Omnidirectional and broadband absorption enhancement from trapezoidal Mie resonators in semiconductor metasurfaces

Light trapping in planar ultrathin-film solar cells is limited due to a small number of optical modes available in the thin-film slab. A nanostructured thin-film design could surpass this limit by providing broadband increase in the local density of states in a subwavelength volume and maintaining efficient coupling of light. Here we report a broadband metasurface design, enabling efficient and broadband absorption enhancement by direct coupling of incoming light to resonant modes of subwavelength-scale Mie nanoresonators defined in the thin-film active layer. Absorption was investigated both theoretically and experimentally in prototypes consisting of lithographically patterned, two-dimensional periodic arrays of silicon nanoresonators on silica substrates. A crossed trapezoid resonator shape of rectangular cross section is used to excite broadband Mie resonances across the visible and near-IR spectra. Our numerical simulations, optical absorption measurements and photocurrent spectral response measurements demonstrate that crossed trapezoidal Mie resonant structures enable angle-insensitive, broadband absorption. A short circuit current density of 12.0 mA/cm2 is achieved in 210 nm thick patterned Si films, yielding a 4-fold increase compared to planar films of the same thickness. It is suggested that silicon metasurfaces with Mie resonator arrays can provide useful insights to guide future ultrathin-film solar cell designs incorporating nanostructured thin active layers.Comment: 15 pages, 5 figure

Measurement of minority-carrier diffusion lengths using wedge-shaped semiconductor photoelectrodes

Measurement of the photocurrent as a function of the thickness of a light absorber has been shown herein both theoretically and experimentally to provide a method for determination of the minority-carrier diffusion length of a sample. To perform the measurement, an illuminated spot of photons with an energy well above the band gap of the material was scanned along the thickness gradient of a wedge-shaped, rear-illuminated semiconducting light absorber. Photogenerated majority carriers were collected through a back-side transparent ohmic contact, and a front-side liquid or Schottky junction collected the photogenerated minority carriers. Calculations showed that the diffusion length could be evaluated from the exponential variation in photocurrent as a function of the thickness of the sample. Good agreement was observed between experiment and theory for a solid-state silicon Schottky junction measured using this method. As an example for the application of the technique to semiconductor/liquid-junction photoelectrodes, the minority-carrier diffusion length was determined for graded thickness, sputtered tungsten trioxide and polished bismuth vanadate films under back-illumination in contact with an aqueous electrolyte. This wedge technique does not require knowledge of the spectral absorption coefficient, doping, or surface recombination velocity of the sample

Dynamic beam steering with all-dielectric electro-optic III-V multiple-quantum-well metasurfaces

Tunable metasurfaces enable dynamical control of the key constitutive properties of light at a subwavelength scale. To date, electrically tunable metasurfaces at near-infrared wavelengths have been realized using free carrier modulation, and switching of thermo-optical, liquid crystal and phase change media. However, the highest performance and lowest loss discrete optoelectronic modulators exploit the electro-optic effect in multiple-quantum-well heterostructures. Here, we report an all-dielectric active metasurface based on electro-optically tunable III–V multiple-quantum-wells patterned into subwavelength elements that each supports a hybrid Mie-guided mode resonance. The quantum-confined Stark effect actively modulates this volumetric hybrid resonance, and we observe a relative reflectance modulation of 270% and a phase shift from 0° to ~70°. Additionally, we demonstrate beam steering by applying an electrical bias to each element to actively change the metasurface period, an approach that can also realize tunable metalenses, active polarizers, and flat spatial light modulators

On the Potential of Optical Nanoantennas for Visibly Transparent Solar Cells

This study aims to determine the maximum possible energy conversion efficiency of visibly transparent solar cells using the detailed balance limit (also known as the Shockley–Queisser limit) and compare it to the efficiency of traditional single-junction solar cells. To achieve this, a new optical nanoantenna has been designed to absorb incoming light selectively, enhancing the average visible transmission while maintaining high absorption in the infrared and UV regions. The color appearance of the antennas has also been evaluated through colorimetrical characterization. Our findings indicate that it is possible to achieve high average visible transparency and energy conversion efficiency of over 80 and 18%, respectively, by carefully selecting semiconductor materials. Such solar cells are versatile enough to be integrated seamlessly into smart windows, agrivoltaic concepts in open and protected cultivation, mobile devices, and appliances without compromising their appearance or functionality. The dimensions and optics of the proposed antennas and visibly transparent solar cells have been thoroughly discussed

Resonant Thermoelectric Nanophotonics

Photodetectors are typically based either on photocurrent generation from electron–hole pairs in semiconductor structures or on bolometry for wavelengths that are below bandgap absorption. In both cases, resonant plasmonic and nanophotonic structures have been successfully used to enhance performance. Here, we show subwavelength thermoelectric nanostructures designed for resonant spectrally selective absorption, which creates large localized temperature gradients even with unfocused, spatially uniform illumination to generate a thermoelectric voltage. We show that such structures are tunable and are capable of wavelength-specific detection, with an input power responsivity of up to 38 V W^(–1), referenced to incident illumination, and bandwidth of nearly 3 kHz. This is obtained by combining resonant absorption and thermoelectric junctions within a single suspended membrane nanostructure, yielding a bandgap-independent photodetection mechanism. We report results for both bismuth telluride/antimony telluride and chromel/alumel structures as examples of a potentially broader class of resonant nanophotonic thermoelectric materials for optoelectronic applications such as non-bandgap-limited hyperspectral and broadband photodetectors

A scanning probe investigation of the role of surface motifs in the behavior of p-WSe_2 photocathodes

The spatial variation in the photoelectrochemical performance for the reduction of an aqueous one-electron redox couple, Ru(NH_3)_6^(3+/2+), and for the evolution of H_2(g) from 0.5 M H_2SO_4(aq) at the surface of bare or Pt-decorated p-type WSe_2 photocathodes has been investigated in situ using scanning photocurrent microscopy (SPCM). The measurements revealed significant differences in the charge-collection performance (quantified by the values of external quantum yields, Φ_(ext)) on various macroscopic terraces. Local spectral response measurements indicated a variation in the local electronic structure among the terraces, which was consistent with a non-uniform spatial distribution of sub-band-gap states within the crystals. The photoconversion efficiencies of Pt-decorated p-WSe_2 photocathodes were greater for the evolution of H_2(g) from 0.5 M H_2SO_4 than for the reduction of Ru(NH_3)_6^(3+/2+), and terraces that exhibited relatively low values of Φ_(ext) for the reduction of Ru(NH_3)_6^(3+/2+) could in some cases yield values of Φ_(ext) for the evolution of H_2(g) comparable to the values of Φ_(ext) yielded by the highest-performing terraces. Although the spatial resolution of the techniques used in this work frequently did not result in observation of the effect of edge sites on photocurrent efficiency, some edge effects were observed in the measurements; however the observed edge effects differed among edges, and did not appear to determine the performance of the electrodes

Trommelsprachen:languages of drums

The dynamic control of light emission from quantum dots is generally controlled via optical or electrical pumping. Here, Lu et al. electrically control the local density of states around a quantum dot to modulate its visible light emission properties

Prognosis for Improvement During Acute Rehabilitation as Measured by the Western Aphasia Battery

TB

Resonant Thermoelectric Nanophotonics

Photodetectors are typically based either on photocurrent generation from electron–hole pairs in semiconductor structures or on bolometry for wavelengths that are below bandgap absorption. In both cases, resonant plasmonic and nanophotonic structures have been successfully used to enhance performance. Here, we show subwavelength thermoelectric nanostructures designed for resonant spectrally selective absorption, which creates large localized temperature gradients even with unfocused, spatially uniform illumination to generate a thermoelectric voltage. We show that such structures are tunable and are capable of wavelength-specific detection, with an input power responsivity of up to 38 V W^(–1), referenced to incident illumination, and bandwidth of nearly 3 kHz. This is obtained by combining resonant absorption and thermoelectric junctions within a single suspended membrane nanostructure, yielding a bandgap-independent photodetection mechanism. We report results for both bismuth telluride/antimony telluride and chromel/alumel structures as examples of a potentially broader class of resonant nanophotonic thermoelectric materials for optoelectronic applications such as non-bandgap-limited hyperspectral and broadband photodetectors