39,893 research outputs found
Microcrystalline silicon growth for heterojunction solar cells
Microcrystalline Si (m-Si) films with a 1.7eV energy bandgap and crystal size of several hundred A were e-beam evaporated on single crystalline Si (c-Si) to form a heterojunction with the substrate, or a window layer to a single crystalline p-n junction (heteroface structure). The goal was to enhance Voc by such uses of the larger bandgap m-Si, with the intriguing prospect of forming heterostructures with exact lattice match on each layer. The heterojunction structure was affected by interface and shunting problems and the best Voc achieved was only 482mV, well below that of single crystal Si homojunctions. The heteroface structure showed promise for some of the samples with p m-Si/p-n structure (the complementary structure did not show any improvement). Although several runs with different deposition conditions were run, the results were inconsistent. Any Voc enhancement obtained was too small to compensate for the current loss due to the extra absorption and poor carrier transport properties of the m-Si film
Simulating coronal condensation dynamics in 3D
We present numerical simulations in 3D settings where coronal rain phenomena
take place in a magnetic configuration of a quadrupolar arcade system. Our
simulation is a magnetohydrodynamic simulation including anisotropic thermal
conduction, optically thin radiative losses, and parametrised heating as main
thermodynamical features to construct a realistic arcade configuration from
chromospheric to coronal heights. The plasma evaporation from chromospheric and
transition region heights eventually causes localised runaway condensation
events and we witness the formation of plasma blobs due to thermal instability,
that evolve dynamically in the heated arcade part and move gradually downwards
due to interchange type dynamics. Unlike earlier 2.5D simulations, in this case
there is no large scale prominence formation observed, but a continuous coronal
rain develops which shows clear indications of Rayleigh-Taylor or interchange
instability, that causes the denser plasma located above the transition region
to fall down, as the system moves towards a more stable state. Linear stability
analysis is used in the non-linear regime for gaining insight and giving a
prediction of the system's evolution. After the plasma blobs descend through
interchange, they follow the magnetic field topology more closely in the lower
coronal regions, where they are guided by the magnetic dips.Comment: 47 pages, 59 figure
- …