1,959 research outputs found
Analysis of longitudinal bunching inan FEL driven two-beam accelerator
Recent experiments [1] have explored the use of a free-electron laser (FEL)
as a buncher for a microwave two-beam accelerator, and the subsequent driving
of a standing-wave rf output cavity. Here we present a deeper analysis of the
longitudinal dynamics of the electron bunches as they are transported from the
end of the FEL and through the output cavity. In particular, we examine the
effect of the transport region and cavity aperture to filter the bunched
portion of the beam.
[1] T. Lefevre, et. al., Phys. Rev. Lett. 84 (2000), 1188.Comment: 3 pages, 8 figures. Submitted to XX Int'l LINAC Conferenc
Three-Dimensional Model-Observation Comparison in the Loop Current Region
Accurate high-resolution ocean models are required for hurricane and oil spill pathway predictions, and to enhance the dynamical understanding of circulation dynamics. Output from the 1/25° data-assimilating Gulf of Mexico HYbrid Coordinate Ocean Model (HYCOM31.0) is compared to daily full water column observations from a moored array, with a focus on Loop Current path variability and upper-deep layer coupling during eddy separation. Array-mean correlation was 0.93 for sea surface height, and 0.93, 0.63, and 0.75 in the thermocline for temperature, zonal, and meridional velocity, respectively. Peaks in modeled eddy kinetic energy were consistent with observations during Loop Current eddy separation, but with modeled deep eddy kinetic energy at half the observed amplitude. Modeled and observed LC meander phase speeds agreed within 8% and 2% of each other within the 100-40 and 40-20 day bands, respectively. The model reproduced observed patterns indicative of baroclinic instability, that is, a vertical offset with deep stream function leading upper stream function in the along-stream direction. While modeled deep eddies differed slightly spatially and temporally, the joint development of an upper-ocean meander along the eastern side of the LC and the successive propagation of upper-deep cyclone/anticylone pairs that preceded separation were contained within the model solution. Overall, model-observation comparison indicated that HYCOM31.0 could provide insight into processes within the 100-20 day band, offering a larger spatial and temporal window than observational arrays
New Pseudo-Phase Structure for -Pu
In this paper we propose a new pseudo-phase crystal structure, based on an
orthorhombic distortion of the diamond structure, for the ground-state
-phase of plutonium. Electronic-structure calculations in the
generalized-gradient approximation give approximately the same total energy for
the two structures. Interestingly, our new pseudo-phase structure is the same
as the Pu -phase structure except with very different b/a and c/a
ratios. We show how the contraction relative to the phase, principally
in the direction, leads to an -like structure in the [0,1,1] plane.
This is an important link between two complex structures of plutonium and opens
new possibilities for exploring the very rich phase diagram of Pu through
theoretical calculations
Low Temperature Symmetry of Pyrochlore Oxide Cd2Re2O7
We report the X-ray study for the pyrochlore oxide Cd2Re2O7. Two
symmetry-lowering structural transitions were observed at Ts1=200K and
Ts2=120K. The former is of the second order from the ideal cubic pyrochlore
structure with space group Fd-3m to a tetragonally distorted structure with
I-4m2, while the latter is of the first order likely to another tetragonal
space group I4122. We discuss the feature of the lattice deformation.Comment: 4 pages, 4 figure
High-pressure study on the superconducting pyrochlore oxide Cd2Re2O7
Superconducting and structural phase transitions in a pyrochlore oxide
Cd2Re2O7 are studied under high pressure by x-ray diffraction and electrical
resistivity measurements. A rich P-T phase diagram is obtained, which contains
at least two phases with the ideal and slightly distorted pyrochlore
structures. It is found that the transition between them is suppressed with
increasing pressure and finally disappears at a critical pressure Pc = 3.5 GPa.
Remarkable enhancements in the residual resistivity as well as the coefficient
A of the AT 2 term in the resistivity are found around the critical pressure.
Superconductivity is detected only for the phase with the structural
distortion. It is suggested that the charge fluctuations of Re ions play a
crucial role in determining the electronic properties of Cd2Re2O7.Comment: 5 pages, 5 figures, submitted to J. Phys. Soc. Jp
Zero-temperature generalized phase diagram of the 4d transition metals under pressure
We use an accurate implementation of density functional theory (DFT) to
calculate the zero-temperature generalized phase diagram of the 4 series of
transition metals from Y to Pd as a function of pressure and atomic number
. The implementation used is full-potential linearized augmented plane waves
(FP-LAPW), and we employ the exchange-correlation functional recently developed
by Wu and Cohen. For each element, we obtain the ground-state energy for
several crystal structures over a range of volumes, the energy being converged
with respect to all technical parameters to within meV/atom. The
calculated transition pressures for all the elements and all transitions we
have found are compared with experiment wherever possible, and we discuss the
origin of the significant discrepancies. Agreement with experiment for the
zero-temperature equation of state is generally excellent. The generalized
phase diagram of the 4 series shows that the major boundaries slope towards
lower with increasing for the early elements, as expected from the
pressure induced transfer of electrons from states to states, but are
almost independent of for the later elements. Our results for Mo indicate a
transition from bcc to fcc, rather than the bcc-hcp transition expected from
- transfer.Comment: 28 pages and 10 figures. Submitted to Phys. Rev.
Crystal Stratigraphy of Two Basalts from Apollo 16: Unique Crystallization of Picritic Basalt 606063,10-16 and Very-Low-Titanium Basalt 65703,9-13
A geochemical survey of Apollo 16 regolith fragments found five basaltic samples from among hundreds of 2-4 mm regolith fragments of the Apollo 16 site. These included a high-Ti vitrophyric basalt (60603,10-16) and one very-low-titanium (VLT) crystalline basalt (65703,9-13). Apollo 16 was the only highlands sample return mission distant from the maria (approx. 200 km). Identification of basaltic samples at the site not from the ancient regolith breccia indicates input of material via lateral transport by post-basin impacts. The presence of basaltic rocklets and glass at the site is not unprecedented and is required to satisfy mass-balance constraints of regolith compositions. However, preliminary characterization of olivine and plagioclase crystal size distributions indicated the sample textures were distinct from other known mare basalts, and instead had affinities to impact melt textures. Impact melt textures can appear qualitatively similar to pristine basalts, and quantitative analysis is required to distinguish between the two in thin section. The crystal stratigraphy method is a powerful tool in studying of igneous systems, utilizing geochemical analyses across minerals and textural analyses of phases. In particular, trace element signatures can aid in determining the ultimate origin of these samples and variations document subtle changes occurring during their petrogenesis
Testing the Origins of Basalt Fragments fro Apollo 16
Several 2-4 mm regolith fragments of basalt from the Apollo 16 site were recently described by [1]. These included a high-Ti vitrophyric basalts (60603,10-16) and one very-low-titanium (VLT) crystalline basalt (65703,9-13). As Apollo 16 was the only highlands sample return mission distant from the maria, identification of basaltic samples at the site indicates input from remote sites via impact processes [1]. However, distinguishing between impact melt and pristine basalt can be notoriously difficult and requires significant sample material [2-6]. The crystal stratigraphy method utilizes essentially non-destructive methods to make these distinctions [7,8]. Crystal stratigraphy combines quantitative petrography in the form of crystal size distributions (CSDs) coupled with mineral geochemistry to reveal the petrogenetic history of samples. The classic CSD plot of crystal size versus population density can reveal insights on growth/cooling rates, residence times, and magma history which in turn can be used to evaluate basaltic vs impact melt origin [7-9]. Electron microprobe (EMP) and laser ablation (LA)-ICP-MS analyses of mineral phases complement textural investigations. Trace element variations document subtle changes occurring during the formation of the samples, and are key in the interpretation and preservation of this rare lunar sample collection
Brewing of filter coffee
We report progress on mathematical modelling of coffee grounds in a drip filter coffee machine. The report focuses on the evolution of the shape of the bed of coffee grounds during extraction with some work also carried out on the chemistry of extraction. This work was sponsored by Philips who are interested in understanding an observed correlation between the final shape of the coffee grounds and the quality of the coffee. We used experimental data gathered by Philips and ourselves to identify regimes in the coffee brewing process and relevant regions of parameter space. Our work makes it clear that a number of separate processes define the shape of the coffee bed depending on the values of the parameters involved e.g. the size of the grains and the speed of fluid flow during extraction. We began work on constructing mathematical models of the redistribution of the coffee grounds specialised to each region and on a model of extraction. A variety of analytic and numerical tools were used. Furthermore our research has progressed far enough to allow us to begin to exploit connections between this problem and other areas of science, in particular the areas of sedimentology and geomorphology, where the processes we have observed in coffee brewing have been studied
Tight-binding study of high-pressure phase transitions in titanium: alpha to omega and beyond
We use a tight-binding total energy method, with parameters determined from a
fit to first-principles calculations, to examine the newly discovered gamma
phase of titanium. Our parameters were adjusted to accurately describe the
alpha Ti-omega Ti phase transition, which is misplaced by density functional
calculations. We find a transition from omega Ti to gamma Ti at 102 GPa, in
good agreement with the experimental value of 116 GPa. Our results suggest that
current density functional calculations will not reproduce the omega Ti-gamma
Ti phase transition, but will instead predict a transition from omega Ti to the
bcc beta Ti phase.Comment: 3 encapsulated Postscript figures, submitted to Phyical Review
Letter
- …