Visible light-driven H2 production over highly dispersed Ruthenia on Rutile TiO2 nanorods

The immobilization of miniscule quantities of RuO2 (~0.1%) onto one-dimensional (1D) TiO2 nanorods (NRs) allows H2 evolution from water under visible light irradiation. Rod-like rutile TiO2 structures, exposing preferentially (110) surfaces, are shown to be critical for the deposition of RuO2 to enable photocatalytic activity in the visible region. The superior performance is rationalized on the basis of fundamental experimental studies and theoretical calculations, demonstrating that RuO2(110) grown as 1D nanowires on rutile TiO2(110), which occurs only at extremely low loads of RuO2, leads to the formation of a heterointerface that efficiently adsorbs visible light. The surface defects, band gap narrowing, visible photoresponse, and favorable upward band bending at the heterointerface drastically facilitate the transfer and separation of photogenerated charge carriers.Peer ReviewedPostprint (published version

Developing preventative strategies to mitigate thermal runaway in NMC532-graphite cylindrical cells using forensic simulations

The ubiquitous deployment of Li-ion batteries (LIBs) in more demanding applications has reinforced the need to understand the root causes of thermal runaway. Herein, we perform a forensic simulation of a real-case failure scenario, using localised heating of Li(Ni0.5Mn0.3Co0.2)O2 versus graphite 18650 cylindrical cells. This study determined the localised temperatures that would lead to venting and thermal runaway of these cells, as well as correlating the gases produced as a function of the degradation pathway. Catastrophic failure, involving melting (with internal cell temperatures exceeding 1085 °C), deformation and ejection of the cell componentry, was induced by locally applying 200 °C and 250 °C to a fully charged cell. Conversely, catastrophic failure was not observed when the same temperatures were applied to the cells at a lower state of charge (SOC). This work highlights the importance of SOC, chemistry and heat in driving the thermal failure mode of Ni-rich LIB cells, allowing for a better understanding of battery safety and the associated design improvements

High Reversibility of Lattice Oxygen Redox in Na-ion and Li-ion Batteries Quantified by Direct Bulk Probes of both Anionic and Cationic Redox Reactions

The reversibility and cyclability of anionic redox in battery electrodes hold the key to its practical employments. Here, through mapping of resonant inelastic X-ray scattering (mRIXS), we have independently quantified the evolving redox states of both cations and anions in Na2/3Mg1/3Mn2/3O2. The bulk-Mn redox emerges from initial discharge and is quantified by inverse-partial fluorescence yield (iPFY) from Mn-L mRIXS. Bulk and surface Mn activities likely lead to the voltage fade. O-K super-partial fluorescence yield (sPFY) analysis of mRIXS shows 79% lattice oxygen-redox reversibility during initial cycle, with 87% capacity sustained after 100 cycles. In Li1.17Ni0.21Co0.08Mn0.54O2, lattice-oxygen redox is 76% initial-cycle reversible but with only 44% capacity retention after 500 cycles. These results unambiguously show the high reversibility of lattice-oxygen redox in both Li-ion and Na-ion systems. The contrast between Na2/3Mg1/3Mn2/3O2 and Li1.17Ni0.21Co0.08Mn0.54O2 systems suggests the importance of distinguishing lattice-oxygen redox from other oxygen activities for clarifying its intrinsic properties.Comment: 33 pages, 8 Figures. Plus 14 pages of Supplementary Materials with 12 Figure

Adsorption-controlled growth of BiVO4 by molecular-beam epitaxy

Single-phase epitaxial films of the monoclinic polymorph of BiVO4 were synthesized by reactive molecular-beam epitaxy under adsorption-controlled conditions. The BiVO4 films were grown on (001) yttria-stabilized cubic zirconia (YSZ) substrates. Four-circle x-ray diffraction, scanning transmission electron microscopy (STEM), and Raman spectroscopy confirm the epitaxial growth of monoclinic BiVO4 with an atomically abrupt interface and orientation relationship (001)BiVO4 parallel to (001)(YSZ) with [100]BiVO4 parallel to [100](YSZ). Spectroscopic ellipsometry, STEM electron energy loss spectroscopy (STEM-EELS), and x-ray absorption spectroscopy indicate that the films have a direct band gap of 2.5 +/- 0.1 eV

Synergistic Degradation Mechanism in Single Crystal Ni-Rich NMC//Graphite Cells

Acknowledgments We acknowledge Diamond Light Source for time on beamline I09 under Proposals SI30201-1 and SI30201-2. This work is supported by the Faraday Institution under Grants FIRG044, FIRG024, and FIRG060.Peer reviewedPublisher PD

Accelerated optimization of transparent, amorphous zinc-tin-oxide thin films for optoelectronic applications

In the last decade, transparent amorphous oxide semiconductors (TAOS) have become an essential component of many electronics, from ultra high resolution displays to solar cells. However, these disordered oxides typically rely on expensive component metals like indium to provide sufficient charge carrier conduction, and their optoelectronic properties are not as predictable and well-described as those of traditional, crystalline semiconductors. Herein we report on our comprehensive study of the amorphous zinc-tin-oxide (a-ZTO) system for use as an indium-free, n-type TAOS. Using a combination of high-throughput co-deposition growth, high resolution spectral mapping, and atomistic calculations, we explain the development of disorder-related subgap states in SnO2-like a-ZTO and optical bandgap reduction in ZnO-like a-ZTO. In addition, we report on a composition-induced electronic and structural transition in ZnO-like a-ZTO resulting in an exceptionally high figure of merit, comparable to that of amorphous indium-gallium-zinc-oxide. Our results accelerate the development of a-ZTO and similar systems as indium-free TAOS materials