An intelligent position-specific training system for mission operations

Marshall Space Flight Center's (MSFC's) payload ground controller training program provides very good generic training; however, ground controller position-specific training can be improved by including position-specific training systems in the training program. This report explains why MSFC needs to improve payload ground controller position-specific training. The report describes a generic syllabus for position-specific training systems, a range of system designs for position-specific training systems, and a generic development process for developing position-specific training systems. The report also describes a position-specific training system prototype that was developed for the crew interface coordinator payload operations control center ground controller position. The report concludes that MSFC can improve the payload ground controller training program by incorporating position-specific training systems for each ground controller position; however, MSFC should not develop position-specific training systems unless payload ground controller position experts will be available to participate in the development process

Growth of Sr1-xCaxRuO3 thin films by metalorganic aerosol deposition

We report the growth of thin films of Sr1-xCaxRuO3 on SrTiO3 and MgO substrates by metalorganic aerosol deposition. The structure and microstructure is characterized by X-ray diffraction and room-temperature scanning tunnelling microscopy (STM), respectively. STM indicates in-plane epitaxy and a small surface roughness for films on SrTiO3. The high-quality of the films is supported by large residual resistivity ratios up to 29.Comment: 4 Pages, 2 Figures, submitted to Proceedings of ICM 2009 (Karlsruhe

Implications of the isotope effects on the magnetization, magnetic torque and susceptibility

We analyze the magnetization, magnetic torque and susceptibility data of La2-xSrxCu(16,18)O4 and YBa2(63,65)CuO7-x near Tc in terms of the universal 3D-XY scaling relations. It is shown that the isotope effect on Tc mirrors that on the anisotropy. Invoking the generic behavior of the anisotropy the doping dependence of the isotope effects on the critical properties, including Tc, correlation lengths and magnetic penetration depths are traced back to a change of the mobile carrier concentration.Comment: 5 pages, 3 figure

Superluminal Caustics of Close, Rapidly-Rotating Binary Microlenses

The two outer triangular caustics (regions of infinite magnification) of a close binary microlens move much faster than the components of the binary themselves, and can even exceed the speed of light. When $\epsilon > 1$, where $\epsilon c$ is the caustic speed, the usual formalism for calculating the lens magnification breaks down. We develop a new formalism that makes use of the gravitational analog of the Li\'enard-Wiechert potential. We find that as the binary speeds up, the caustics undergo several related changes: First, their position in space drifts. Second, they rotate about their own axes so that they no longer have a cusp facing the binary center of mass. Third, they grow larger and dramatically so for $\epsilon >> 1$. Fourth, they grow weaker roughly in proportion to their increasing size. Superluminal caustic-crossing events are probably not uncommon, but they are difficult to observe.Comment: 12 pages, 7 ps figures, submitted to Ap

Angular Radii of Stars via Microlensing

We outline a method by which the angular radii of giant and main sequence stars in the Galactic bulge can be measured to a few percent accuracy. The method combines ground-based photometry of caustic-crossing bulge microlensing events, with a handful of precise astrometric measurements of the lensed star during the event, to measure the angular radius of the source, theta_*. Dense photometric coverage of one caustic crossing yields the crossing timescale dt. Less frequent coverage of the entire event yields the Einstein timescale t_E and the angle phi of source trajectory with respect to the caustic. The photometric light curve solution predicts the motion of the source centroid up to an orientation on the sky and overall scale. A few precise astrometric measurements therefore yield theta_E, the angular Einstein ring radius. Then the angular radius of the source is obtained by theta_*=theta_E(dt/t_E) sin(phi). We argue that theta_* should be measurable to a few percent accuracy for Galactic bulge giant stars using ground-based photometry from a network of small (1m-class) telescopes, combined with astrometric observations with a precision of ~10 microarcsec to measure theta_E. We find that a factor of ~50 times fewer photons are required to measure theta_E to a given precision for binary-lens events than single-lens events. Adopting parameters appropriate to the Space Interferometry Mission (SIM), ~7 min of SIM time is required to measure theta_E to ~5% accuracy for giant sources in the bulge. For main-sequence sources, theta_E can be measured to ~15% accuracy in ~1.4 hours. With 10 hrs of SIM time, it should be possible to measure theta_* to ~5% for \~80 giant stars, or to 15% for ~7 main sequence stars. A byproduct of such a campaign is a significant sample of precise binary-lens mass measurements.Comment: 13 pages, 3 figures. Revised version, minor changes, required SIM integration times revised upward by ~60%. Accepted to ApJ, to appear in the March 20, 2003 issue (v586

Reconstruction of Cluster Masses using Particle Based Lensing I: Application to Weak Lensing

We present Particle-Based Lensing (PBL), a new technique for gravitational lensing mass reconstructions of galaxy clusters. Traditionally, most methods have employed either a finite inversion or gridding to turn observational lensed galaxy ellipticities into an estimate of the surface mass density of a galaxy cluster. We approach the problem from a different perspective, motivated by the success of multi-scale analysis in smoothed particle hydrodynamics. In PBL, we treat each of the lensed galaxies as a particle and then reconstruct the potential by smoothing over a local kernel with variable smoothing scale. In this way, we can tune a reconstruction to produce constant signal-noise throughout, and maximally exploit regions of high information density. PBL is designed to include all lensing observables, including multiple image positions and fluxes from strong lensing, as well as weak lensing signals including shear and flexion. In this paper, however, we describe a shear-only reconstruction, and apply the method to several test cases, including simulated lensing clusters, as well as the well-studied ``Bullet Cluster'' (1E0657-56). In the former cases, we show that PBL is better able to identify cusps and substructures than are grid-based reconstructions, and in the latter case, we show that PBL is able to identify substructure in the Bullet Cluster without even exploiting strong lensing measurements. We also make our codes publicly available.Comment: Accepted for publication in ApJ; Codes available at http://www.physics.drexel.edu/~deb/PBL.htm ; 12 pages,9 figures, section 3 shortene

Exact gravitational lensing and rotation curve

Based on the geodesic equation in a static spherically symmetric metric we discuss the rotation curve and gravitational lensing. The rotation curve determines one function in the metric without assuming Einstein's equations. Then lensing is considered in the weak field approximation of general relativity. From the null geodesics we derive the lensing equation and corrections to it.Comment: 12 pages, 1 figur