Reaction Dynamics for the Systems 7Be,8B + 208Pb at Coulomb Barrier Energies

In this contribution we describe the first results obtained for the investigation of the elastic scattering process in the reactions induced by the Radioactive Ion Beams 7Be and 8B on a 208Pb target at Coulomb barrier energies. The experimental data were analyzed within the framework of the optical model in order to extract the total reaction cross section. The comparison with data available in literature for reactions induced on 208Pb by light ions in the mass range A = 6-8 shows that the loosely-bound 8B has the largest reactivity

High-rate deposition of microcrystalline silicon in a large-area PECVD reactor and integration in tandem solar cells

We study the high-rate deposition of microcrystalline silicon in a large-area plasma-enhanced chemical-vapor-deposition (PECVD) reactor operated at 40.68 MHz, in the little-explored process conditions of high-pressure and high-silane concentration and depletion. Due to the long gas residence time in this process, the silane gas is efficiently depleted using moderate feed-in power density, thus facilitating up-scaling of the process to large surfaces. As observed in more traditional deposition processes, the deposition rate and performance of device-quality material are limited by the inter-electrode gap of the reactor. We significantly increase the cell performances by reducing this gap. X-ray diffractometry (XRD) and secondary ion mass spectroscopy (SIMS) are used to characterize the microcrystalline material deposited in the modified reactor at a rate of 1 nm/s. Comparison with a microcrystalline process at a low deposition rate demonstrates that the crystallographic orientation of the absorbing layer of the cell and the concentrations of contaminants are strongly correlated and dependent on the process. We use microcrystalline cells with absorber layer grown at a rate of 1 nm/s integrated as bottom cells in amorphous-microcrystalline (micromorph) tandem solar cells using the superstrate configuration. We report an initial efficiency of 10.8% (9.6% stabilized) for a tandem cell with 1.2 cm2 surface. Copyright # 2010 John Wiley & Sons, Ltd

Reaction dynamics induced by the radioactive ion beam 7Be on medium-mass and heavy targets

We studied the reaction dynamics induced at Coulomb barrier energies by the weakly-bound Radioactive Ion Beam 7Be (Sα = 1.586 MeV) on medium-mass (58Ni) and heavy (208Pb) targets. The experiments were performed at INFN-LNL (Italy), where a 2-3×105 pps 7Be secondary beam was produced with the RIB in-flight facility EXOTIC. Charged reaction products were detected by means of high-granularity silicon detectors in rather wide angular ranges. The contribution presents an up-to-date status of the data analysis and theoretical interpretation for both systems.European Commission, Seventh Framework Programme 60037

Impact of secondary gas-phase reactions on microcrystalline silicon solar cells deposited at high rate

The role of secondary gas-phase reactions during plasma-enhanced chemical vapor deposition of microcrystalline silicon is a controversial subject. In this paper, we show that the enhancement of such reactions is associated with the improvement of material properties of absorber layers deposited at high constant rate. We detect powder, a product of secondary gas-phase reactions, via infrared laser absorption spectroscopy, laser light scattering, and optical emission spectroscopy. As the powder formation is increased, we measure a systematic improvement of device performance. This demonstrates that secondary gas-phase reactions are not detrimental to the material quality of microcrystalline silicon deposited at high rate. © 2010 American Institute of Physics

Oscillations above the barrier in the fusion of 28Si + 28Si

Fusion cross sections of 28Si + 28Si have been measured in a range above the barrier with a very small energy step (DeltaElab = 0.5 MeV). Regular oscillations have been observed, best evidenced in the first derivative of the energy-weighted excitation function. For the first time, quite different behaviors (the appearance of oscillations and the trend of sub-barrier cross sections) have been reproduced within the same theoretical frame, i.e., the coupled-channel model using the shallow M3Y+repulsion potential. The calculations suggest that channel couplings play an important role in the appearance of the oscillations, and that the simple relation between a peak in the derivative of the energy-weighted cross section and the height of a centrifugal barrier is lost, and so is the interpretation of the second derivative of the excitation function as a barrier distribution for this system, at energies above the Coulomb barrier.Comment: submitted to Physics Letters

Electronics design of the RPC system for the OPERA muon spectrometer

The present document describes the front-end electronics of the RPC system that instruments the magnet muon spectrometer of the OPERA experiment. The main task of the OPERA spectrometer is to provide particle tracking information for muon identification and simplify the matching between the Precision Trackers. As no trigger has been foreseen for the experiment, the spectrometer electronics must be self-triggered with single-plane readout capability. Moreover, precision time information must be added within each event frame for off-line reconstruction. The read-out electronics is made of three different stages: the Front-End Boards (FEBs) system, the Controller Boards (CBs) system and the Trigger Boards(TBs) system. The FEB system provides discrimination of the strip incoming signals; a FAST-OR output of the input signals is also available for trigger plane signal generation. FEB signals are acquired by the CB system that provides the zero suppression and manages the communication to the DAQ and Slow Control. A Trigger Board allows to operate in both self-trigger mode (the FEB’s FAST-OR signal starts the plane acquisition) or in external-trigger mode (different conditions can be set on the FAST-OR signals generated from different planes)

LATEST DEVELOPMENTS ON MICROMORPH TANDEM CELLS AT IMT

The latest developments on micromorph tandem cells in small area laboratory and large area industrial PE-CVD systems are reviewed. We report on a 13.3% initial efficiency micromorph tandem cell deposited in our small area system. The development of an in-situ silicon oxide based intermediate reflector layer (SOIR) was essential in order to achieve such high efficiencies. We describe its detailed material structure and discuss optical management aspects for different cell configurations. In our large area industrial R&D reactor the highest efficiency so far obtained is a 11.0% initial efficiency micromorph tandem cell. We discuss in detail the role of pressure and silane depletion on the cell parameters of single junction microcrystalline cells and present efficiency trends decreasing from 8.2% to 7.0% with deposition rates increasing from 0.3 nm/s to 1.2 nm/s

Development of Micromorph Cells in Large-Area Industrial Reactor

The influences of the deposition pressure and silane depletion on the efficiency of single-junction microcrystalline silicon solar cells has been investigated. The efficiency is found to correlate with the ion energy which affects the density of states in the absorber material. Cell with efficiency of 7.3% at a deposition rate of 1 nm/s, and, respectively, 7.8% at 0.35 nm/s were deposited in R&D KAI M industrial reactor. Silicon oxide based intermediate reflector layers were developed in KAI reactor for incorporation in micromorph devices. Material with an index of refraction of 1.7 at 600 nm and low lateral conductivity were deposited. Micromorph devices incorporating these intermediate reflector layers were fabricated with initial efficiency of 12.3% at a deposition rate of 0.35 nm/s and 10.8% at 1 nm/s

Fusion of 28Si + 28Si: oscillations above the barrier and the behavior down to 1μb

Fusion excitation functions of light heavy-ion systems show oscillatory structures above the Coulomb barrier, caused by resonances or due to the penetration of successive centrifugal barriers well separated in energy. In heavier systems, the amplitude of oscillations decreases and the peaks get nearer to each other. This makes the measurements very challenging. We have performed a first experiment for 28Si + 28Si, by measuring fusion cross sections (σ) in an energy range of ≃15 MeV above the barrier, with a small ΔElab = 0.5 MeV step. Three regular oscillations are clearly observed, which are best revealed by plotting the energy-weighted derivative of the excitation function. The excitation function has been recently measured down to cross sections ≤1μb with larger energy steps. Coupled-channel (CC) calculations based on a shallow potential in the entrance channel are able to reproduce the oscillations. A further analysis will provide a stringent test for the calculations, in particular for the choice of the ion-ion potential, because the subbarrier excitation function has to be reproduced as well. Coupled-channel (CC) calculations based on a shallow potential in the entrance channel are able to reproduce the oscillations. A further analysis will provide a stringent test for the calculations, in particular for the choice of the ion-ion potential, because the subbarrier excitation function has to be reproduced as well