108 research outputs found
Bioactive and Tribological Behaviour of Atmospheric Plasma Sprayed Hydroxyapatite Coatings Reinforced by Lanthanum Oxide
Lanthanum oxide (La2O3) reinforced Hydroxyapatite coating was deposited by using unique gas tunnel type plasma spray torch under optimum spraying conditions. The phase and microstructure of the as-prepared powder and coatings were characterized by X-ray diffraction (XRD) and scanning electron microscope (SEM). In vitro bioactivity of the plasma sprayed lanthanum oxide reinforced hydroxyapatite coatings were investigated by using simulated body fluid solution. Results showed that there was onset of apatite formation on the surface of coatings after 15 days of immersion in SBF, while after 19 days of immersion in SBF it was indicated that a HCAp phase crystallized on their surface. Our studies demonstrate that lanthanum oxide reinforced hydroxyapatite coatings are potentially useful biomaterials with good tribological and bioactive behaviour
TL and OSL response of turquoise for dosimetric application
Turquoise is one of the amongst first gem stones used in jewelry and possessing cultural value since 2000 BC (at least). This work attempts characterize this stone scientifically using both thermally (TL) and optically stimulated luminescence (OSL) techniques. The experimental investigation included 1) the study of the natural TL and OSL signals, 2) the reproducibility of TL sensitivity over repeated irradiation and TL readout cycles, 3) dependence of sensitivity on annealing temperatures and 4) the TL and OSL dose response curves. The potential use of the TL and OSL techniques in determination of provenance, accidental dosimetry and probably to authenticity and dating purposes are then discussed.Publisher's Versio
Sol-Gel Derived Mg-Based Ceramic Scaffolds Doped with Zinc or Copper Ions: Preliminary Results on Their Synthesis, Characterization, and Biocompatibility
Glass-ceramic scaffolds containing Mg have shown recently the potential to enhance the proliferation, differentiation, and biomineralization of stem cells in vitro, property that makes them promising candidates for dental tissue regeneration. An additional property of a scaffold aimed at dental tissue regeneration is to protect the regeneration process against oral bacteria penetration. In this respect, novel bioactive scaffolds containing Mg2+ and Cu2+ or Zn2+, ions known for their antimicrobial properties, were synthesized by the foam replica technique and tested regarding their bioactive response in SBF, mechanical properties, degradation, and porosity. Finally their ability to support the attachment and long-term proliferation of Dental Pulp Stem Cells (DPSCs) was also evaluated. The results showed that conversely to their bioactive response in SBF solution, Zn-doped scaffolds proved to respond adequately regarding their mechanical strength and to be efficient regarding their biological response, in comparison to Cu-doped scaffolds, which makes them promising candidates for targeted dental stem cell odontogenic differentiation and calcified dental tissue engineering
Optical far infrared properties of FeS2
In this paper are presented the far-infrared reflectivity spectra for a cleaved FeS 2 sample measured at roam temperature and at 77 K
Optical far infrared properties of PtSb2
Far infrared reflection spectra measured at room temperature were used to investigate vibrational properties of PtSb2 single crystals. The experimental results were analyzed using a dielectric function taking into account the existence of plasmonionised impurity-phonon interactions. Together with strong coupling three infrared active lattice modes at about 143, 187 and 202 cm-1 were observed. These results were discussed with respect to calculated literature vibrational frequencies. Electrical properties of single crystal PtSb2 were also measured at room temperature
Far infrared properties of PbTe doped with Hg
Single crystal samples of PbTe doped with Hg were grown using the Bridgman method. Far infrared reflectivity spectra were measured at room temperature for samples with 0.5 at. % Hg; 0.9 at. % Hg and 1.4 at. % Hg. The plasma frequency decreased when PbTe was doped with Hg and it was lowest for the PbTe sample doped with 0.5 at. % Hg. The values of the determined optical free carrier mobility increased and was the highest for PbTe doped with 0.5 at. % Hg
Far infrared properties of sintered PbTe doped with boron
Far infrared spectra of sintered PbTe doped with boron were analyzed. The measured infrared spectra were fitted using a modified plasmon-phonnon interaction model with two additional oscillators (at about 195 cm-1 and 285 cm-1) representing local B-impurity modes. The obtained results were compared with previously published data for a single crystal PbTe sample doped with boron
Far infrared and photoacoustic characterization of iodine doped PbTe
Single crystal samples of PbTe doped with PbI2 were made using the Bridgman technique. Far infrared reflectivity diagrams of PbTe doped with 0.4 at% and 0.6 at% Iodine were measured and numerically analyzed. A plasma resonance at about 650 cm(-1) with the reflectivity minima very close to zero was observed for both samples. Thermal diffusivity was determined for the same samples using the photoacoustic method with a transmission detection configuration and the values of the minority free carrier (holes) mobility were calculated
- ā¦