2,431 research outputs found
Analysis of Photoassociation Spectra for Giant Helium Dimers
We perform a theoretical analysis to interpret the spectra of purely
long-range helium dimers produced by photoassociation (PA) in an ultra-cold gas
of metastable helium atoms. The experimental spectrum obtained with the PA
laser tuned closed to the atomic line has been
reported in a previous Letter. Here, we first focus on the corrections to be
applied to the measured resonance frequencies in order to infer the molecular
binding energies. We then present a calculation of the vibrational spectra for
the purely long-range molecular states, using adiabatic potentials obtained
from perturbation theory. With retardation effects taken into account, the
agreement between experimental and theoretical determinations of the spectrum
for the purely long-range potential well is very good. The results
yield a determination of the lifetime of the atomic state
Abundance of small individuals influences the effectiveness of processing techniques for deep-sea nematodes
Nematodes are the most abundant metazoans of deep-sea benthic communities, but knowledge of their distribution is limited relative to larger organisms. Whilst some aspects of nematode processing techniques, such as extraction, have been extensively studied, other key elements have attracted little attention. We compared the effect of (1) mesh size (63, 45, and 32 ÎŒm) on estimates of nematode abundance, biomass, and body size, and (2) microscope magnification (50 and 100Ă) on estimates of nematode abundance at bathyal sites (250-3100 m water depth) on the Challenger Plateau and Chatham Rise, south-west Pacific Ocean. Variation in the effectiveness of these techniques was assessed in relation to nematode body size and environmental parameters (water depth, sediment organic matter content, %silt/clay, and chloroplastic pigments). The 63-ÎŒm mesh retained a relatively low proportion of total nematode abundance (mean ±SD = 55 ±9%), but most of nematode biomass (90 ± 4%). The proportion of nematode abundance retained on the 45-ÎŒm mesh in surface (0-1 cm) and subsurface (1-5 cm) sediment was significantly correlated (P < 0.01) with %silt/clay (RÂČ = 0.39) and chloroplastic pigments (RÂČ = 0.29), respectively. Variation in median nematode body weight showed similar trends, but relationships between mean nematode body weight and environmental parameters were either relatively weak (subsurface sediment) or not significant (surface sediment). Using a low magnification led to significantly lower (on average by 43%) nematode abundance estimates relative to high magnification (P < 0.001), and the magnitude of this difference was significantly correlated (P < 0.05) with total nematode abundance (RÂČp = 0.53) and the number of small (†250 ÎŒm length) individuals (RÂČp = 0.05). Our results suggest that organic matter input and sediment characteristics influence the abundance of small nematodes in bathyal communities. The abundance of small individuals can, in turn, influence abundance estimates obtained using different mesh sizes and microscope magnifications
Recommended from our members
Human fur gene encodes a yeast KEX2-like endoprotease that cleaves pro-beta-NGF in vivo.
Extracts from BSC-40 cells infected with vaccinia recombinants expressing either the yeast KEX2 prohormone endoprotease or a human structural homologue (fur gene product) contained an elevated level of a membrane-associated endoproteolytic activity that could cleave at pairs of basic amino acids (-LysArg- and -ArgArg-). The fur-directed activity (furin) shared many properties with Kex2p including activity at pH 7.3 and a requirement for calcium. By using antifurin antibodies, immunoblot analysis detected two furin translation products (90 and 96 kD), while immunofluorescence indicated localization to the Golgi apparatus. Coexpression of either Kex2p or furin with the mouse beta-nerve growth factor precursor (pro-beta-NGF) resulted in greatly enhanced conversion of the precursor to mature nerve growth factor. Thus, the sequence homology shared by furin and the yeast KEX2 prohormone processing enzyme is reflected by significant functional homology both in vitro and in vivo
Insulator interface effects in sputterâdeposited NbN/MgO/NbN (superconductorâinsulatorâsuperconductor) tunnel junctions
All refractory, NbN/MgO/NbN (superconductorâinsulatorâsuperconductor) tunnel junctions have been fabricated by in situ sputter deposition. The influence of MgO thickness (0.8â6.0 nm) deposited under different sputtering ambients at various deposition rates on currentâvoltage (IâV) characteristics of smallâarea (30Ă30 ÎŒm) tunnel junctions is studied. The NbN/MgO/NbN trilayer is deposited in situ by dc reactive magnetron (NbN), and rf magnetron (MgO) sputtering, followed by thermal evaporation of a protective Au cap. Subsequent photolithography, reactive ion etching, planarization, and top contact (Pb/Ag) deposition completes the junction structure. Normal resistance of the junctions with MgO deposited in Ar or Ar and N2 mixture shows good exponential dependence on the MgO thickness indicating formation of a pinâholeâfree uniform barrier layer. Further, a postdeposition in situ oxygen plasma treatment of the MgO layer increases the junction resistance sharply, and reduces the subgap leakage. A possible enrichment of the MgO layer stoichiometry by the oxygen plasma treatment is suggested. A sumgap as high as 5.7 mV is observed for such a junctio
Multiplexable Kinetic Inductance Detectors
We are starting to investigate a novel multiplexable readout method that can be applied to a large class of superconducting pair-breaking detectors. This readout method is completely different from those currently used with STJ and TES detectors, and in principle could deliver large pixel counts, high sensitivity, and Fano-limited spectral resolution. The readout is based on the fact that the kinetic surface inductance L_s of a superconductor is a function of the density of quasiparticles n, even at temperatures far below T_c. An efficient way to measure changes in the kinetic inductance is to monitor the transmission phase of a resonant circuit. By working at microwave frequencies and using thin films, the kinetic inductance can be a significant part of the total inductance L, and the volume of the inductor can be made quite small, on the order of 1 ”m^3. As is done with other superconducting detectors, trapping could be used to concentrate the quasiparticles into the small volume of the inductor. However, the most intriguing aspect of the concept is that passive frequency multiplexing could be used to read out ~10^3 detectors with a single HEMT amplifier
Thin-film chemical sensors based on electron tunneling
The physical mechanisms underlying a novel chemical sensor based on electron tunneling in metal-insulator-metal (MIM) tunnel junctions were studied. Chemical sensors based on electron tunneling were shown to be sensitive to a variety of substances that include iodine, mercury, bismuth, ethylenedibromide, and ethylenedichloride. A sensitivity of 13 parts per billion of iodine dissolved in hexane was demonstrated. The physical mechanisms involved in the chemical sensitivity of these devices were determined to be the chemical alteration of the surface electronic structure of the top metal electrode in the MIM structure. In addition, electroreflectance spectroscopy (ERS) was studied as a complementary surface-sensitive technique. ERS was shown to be sensitive to both iodine and mercury. Electrolyte electroreflectance and solid-state MIM electroreflectance revealed qualitatively the same chemical response. A modified thin-film structure was also studied in which a chemically active layer was introduced at the top Metal-Insulator interface of the MIM devices. Cobalt phthalocyanine was used for the chemically active layer in this study. Devices modified in this way were shown to be sensitive to iodine and nitrogen dioxide. The chemical sensitivity of the modified structure was due to conductance changes in the active layer
An optimal renewable energy mix for Indonesia
Indonesia has experienced a constant increase of the use of petroleum and coal in the power sector, while the share of renewable sources has remained stable at 6% of the total energy production during the last decade. As its domestic energy demand undeniably continues to grow, Indonesia is committed to increase the production of renewable energy. Mainly to decrease its dependency on fossil fuel-based resources, and to decrease the anthropogenic emissions, the government of Indonesia has established a 23 percent target for renewable energy by 2025, along with a 100 percent electrification target by 2020 (the current rate is 80.4 percent). In that respect, Indonesia has abundant resources to meet these targets, but there is - inter alia - a lack of proper integrated planning, regulatory support, investment, distribution in remote areas of the Archipelago, and missing data to back the planning.
To support the government of Indonesia in its sustainable energy system planning, a geographic explicit energy modeling approach is applied. This approach is based on the energy systems optimization model BeWhere, which identifies the optimal location of energy conversion sites based on the minimization of the costs of the supply chain. The model will incorporate the existing fossil fuel-based infrastructures, and evaluate the optimal costs, potentials and locations for the development of renewable energy technologies (i.e. wind, solar, hydro, biomass and geothermal based technologies), as well as the development of biomass co-firing in existing coal plants. With the help of the model, an optimally adapted renewable energy mix â vis-Ă -vis the competing fossil fuel based resources and applicable policies in order to promote the development of those renewable energy technologies â will be identified. The development of the optimal renewable energy technologies is carried out with special focus on nature protection and cultural heritage areas, where feedstock (e.g., biomass harvesting) and green-field power plant sites will be limited â depending on the protection type and renewable energy technology.
The results of the study provide indications to the policy makers on where, how and which technologies should be implemented, and what kind of policy support would be needed in order to increase and meet the Indonesian renewable energy target and to increase the energy access for all
Reaching the hydrodynamic regime in a Bose-Einstein condensate by suppression of avalanche
We report the realization of a Bose-Einstein condensate (BEC) in the
hydrodynamic regime. The hydrodynamic regime is reached by evaporative cooling
at a relative low density suppressing the effect of avalanches. With the
suppression of avalanches a BEC containing 120.10^6 atoms is produced. The
collisional opacity can be tuned from the collisionless regime to a collisional
opacity of more than 3 by compressing the trap after condensation. In the
collisional opaque regime a significant heating of the cloud at time scales
shorter than half of the radial trap period is measured. This is direct proof
that the BEC is hydrodynamic.Comment: Article submitted for Phys. Rev. Letters, 6 figure
- âŠ