Flight and ground tests of a very low density elastomeric ablative material

A very low density ablative material, a silicone-phenolic composite, was flight tested on a recoverable spacecraft launched by a Pacemaker vehicle system; and, in addition, it was tested in an arc heated wind tunnel at three conditions which encompassed most of the reentry heating conditions of the flight tests. The material was composed, by weight, of 71 percent phenolic spheres, 22.8 percent silicone resin, 2.2 percent catalyst, and 4 percent silica fibers. The tests were conducted to evaluate the ablator performance in both arc tunnel and flight tests and to determine the predictability of the albator performance by using computed results from an existing one-dimensional numerical analysis. The flight tested ablator experienced only moderate surface recession and retained a smooth surface except for isolated areas where the char was completely removed, probably following reentry and prior to or during recovery. Analytical results show good agreement between arc tunnel and flight test results. The thermophysical properties used in the analysis are tabulated

vbyCaHbeta CCD Photometry of Clusters. VIII. The Super-Metal Rich, Old Open Cluster NGC 6791

CCD photometry on the intermediate-band vbyCaHbeta system is presented for the metal-rich, old open cluster, NGC 6791. Preliminary analysis led to [Fe/H] above +0.4 with an anomalously high reddening and an age below 5 Gyr. A revised calibration between (b-y)_0 and [Fe/H] at a given temperature shows that the traditional color-metallicity relations underestimate the color of the turnoff stars at high metallicity. With the revised relation, the metallicity from hk and the reddening for NGC 6791 become [Fe/H] = +0.45 +/- 0.04 and E(b-y) = 0.113 +/- 0.012 or E(B-V) = 0.155 +/- 0.016. Using the same technique, reanalysis of the photometry for NGC 6253 produces [Fe/H] = +0.58 +/-0.04 and E(b-y) = 0.120 +/- 0.018 or E(B-V) = 0.160 +/- 0.025. The errors quoted include both the internal and external errors. For NGC 6791, the metallicity from m_1 is a factor of two below that from hk, a result that may be coupled to the consistently low metal abundance from DDO photometry of the cluster and the C-deficiency found from high dispersion spectroscopy. E(B-V) is the same value predicted from Galactic reddening maps. With E(B-V) = 0.15 and [Fe/H] = +0.45, the available isochrones predict an age of 7.0 +/- 1.0 Gyr and an apparent modulus of (m-M) = 13.60 +/- 0.15, with the dominant source of the uncertainty arising from inconsistencies among the isochrones. The reanalysis of NGC 6253 with the revised lower reddening confirms that on both the hk and m_1 metallicity scales, NGC 6253, while less than half the age of NGC 6791, remains at least as metal-rich as NGC 6791, if not richer.Comment: Accepted for Astronomical Journal. 42 p. latex file includes 11 figures and 3 tables, one of which is a short version of a data table to appear in online AJ in its entiret

Heat transfer distributions around nominal ice accretion shapes formed on a cylinder in the NASA Lewis icing research tunnel

Local heat transfer coefficients were obtained on irregular cylindrical shapes which typify the accretion of ice on circular cylinders in cross flow. The ice shapes were grown on a 5.1 cm (2.0 in.) diameter cylinder in the NASA Lewis Icing Research Tunnel. The shapes were 2, 5, and 15 min accumulations of glaze ice and 15 min accumulation of rime ice. Heat transfer coefficients were also measured around the cylinder with no ice accretion. These icing shapes were averaged axially to obtain a nominal shape of constant cross section for the heat transfer tests. Heat transfer coefficients around the perimeter of each shape were measured with electrically heated copper strips embedded in the surface of the model which was cast from polyurethane foam. Each strip contained a thermocouple to measure the local surface temperature. The models were run in a 15.2 x 68.6 cm (6 x 27 in.) wind tunnel at several velocities. Background turbulence in the wind tunnel was less than 0.5 percent. The models were also run with a turbulence producing grid which gave about 3.5 percent turbulence at the model location with the model removed. The effect of roughness was also simulated with sand grains glued to the surface. Results are presented as Nusselt number versus angle from the stagnation line for the smooth and rough models for both high and low levels of free stream turblence. Roughness of the surface in the region prior to flow separation plays a major role in determining the heat transfer distribution

Effect of simulated forward airspeed on small-scale-model externally blown flap noise

Noise tests were conducted on a small-scale model of an externally blown flap lift augmentation system. The nozzle/wing model was subjected to external flow that simulated takeoff and landing flight velocities by placing it in a 33-centimeter-diameter free jet. The results showed that external flow attenuated the noise associated with the various configurations tested. The amount of attenuation depended on flap setting. More attenuation occurred with a trailing-flap setting of 20 deg than with one of 60 deg. Noise varied with relative velocity as a function of the trailing-flap setting and the angle from the nozzle inlet

Noise produced by a small-scale, externally blown flap

Noise data were obtained with a model of an externally blown flap of the type that is currently being considered for STOL aircraft. The noise caused by impingement of the jet on the flap is much louder than the nozzle jet noise. It is especially so directly below the wing. The noise level increases as the jet velocity and flap angle are increased. The sound power level increased with the sixth power of velocity. Several physical variations to the STOL model configuration were also tested. Two such variations, a large board and a slotless curved plate wing, had the same power spectra density (Strouhal number curve) as the model

Detection of continuous variable entanglement without coherent local oscillators

We propose three criteria for identifying continuous variable entanglement between two many-particle systems with no restrictions on the quantum state of the local oscillators used in the measurements. Mistakenly asserting a coherent state for the local oscillator can lead to incorrectly identifying the presence of entanglement. We demonstrate this in simulations with 100 particles, and also find that large number fluctuations do not prevent the observation of entanglement. Our results are important for quantum information experiments with realistic Bose-Einstein condensates or in optics with arbitrary photon states.Comment: 7 Pages, 4 Figure

The Mass of the Convective Zone in FGK Main Sequence Stars and the Effect of Accreted Planetary Material on Apparent Metallicity Determinations

The mass of the outer convective zone in FGK main sequence stars decreases dramatically with stellar mass. Therefore, any contamination of a star's atmosphere by accreted planetary material should affect hotter stars much more than cool stars. If recent suggestions that high metal abundances in stars with planets are caused by planetesimal accretion are correct, then metallicity enhancements in earlier-type stars with planets should be very pronounced. No such trend is seen, however.Comment: Submitted ApJ Letters March 26th; accepted April 30th. 12 pages, 2 figure

Understanding the fidelity effect when evaluating games with children

There have been a number of studies that have compared evaluation results from prototypes of different fidelities but very few of these are with children. This paper reports a comparative study of three prototypes ranging from low fidelity to high fidelity within the context of mobile games, using a between subject design with 37 participants aged 7 to 9. The children played a matching game on either an iPad, a paper prototype using screen shots of the actual game or a sketched version. Observational data was captured to establish the usability problems, and two tools from the Fun Toolkit were used to measure user experience. The results showed that there was little difference for user experience between the three prototypes and very few usability problems were unique to a specific prototype. The contribution of this paper is that children using low-fidelity prototypes can effectively evaluate games of this genre and style