Properties of superconducting MgB_2 wires: "in-situ" versus "ex-situ" reaction technique

We have fabricated a series of iron-sheathed superconducting wires prepared by the powder-in-tube technique from (MgB_2)_{1-x}:(Mg+2B)_x initial powder mixtures taken with different proportions, so that x varies from 0 to 1. It turned out that "ex-situ" prepared wire (x = 0) has considerable disadvantages compared to all the other wires in which "in-situ" assisted (0 < x < 1) or pure "in-situ" (x = 1) preparation was used due to weaker inter-grain connectivity. As a result, higher critical current densities J_c were measured over the entire range of applied magnetic fields B_a for all the samples with x > 0. Pinning of vortices in MgB_2 wires is shown to be due to grain boundaries. J_c(B_a) behavior is governed by an interplay between the transparency of grain boundaries and the amount of "pinning" grain boundaries. Differences between thermo-magnetic flux-jump instabilities in the samples and a possible threat to practical applications are also discussed.Comment: To be published in Supercond. Sci. Technol. (2003), in pres

Future wave climate over the west-European shelf seas

In this paper, we investigate changes in the wave climate of the west-European shelf seas under global warming scenarios. In particular, climate change wind fields corresponding to the present (control) time-slice 1961–2000 and the future (scenario) time-slice 2061–2100 are used to drive a wave generation model to produce equivalent control and scenario wave climate. Yearly and seasonal statistics of the scenario wave climates are compared individually to the corresponding control wave climate to identify relative changes of statistical significance between present and future extreme and prevailing wave heights. Using global, regional and linked global–regional wind forcing over a set of nested computational domains, this paper further demonstrates the sensitivity of the results to the resolution and coverage of the forcing. It suggests that the use of combined forcing from linked global and regional climate models of typical resolution and coverage is a good option for the investigation of relative wave changes in the region of interest of this study. Coarse resolution global forcing alone leads to very similar results over regions that are highly exposed to the Atlantic Ocean. In contrast, fine resolution regional forcing alone is shown to be insufficient for exploring wave climate changes over the western European waters because of its limited coverage. Results obtained with the combined global–regional wind forcing showed some consistency between scenarios. In general, it was shown that mean and extreme wave heights will increase in the future only in winter and only in the southwest of UK and west of France, north of about 44–45° N. Otherwise, wave heights are projected to decrease, especially in summer. Nevertheless, this decrease is dominated by local wind waves whilst swell is found to increase. Only in spring do both swell and local wind waves decrease in average height

Josephson scanning tunneling microscopy

We propose a set of scanning tunneling microscopy experiments in which the surface of superconductor is scanned by a superconducting tip. Potential capabilities of such experimental setup are discussed. Most important anticipated results of such an experiment include the position-resolved measurement of the superconducting order parameter and the possibility to determine the nature of the secondary component of the order parameter at the surface. The theoretical description based on the tunneling Hamiltonian formalism is presented.Comment: 6 pages, 7 figures, submitted to Phys. Rev.

Direct visualization of iron sheath shielding effect in MgB_2 superconducting wires

Local magneto-optical imaging and global magnetization measurement techniques were used in order to visualize shielding effects in the superconducting core of MgB_2 wires sheathed by ferromagnetic iron (Fe). The magnetic shielding can provide a Meissner-like state in the superconducting core in applied magnetic fields up to ~1T. The maximum shielding fields are shown to correlate with the saturation fields of magnetization in Fe-sheaths. The shielding has been found to facilitate the appearance of an overcritical state, which is capable of achieving a critical current density (J_c) in the core which is larger than J_c in the same wire without the sheath by a factor of ~2. Other effects caused by the magnetic interaction between the sheath and the superconducting core are discussed.Comment: 4 pages, 3 figure

Superconducting screening on different length scales in high-quality bulk MgB2 superconductor

High quality bulk MgB2 exhibit a structure of voids and agglomeration of crystals on different length-scales. Because of this, the superconducting currents percolate between the voids in the ensuing structure. Magnetic measurements reveal that the superconducting currents circulate on at least three different length-scales, of ~1 micrometre, ~10 micrometre and whole of the sample (~millimetre). Each of these screenings contributes to the measured irreversible magnetic moment (Dm). The analysis of the field dependence of Dm for samples of subsequently decreasing size showed that the critical current obtained using the simple critical state model is erroneous. This leads to the artefact of the sample size-dependent critical current and irreversibility field. Our data analysis enables the separation of the contribution of each of the screening currents to Dm. The field dependence of each of the currents follows a stretched exponential form. The currents flowing around whole of the sample give a dominant contribution to Dm in the intermediate fields (1T < H < 4T at 20K) and they can be used to obtain the value of Jc from critical state model, which corresponds to the transport Jc

The origin of paramagnetic magnetization in field-cooled YBa2Cu3O7 films

Temperature dependences of the magnetic moment have been measured in YBa_2Cu_3O_{7-\delta} thin films over a wide magnetic field range (5 <= H <= 10^4 Oe). In these films a paramagnetic signal known as the paramagnetic Meissner effect has been observed. The experimental data in the films, which have strong pinning and high critical current densities (J_c ~ 2 \times 10^6 A/cm^2 at 77 K), are quantitatively shown to be highly consistent with the theoretical model proposed by Koshelev and Larkin [Phys. Rev. B 52, 13559 (1995)]. This finding indicates that the origin of the paramagnetic effect is ultimately associated with nucleation and inhomogeneous spatial redistribution of magnetic vortices in a sample which is cooled down in a magnetic field. It is also shown that the distribution of vortices is extremely sensitive to the interplay of film properties and the real experimental conditions of the measurements.Comment: RevTex, 8 figure

Measurement of an Exceptionally Weak Electron-Phonon Coupling on the Surface of the Topological Insulator Bi2_2Se3_3 Using Angle-Resolved Photoemission Spectroscopy

Gapless surface states on topological insulators are protected from elastic scattering on non-magnetic impurities which makes them promising candidates for low-power electronic applications. However, for wide-spread applications, these states should have to remain coherent at ambient temperatures. Here, we studied temperature dependence of the electronic structure and the scattering rates on the surface of a model topological insulator, Bi$_2$Se$_3$, by high resolution angle-resolved photoemission spectroscopy. We found an extremely weak broadening of the topological surface state with temperature and no anomalies in the state's dispersion, indicating exceptionally weak electron-phonon coupling. Our results demonstrate that the topological surface state is protected not only from elastic scattering on impurities, but also from scattering on low-energy phonons, suggesting that topological insulators could serve as a basis for room temperature electronic devices.Comment: published version, 5 pages, 4 figure

Microscopic origin of local moments in a zinc-doped high-TcT_{c} superconductor

The formation of a local moment around a zinc impurity in the high-$T_{c}$ cuprate superconductors is studied within the framework of the bosonic resonating-valence-bond (RVB) description of the $t-J$ model. A topological origin of the local moment has been shown based on the phase string effect in the bosonic RVB theory. It is found that such an $S=1/2$ moment distributes near the zinc in a form of staggered magnetic moments at the copper sites. The corresponding magnetic properties, including NMR spin relaxation rate, uniform spin susceptibility, and dynamic spin susceptibility, etc., calculated based on the theory, are consistent with the experimental measurements. Our work suggests that the zinc substitution in the cuprates provide an important experimental evidence for the RVB nature of local physics in the original (zinc free) state.Comment: The topological reason of local moment formation is given. One figure is adde

A new approach to the inverse problem for current mapping in thin-film superconductors

A novel mathematical approach has been developed to complete the inversion of the Biot-Savart law in one- and two-dimensional cases from measurements of the perpendicular component of the magnetic field using the well-developed Magneto-Optical Imaging technique. Our approach, especially in the 2D case, is provided in great detail to allow a straightforward implementation as opposed to those found in the literature. Our new approach also refines our previous results for the 1D case [Johansen et al., Phys. Rev. B 54, 16264 (1996)], and streamlines the method developed by Jooss et al. [Physica C 299, 215 (1998)] deemed as the most accurate if compared to that of Roth et al. [J. Appl. Phys. 65, 361 (1989)]. We also verify and streamline the iterative technique, which was developed following Laviano et al. [Supercond. Sci. Technol. 16, 71 (2002)] to account for in-plane magnetic fields caused by the bending of the applied magnetic field due to the demagnetising effect. After testing on magneto-optical images of a high quality YBa2Cu3O7 superconducting thin film, we show that the procedure employed is effective

Effect of the sample geometry on the second magnetization peak in single crystalline Ba0.63_{0.63}K0.37_{0.37}BiO3_3 thick film

Magnetization hysteresis loop $M(H)$ measurements performed on a single crystalline Ba$_{0.63}$K$_{0.37}$BiO$_3$ superconducting thick film reveal pronounced sample geometry dependence of the "second magnetization peak" (SMP), i.e. a maximum in the width of $M(H)$ occurring at the field $H_{\rm SMP}(T)$. In particular, it is found that the SMP vanishes decreasing the film dimension. We argue that the observed sample geometry dependence of the SMP cannot be accounted for by models which assume a vortex pinning enhancement as the origin of the SMP. Our results can be understood considering the thermomagnetic instability effect and/or non-uniform current distribution at $H < H_{\rm SMP}$ in large enough samples.Comment: 8 pages 3 figure