Flow of low viscosity Boger fluids through a microfluidic hyperbolic contraction

In this work we focus on the development of low viscosity Boger fluids and assess their elasticity analyzing the flow through a microfluidic hyperbolic contraction. Rheological tests in shear and extensional flows were carried out in order to evaluate the effect of the addition of a salt (NaCl) to dilute aqueous solutions of polyacrylamide at 400, 250, 125 and 50 ppm (w/w). The rheological data showed that when 1% (w/w) of NaCl was added, a significant decrease of the shear viscosity curve was observed, and a nearly constant shear viscosity was found for a wide range of shear rates, indicating Boger fluid behavior. The relaxation times, measured using a capillary break-up extensional rheometer (CaBER), decreased for lower polymer concentrations, and with the addition of NaCl. Visualizations of these Boger fluids flowing through a planar microfluidic geometry containing a hyperbolic contraction, which promotes a nearly uniform extension rate at the centerline of the geometry, was important to corroborate their degree of elasticity. Additionally, the quantification of the vortex growth upstream of the hyperbolic contraction was used with good accuracy and reproducibility to assess the relaxation time for the less concentrated Boger fluids, for which CaBER measurements are difficult to perform

Shear viscosity and nonlinear behaviour of whole blood under large amplitude oscillatory shear

We investigated experimentally the rheological behavior of whole human blood subjected to large amplitude oscillatory shear under strain control to assess its nonlinear viscoelastic response. In these rheological tests, the shear stress response presented higher harmonic contributions, revealing the nonlinear behavior of human blood that is associated with changes in its internal microstructure. For the rheological conditions investigated, intra-cycle strain-stiffening and intra-cycle shear-thinning behavior of the human blood samples were observed and quantified based on the Lissajous–Bowditch plots. The results demonstrated that the dissipative nature of whole blood is more intense than its elastic component. We also assessed the effect of adding EDTA anticoagulant on the shear viscosity of whole blood subjected to steady shear flow. We found that the use of anticoagulant in appropriate concentrations did not influence the shear viscosity and that blood samples without anticoagulant preserved their rheological characteristics approximately for up to 8 minutes before coagulation became significant

Nanogel formation of polymer solutions flowing through porous media

A gelation process was seen to occur when Boger fluids made from aqueous solutions of polyacrylamide (PAA) and NaCl flowed through porous media with certain characteristics. As these viscoelastic fluids flow through a porous medium, the pressure drop across the bed varies linearly with the flow rate, as also happens with Newtonian fluids. Above a critical flow rate, elastic effects set in and the pressure drop grows above the low-flow-rate linear regime. Increasing further the flow rate, a more dramatic increase in the slope of the pressure drop curve can be observed as a consequence of nanogel formation. In this work, we discuss the reasons for this gelation process based on our measurements using porous media of different sizes, porosity and chemical composition. Additionally, the rheological properties of the fluids were investigated for shear and extensional flows. The fluids were also tested as they flowed through different microfluidic analogues of the porous media. The results indicate that the nanogel inception occurs with the adsorption of PAA molecules on the surface of the porous media particles that contain silica on their surfaces. Subsequently, if the interparticle space is small enough a jamming process occurs leading to flow-induced gel formation

On the effect of contraction ratio in viscoelastic flow through abrupt contractions

A numerical study of the creeping flow of a PTT fluid through planar sudden contractions was carried out to quantify the effect of contraction ratio upon the flow characteristics (streamlines and size and intensity of recirculation vortices). The relevant governing equations were solved with a finite volume method embodying a new high-resolution scheme (Alves et al. [Int. J. Numer. Meth. Fluids 41 (2003) 47]) for the discretisation of convection terms, which is here explained and shown to yield improved accuracy and robustness. The results of the simulations, in terms of streamline patterns, give further evidence for a lip-vortex enhancement mechanism and are in remarkable agreement with flow visualization photographs from the literature. In addition, the results show that the variation of flow features in the vicinity of the re-entrant corner, such as lip vortex size and streamlines, are dominated by downstream quantities and scale with the common definition for the Deborah number in this flow, while flow characteristics in the salient corner region scale with that Deborah number divided by the contraction ratio

Viscoelastic flow in a 3D square/square contraction: Visualizations and simulations.

The inertialess three-dimensional (3D) flow of viscoelastic shear-thinning fluids in a 4:1 sudden square-square contraction was investigated experimentally and numerically and compared with the flow of inelastic fluids. Whereas for a Newtonian fluid the vortex length remains unchanged at low Reynolds numbers, with the non-Newtonian fluid there is a large increase in vortex length with fluid elasticity leading to unstable periodic flow at higher flow rates. In the steady flow regime the vortices are 3D and fluid particles enter the vortex at the middle plane, rotate towards its eye, drift sideways to the corner-plane vortex, rotate to its periphery, and exit to the downstream duct. Such dynamic process is reverse of that observed and predicted with Newtonian fluids. Numerical predictions using a multimode Phan-Thien–Tanner viscoelastic model are found to match the visualizations accurately and in particular are able to replicate the observed flow reversal. The effect of fluid rheology on flow reversal, vortex enhancement, and entry pressure drop is investigated in detail

Immune regulatory networks coordinated by glycans and glycan-binding proteins in autoimmunity and infection

The immune system is coordinated by an intricate network of stimulatory and inhibitory circuits that regulate host responses against endogenous and exogenous insults. Disruption of these safeguard and homeostatic mechanisms can lead to unpredictable inflammatory and autoimmune responses, whereas deficiency of immune stimulatory pathways may orchestrate immunosuppressive programs that contribute to perpetuate chronic infections, but also influence cancer development and progression. Glycans have emerged as essential components of homeostatic circuits, acting as fine-tuners of immunological responses and potential molecular targets for manipulation of immune tolerance and activation in a wide range of pathologic settings. Cell surface glycans, present in cells, tissues and the extracellular matrix, have been proposed to serve as “self-associated molecular patterns” that store structurally relevant biological data. The responsibility of deciphering this information relies on different families of glycan-binding proteins (including galectins, siglecs and C-type lectins) which, upon recognition of specific carbohydrate structures, can recalibrate the magnitude, nature and fate of immune responses. This process is tightly regulated by the diversity of glycan structures and the establishment of multivalent interactions on cell surface receptors and the extracellular matrix. Here we review the spatiotemporal regulation of selected glycan-modifying processes including mannosylation, complex Nglycan branching, core 2 O-glycan elongation, LacNAc extension, as well as terminal sialylation and fucosylation. Moreover, we illustrate examples that highlight the contribution of these processes to the control of immune responses and their integration with canonical tolerogenic pathways. Finally, we discuss the power of glycans and glycan-binding proteins as a source of immunomodulatory signals that could be leveraged for the treatment of autoimmune inflammation and chronic infection.This work was supported by grants from SSP: co-funded by the European Union (ERC, GlycanSwitch, 101071386). Views and opinions expressed are however those of the author(s) only and do not necessarily reflect those of the European Union or the European Research Council Executive Agency. Neither the European Union nor the granting authority can be held responsible for them. The work was also co-funded by EU GlycanTrigger-grant Agreement No: 101093997. Views and opinions expressed are however those of the author(s) only and do not necessarily reflect those of the European Union or European Health and Digital Executive Agency. Neither the European Union nor the granting authority can be held responsible for them. SSP also acknowledges funding by “2022 LRA Lupus Innovation Award” and by “European Crohn’s and Colitis Organisation (ECCO) Pioneer Award 2021”. SSP also acknowledges the US Department of Defense, US Army Medical Research Acquisition Activity, FY18 Peer Reviewed Medical Research Program Investigator-Initiated Research Award (award number W81XWH1920053) as well as grant funded by the Portuguese Foundation for Science and Technology – FCT (EXPL/MED-ONC/0496/2021). IA acknowledges FCT for funding (2022.00337.CEECIND). JG acknowledges funding from ESCMID (ESCMID Research Grant 2022), ECCO (ECCO Grant 2023) and FCT (2020.00088.CEECIND). G.A.R acknowledges grants from the Argentinean Agency for Promotion of Science, Technology and Innovation (PICT 2017-0494, PICT-FBB 620 and PICT 2020-01552). The authors are also thankful for generous support from Sales (Argentina), Bunge & Born (Argentina), Baron (Argentina), Williams (Argentina) and Richard Lounsbery (USA) Foundations, as well as donations from Ferioli-Ostry and Caraballo families to GAR

The effect of expansion ratio for creeping expansion flows of UCM fluids

A systematic numerical investigation on creeping flows in planar sudden expansions of viscoelastic fluids obeying the upper-convected Maxwell model is carried out to assess the combined effects of viscoelasticity, through the Deborah number, and expansion ratio (ER), which was varied between 1.25 and 32. At large expansion ratios (ER≥4) the flow becomes dominated by the downstream duct size and appropriately normalized quantities tend to be independent of ER. The recirculation size and strength become decreasing functions of De, whereas the Couette correction (the normalized entry pressure drop due to the presence of the expansion) increases. At small ER (ER≤3), however, no simple scaling laws are found and there is a complex interaction between De and ER leading to non-monotonic variations, with an initial decrease in the recirculation length at low Deborah numbers, followed by an enhancement as De increases

Plane sudden expansion flows of viscoelastic liquids

We report a systematic numerical investigation of the creeping flow of three different viscoelastic models, the UCM, Oldroyd-B and the linear form of the PTT model, through a 1:3 planar sudden expansion. Although the effect of elasticity is to reduce both the length and intensity of the recirculation region downstream of the expansion, we show that this reduction is much lower than previous studies have suggested and that, at high Deborah number, a significant region of recirculation still exists for all of the models studied

Uniform flow of viscoelastic fluids past a confined falling cylinder

Uniform steady flow of viscoelastic fluids past a cylinder placed between two moving parallel plates is investigated numerically with a finite-volume method. This configuration is equivalent to the steady settling of a cylinder in a viscoelastic fluid, and here, a 50% blockage ratio is considered. Five constitutive models are employed (UCM, Oldroyd-B, FENE-CR, PTT and Giesekus) to assess the effect of rheological properties on the flow kinematics and wake patterns. Simulations were carried out under creeping flow conditions, using very fine meshes, especially in the wake of the cylinder where large normal stresses are observed at high Deborah numbers. Some of the results are compared with numerical data from the literature, mainly in terms of a drag coefficient, and significant discrepancies are found, especially for the constant-viscosity constitutive models. Accurate solutions could be obtained up to maximum Deborah numbers clearly in excess of those reported in the literature, especially with the PTT and FENECR models. The existence or not of a negative wake is identified for each set of model parameters

Solid Waste Mixtures as Constructed Wetlands Filling: Effect of Hydraulic Loading Rate on Nutrient Removal from Wastewater

This study aims to contribute to constructed wetlands’ (CWs) eco-efficiency by applying the concepts of circular economy and waste to treat waste. Five sets of lab-scale CWs with different combinations of filling materials were evaluated and the effect of the hydraulic loading rate (HLR) on the nutrient removal efficiencies was studied. Each CW set consisted of two, duplicate, plastic pots with solid waste filling supporting Phragmites australis macrophyte plants. The filling materials were layer combinations of limestone rock fragments, a waste from construction activities, and one of four other solid wastes: cork granulates from the cork industry (LCG); snail shells from the food and catering industry (LSS); coal slag from coal power plants (LCS); and clay brick fragments from construction activities (LBF). A reference set (LO) was filled only with limestone fragments. The CWs were operated using a low-strength wastewater in successive fill-and-drain cycles with a retention time of one to eight days and a one-day rest. Their removal efficiency was evaluated for COD, total phosphorus (TP) and total nitrogen (TN). All four CWs with mixed filling showed COD removal efficiencies higher than the reference CW and above 79%. The highest removal efficiency was achieved by the LCS CW (91 to 97%). The reference LO CW showed the highest TP removal efficiency. With exception of the LSS CW, the mixed filling CWs showed removal efficiencies close to the reference CW (above 55%). All but the LSS CW showed higher TN removal efficiencies than the reference CW (above 51%). The observed effect of HLR depends on the type of CW. The effect on COD, TP and TN removal efficiencies averaged 9%, 15% and 20%, respectively, for a range of HLR from 0.005 to 0.087 m/day. From this study it can be concluded that all tested layer-packed mixed solid waste fillings are adequate substrate combinations for nutrient removal from wastewater. Moreover, high nutrient removal efficiencies were maintained over a wide range of hydraulic loading rates. This innovative combination of waste materials can improve the CW adaptability to specific types of wastewater and contribute to reducing solid waste disposal in landfills.This work was supported by Program FEDER, ref. POCI-01-0145-FEDER-023314, project VALORBIO. The authors acknowledge the collaboration of the Lab.IPT staff and the assistance of the Instituto Politécnico de Tomar maintenance staff.info:eu-repo/semantics/publishedVersio