34,686 research outputs found
An ellipsometer with variable angle of incidence for studies in ultrahigh vacuum
The windows for the vacuum chamber are incorporated into the optical bench system by means of flexible bellows which allow measurements to be made over a large range of angle of incidence, one of which is chosen so that maximum sensitivity is obtained. The principal angle of incidence was determined, and straightforward corrections for strain birefringence of vacuum chamber windows were made. Atomically clean surfaces of sodium chloride and lithium fluoride were investigated to verify the performance of the system. Submonolayer and monolayer coverage of water on these surfaces could be detected. On cleavage planes of NaCl, a first monolayer of adsorbed water is complete at about one torr only
Capturing, using, and managing quality assurance knowledge for shuttle post-MECO flight design
Ascent initialization values used by the Shuttle's onboard computer for nominal and abort mission scenarios are verified by a six degrees of freedom computer simulation. The procedure that the Ascent Post Main Engine Cutoff (Post-MECO) group uses to perform quality assurance (QA) of the simulation is time consuming. Also, the QA data, checklists and associated rationale, though known by the group members, is not sufficiently documented, hindering transfer of knowledge and problem resolution. A new QA procedure which retains the current high level of integrity while reducing the time required to perform QA is needed to support the increasing Shuttle flight rate. Documenting the knowledge is also needed to increase its availability for training and problem resolution. To meet these needs, a knowledge capture process, embedded into the group activities, was initiated to verify the existing QA checks, define new ones, and document all rationale. The resulting checks were automated in a conventional software program to achieve the desired standardization, integrity, and time reduction. A prototype electronic knowledge base was developed with Macintosh's HyperCard to serve as a knowledge capture tool and data storage
The Arizona Radio Observatory CO Mapping Survey of Galactic Molecular Clouds: III. The Serpens Cloud in CO J=2-1 and 13CO J=2-1 Emission
We mapped 12CO and 13CO J = 2-1 emission over 1.04 square deg of the Serpens
molecular cloud with 38 arcsec spatial and 0.3 km/s spectral resolution using
the Arizona Radio Observatory Heinrich Hertz Submillimeter telescope. Our maps
resolve kinematic properties for the entire Serpens cloud. We also compare our
velocity moment maps with known positions of Young Stellar Objects (YSOs) and
1.1 mm continuum emission. We find that 12CO is self-absorbed and 13CO is
optically thick in the Serpens core. Outside of the Serpens core, gas appears
in filamentary structures having LSR velocities which are blue-shifted by up to
2 km/s relative to the 8 km/s systemic velocity of the Serpens cloud. We show
that the known Class I, Flat, and Class II YSOs in the Serpens core most likely
formed at the same spatial location and have since drifted apart. The spatial
and velocity structure of the 12CO line ratios implies that a detailed
3-dimensional radiative transfer model of the cloud will be necessary for full
interpretation of our spectral data. The starless cores region of the cloud is
likely to be the next site of star formation in Serpens.Comment: 41 pages, 15 figure
Correcting turnover correlations: A critique
In this article, the authors argue that turnover correlations do not need to be corrected. First, they maintain that correction formulas cannot correct for poor construct validity. Second, they discuss the original purposes of turnover correction formulas. Third, the authors describe the logical fallacies of correcting turnover correlations. Finally, they show why turnover correlations are not, as is widely believed, statistically limited to a maximum of .80
Radar Cross Section Studies/Compact Range Research
A summary is given of the achievements of NASA Grant NsG-1613 by Ohio State University from May 1, 1987 to April 30, 1988. The major topics covered are as follows: (1) electromagnetic scattering analysis; (2) indoor scattering measurement systems; (3) RCS control; (4) waveform processing techniques; (5) material scattering and design studies; (6) design and evaluation of design studies; and (7) antenna studies. Major progress has been made in each of these areas as verified by the numerous publications produced
Radar cross section studies
The ultimate goal is to generate experimental techniques and computer codes of rather general capability that would enable the aerospace industry to evaluate the scattering properties of aerodynamic shapes. Another goal involves developing an understanding of scattering mechanisms so that modification of the vehicular structure could be introduced within constraints set by aerodynamics. The development of indoor scattering measurement systems with special attention given to the compact range is another goal. There has been considerable progress in advancing state-of-the-art scattering measurements and control and analysis of the electromagnetic scattering from general targets
Topologies of nodal sets of random band limited functions
It is shown that the topologies and nestings of the zero and nodal sets of
random (Gaussian) band limited functions have universal laws of distribution.
Qualitative features of the supports of these distributions are determined. In
particular the results apply to random monochromatic waves and to random real
algebraic hyper-surfaces in projective space.Comment: 62 pages. Major revision following referee repor
Dynamics of transcendental Hénon maps-II
Transcendental Hénon maps are the natural extensions of the well investigated complex polynomial Hénon maps to the much larger class of holomorphic automorphisms. We prove here that transcendental Hénon maps always have non-trivial dynamical behavior, namely that they always admit both periodic and escaping orbits, and that their Julia sets are non-empty and perfect
- …