any other two-photon source, whatever strength of the correlations between the two photons'' [A. F. Abouraddy, B. E. A. Saleh, A. V. Sergienko, and M. C. Teich, Phys. Rev. Lett. 87, 123602 (2001)]. While we believe that the cited statement is true, we show that the method proposed in that paper, with ``bucket detection'' of one of the photons, will give identical results for entangled states as for appropriately prepared classically correlated states.Comment: 4 pages, 2 figures, REVTe

    Role of entanglement in two-photon imaging

    Get PDF
    The use of entangled photons in an imaging system can exhibit effects that cannot be mimicked by any other two-photon source, whatever the strength of the correlations between the two photons. We consider a two-photon imaging system in which one photon is used to probe a remote (transmissive or scattering) object, while the other serves as a reference. We discuss the role of entanglement versus correlation in such a setting, and demonstrate that entanglement is a prerequisite for achieving distributed quantum imaging.Comment: 15 pages, 2 figure

    Implementation of a Toffoli Gate with Superconducting Circuits

    Full text link
    The quantum Toffoli gate allows universal reversible classical computation. It is also an important primitive in many quantum circuits and quantum error correction schemes. Here we demonstrate the realization of a Toffoli gate with three superconducting transmon qubits coupled to a microwave resonator. By exploiting the third energy level of the transmon qubit, the number of elementary gates needed for the implementation of the Toffoli gate, as well as the total gate time can be reduced significantly in comparison to theoretical proposals using two-level systems only. We characterize the performance of the gate by full process tomography and Monte Carlo process certification. The gate fidelity is found to be 68.5±0.568.5\pm0.5%.Comment: 4 pages, 5figure

    JWST Detects Neon Line Variability in a Protoplanetary Disk

    Full text link
    We report the first detection of variability in the mid-infrared neon line emission of a protoplanetary disk by comparing a JWST MIRI MRS spectrum of SZ Cha taken in 2023 with a Spitzer IRS SH spectrum of this object from 2008. We measure the [Ne III]-to-[Ne II] line flux ratio, which is a diagnostic of the high-energy radiation field, to distinguish between the dominance of EUV- or X-ray-driven disk photoevaporation. We find that the [Ne III]-to-[Ne II] line flux ratio changes significantly from ∼1.4\sim1.4 in 2008 to ∼0.2\sim0.2 in 2023. This points to a switch from EUV-dominated to X-ray-dominated photoevaporation of the disk. We present contemporaneous ground-based optical spectra of the Halpha emission line that show the presence of a strong wind in 2023. We propose that this strong wind prevents EUV radiation from reaching the disk surface while the X-rays permeate the wind and irradiate the disk. We speculate that at the time of the Spitzer observations, the wind was suppressed and EUV radiation reached the disk. These observations confirm that the MIR neon emission lines are sensitive to changes in high-energy radiation reaching the disk surface. This highlights the [Ne III]-to-[Ne II] line flux ratio as a tool to gauge the efficiency of disk photoevaporation in order to provide constraints on the planet-formation timescale. However, multiwavelength observations are crucial to interpret the observations and properly consider the star-disk connection.Comment: Accepted to ApJ

    Influence of Supercurrents on Low-Temperature Thermopower in Mesoscopic N/S Structures

    Full text link
    The thermopower of mesoscopic normal metal/superconductor structures has been measured at low temperatures. Effect of supercurrent present in normal part of the structure was studied in two cases: when it was created by applied external magnetic field and when it was applied directly using extra superconducting electrodes. Temperature and magnetic field dependencies of thermopower are compared to the numerical simulations based on the quasiclassical theory of the superconducting proximity effect.Comment: 21 pages, 12 figures. To be published in the proceedings of the ULTI conference organized in Lammi, Finland (2006

    Reactions of a Be-10 beam on proton and deuteron targets

    Get PDF
    The extraction of detailed nuclear structure information from transfer reactions requires reliable, well-normalized data as well as optical potentials and a theoretical framework demonstrated to work well in the relevant mass and beam energy ranges. It is rare that the theoretical ingredients can be tested well for exotic nuclei owing to the paucity of data. The halo nucleus Be-11 has been examined through the 10Be(d,p) reaction in inverse kinematics at equivalent deuteron energies of 12,15,18, and 21.4 MeV. Elastic scattering of Be-10 on protons was used to select optical potentials for the analysis of the transfer data. Additionally, data from the elastic and inelastic scattering of Be-10 on deuterons was used to fit optical potentials at the four measured energies. Transfers to the two bound states and the first resonance in Be-11 were analyzed using the Finite Range ADiabatic Wave Approximation (FR-ADWA). Consistent values of the spectroscopic factor of both the ground and first excited states were extracted from the four measurements, with average values of 0.71(5) and 0.62(4) respectively. The calculations for transfer to the first resonance were found to be sensitive to the size of the energy bin used and therefore could not be used to extract a spectroscopic factor.Comment: 16 Pages, 10 figure

    Biogeography of wild Arachis (Leguminosae): distribution and environmental characterisation.

    Get PDF
    Geographic Information System (GIS) tools are applied to a comprehensive database of 3514 records of wild Arachis species to assist in the conservation and utilisation of the species by: (a) determining the distributional range of species and their abundance; (b) characterising species environments; (c) determining the geographical distribution of species richness; and (d) determining the extent to which species are associated with river basins. Distributional ranges, climatic variables and indices of endemism for each species are tabulated. A. duranensis Krapov. & W.C. Gregory, the most probable donor of the A genome to the cultivated peanut, is distributed in close proximity to both the proposed donor of the B genome, A. ipaënsis, and the closest wild relative of the cultigen, A. monticola Krapov. & Rigoni. This region in the eastern foothills of the Andes and the adjoining chaco regions of Argentina, Bolivia and Paraguay, is a key area for further exploration for wild Arachis. An area of particularly high species richness occurs in the State of Mato Grosso, close to the Gran Pantanal in southwest Brazil. Seventy-one percent of the species were found to have some degree of association with water catchment areas, although in most cases it was difficult to determine whether this was due to climatic adaptation reasons, restricted dispersal due to geocarpic habit, or the role of watercourses as a principal dispersal agent. In only two cases could climatic adaptation be eliminated as the reason for species distribution
    • …
    corecore