480 research outputs found

    Non-melt selective enhancement of crystalline structure in molybdenum thin films using femtosecond laser pulses

    Get PDF
    It is challenging to crystalize a thin film of higher melting temperature when deposited on a substrate with comparatively lower melting point. Trading such disparities in thermal properties between a thin film and its substrate can significantly impede material processing. We report a novel solid-state crystallization process for annealing of high melting point molybdenum thin films. A systematic investigation of laser induced annealing from single pulse to high pulse overlapping is reported upon scanning at fluences lower than the threshold required for the damage/ablation of molybdenum thin films. The approach allows better control of the grain size by changing the applied laser fluence. Atomic force microscopy surface morphology and x-ray diffraction (XRD) analysis reveal significant improvements in the average polycrystalline grain size after laser annealing; the sheet resistance was reduced by 19% of the initial value measured by a Four-point probe system. XRD confirms the enlargement of the single crystal grain size. No melting was evident, although a change in the close packing, shape and size of nanoscale polycrystalline grains is observed. Ultrashort laser induced crystallinity greatly enhances the electrical properties; Hall measurements reinforced that the overall carrier concentration increases after scanning at different laser fluences. The proposed method, based on the aggregation and subsequent growth of polycrystalline and single crystal-grains, leading to enhanced crystallization, has potential to be applicable in thin film processing industry for their wide applications

    Femtosecond Laser-Induced Crystallization of Amorphous Silicon Thin Films under a Thin Molybdenum Layer

    Get PDF
    A new process to crystallize amorphous silicon without melting and the generation of excessive heating of nearby components is presented. We propose the addition of a molybdenum layer to improve the quality of the laser-induced crystallization over that achieved by direct irradiation of silicon alone. The advantages are that it allows the control of crystallite size by varying the applied fluence of a near-infrared femtosecond laser. It offers two fluence regimes for nanocrystallization and polycrystallization with small and large crystallite sizes, respectively. The high repetition rate of the compact femtosecond laser source enables high-quality crystallization over large areas. In this proposed method, a multilayer structure is irradiated with a single femtosecond laser pulse. The multilayer structure includes a substrate, a target amorphous Si layer coated with an additional molybdenum thin film. The Si layer is crystallized by irradiating the Mo layer at different fluence regimes. The transfer of energy from the irradiated Mo layer to the Si film causes the crystallization of amorphous Si at low temperatures (∌700 K). Numerical simulations were carried out to estimate the electron and lattice temperatures for different fluence regimes using a two-temperature model. The roles of direct phonon transport and inelastic electron scattering at the Mo-Si interface were considered in the transfer of energy from the Mo to the Si film. The simulations confirm the experimental evidence that amorphous Si was crystallized in an all-solid-state process at temperatures lower than the melting point of Si, which is consistent with the results from transmission electron microscopy (TEM) and Raman. The formation of crystallized Si with controlled crystallite size after laser treatment can lead to longer mean free paths for carriers and increased electrical conductivity

    Standardized volumetric 3D-analysis of SPECT/CT imaging in orthopaedics: overcoming the limitations of qualitative 2D analysis

    Get PDF
    <p>Abstract</p> <p>Background</p> <p>SPECT/CT combines high resolution anatomical 3D computerized tomography (CT) and single photon emission computerized tomography (SPECT) as functional imaging, which provides 3D information about biological processes into a single imaging modality. The clinical utility of SPECT/CT imaging has been recognized in a variety of medical fields and most recently in orthopaedics; however, clinical adoption has been limited due to shortcomings of analytical tools available. Specifically, SPECT analyses are mainly qualitative due to variation in overall metabolic uptake among patients. Furthermore, most analyses are done in 2D, although rich 3D data are available. Consequently, it is difficult to quantitatively compare the position, size, and intensity of SPECT uptake regions among patients, and therefore difficult to draw meaningful clinical conclusions.</p> <p>Methods</p> <p>We propose a method for normalizing orthopaedic SPECT/CT data that enables standardised 3D volumetric quantitative measurements and comparison among patients. Our method is based on 3D localisation using clinically relevant anatomical landmarks and frames of reference, along with intensity value normalisation using clinically relevant reference regions. Using the normalised data, we describe a thresholding technique to distinguish clinically relevant hot spots from background activity.</p> <p>Results</p> <p>Using an exemplar comparison of two patients, we demonstrate how the normalised, 3D-rendered data can provide a richer source of clinical information and allow quantitative comparison of SPECT/CT measurements across patients. Specifically, we demonstrate how non-normalized SPECT/CT analysis can lead to different clinical conclusions than the normalized SPECT/CT analysis, and that normalized quantitative analysis can be a more accurate indicator of pathology.</p> <p>Conclusions</p> <p>Conventional orthopaedic frames of reference, 3D volumetric data analysis and thresholding are used to distinguish clinically relevant hot spots from background activity. Our goal is to facilitate a standardised approach to quantitative data collection and comparison of clinical studies using SPECT/CT, enabling more widespread clinical use of this powerful imaging tool.</p

    A missed orthopaedic injury following a seizure: a case report

    Get PDF
    Numerous orthopaedic injuries can follow a seizure and are often diagnosed late. This is the first documented case of a missed bilateral anterior shoulder dislocation following a seizure. The possible reasons for the greater incidence of posterior dislocations are examined and why bilateral anterior dislocations following a seizure are so rare. The article discusses the reasons for the delay and highlights potential pitfalls and learning points for junior emergency department doctors

    IMPLEmenting a clinical practice guideline for acute low back pain evidence-based manageMENT in general practice (IMPLEMENT) : cluster randomised controlled trial study protocol

    Get PDF
    Background: Evidence generated from reliable research is not frequently implemented into clinical practice. Evidence-based clinical practice guidelines are a potential vehicle to achieve this. A recent systematic review of implementation strategies of guideline dissemination concluded that there was a lack of evidence regarding effective strategies to promote the uptake of guidelines. Recommendations from this review, and other studies, have suggested the use of interventions that are theoretically based because these may be more effective than those that are not. An evidencebased clinical practice guideline for the management of acute low back pain was recently developed in Australia. This provides an opportunity to develop and test a theory-based implementation intervention for a condition which is common, has a high burden, and for which there is an evidence-practice gap in the primary care setting. Aim: This study aims to test the effectiveness of a theory-based intervention for implementing a clinical practice guideline for acute low back pain in general practice in Victoria, Australia. Specifically, our primary objectives are to establish if the intervention is effective in reducing the percentage of patients who are referred for a plain x-ray, and improving mean level of disability for patients three months post-consultation. Methods/Design: This study protocol describes the details of a cluster randomised controlled trial. Ninety-two general practices (clusters), which include at least one consenting general practitioner, will be randomised to an intervention or control arm using restricted randomisation. Patients aged 18 years or older who visit a participating practitioner for acute non-specific low back pain of less than three months duration will be eligible for inclusion. An average of twenty-five patients per general practice will be recruited, providing a total of 2,300 patient participants. General practitioners in the control arm will receive access to the guideline using the existing dissemination strategy. Practitioners in the intervention arm will be invited to participate in facilitated face-to-face workshops that have been underpinned by behavioural theory. Investigators (not involved in the delivery of the intervention), patients, outcome assessors and the study statistician will be blinded to group allocation. Trial registration: Australian New Zealand Clinical Trials Registry ACTRN012606000098538 (date registered 14/03/2006).The trial is funded by the NHMRC by way of a Primary Health Care Project Grant (334060). JF has 50% of her time funded by the Chief Scientist Office3/2006). of the Scottish Government Health Directorate and 50% by the University of Aberdeen. PK is supported by a NHMRC Health Professional Fellowship (384366) and RB by a NHMRC Practitioner Fellowship (334010). JG holds a Canada Research Chair in Health Knowledge Transfer and Uptake. All other authors are funded by their own institutions

    Identification of a novel zinc metalloprotease through a global analysis of clostridium difficile extracellular proteins

    Get PDF
    Clostridium difficile is a major cause of infectious diarrhea worldwide. Although the cell surface proteins are recognized to be important in clostridial pathogenesis, biological functions of only a few are known. Also, apart from the toxins, proteins exported by C. difficile into the extracellular milieu have been poorly studied. In order to identify novel extracellular factors of C. difficile, we analyzed bacterial culture supernatants prepared from clinical isolates, 630 and R20291, using liquid chromatography-tandem mass spectrometry. The majority of the proteins identified were non-canonical extracellular proteins. These could be largely classified into proteins associated to the cell wall (including CWPs and extracellular hydrolases), transporters and flagellar proteins. Seven unknown hypothetical proteins were also identified. One of these proteins, CD630_28300, shared sequence similarity with the anthrax lethal factor, a known zinc metallopeptidase. We demonstrated that CD630_28300 (named Zmp1) binds zinc and is able to cleave fibronectin and fibrinogen in vitro in a zinc-dependent manner. Using site-directed mutagenesis, we identified residues important in zinc binding and enzymatic activity. Furthermore, we demonstrated that Zmp1 destabilizes the fibronectin network produced by human fibroblasts. Thus, by analyzing the exoproteome of C. difficile, we identified a novel extracellular metalloprotease that may be important in key steps of clostridial pathogenesis

    The evolution of health policy guidelines for assisted reproduction in the Republic of Ireland, 2004-2009

    Get PDF
    This analysis reports on Irish regulatory policies for in vitro fertilisation (IVF) from 2004-2009, in the context of membership changes within the Medical Council of Ireland. To achieve this, the current (2009) edition of the Guide to Professional Conduct & Ethics was compared with the immediately preceding version (2004). The statutory composition of the Medical Council from 2004-2009 was also studied. Content analysis of the two editions identified the following differences: 1) The 2004 guide states that IVF "should only be used after thorough investigation has failed to reveal a treatable cause of the infertility", while the 2009 guide indicates IVF "should only be used after thorough investigation has shown that no other treatment is likely to be effective"; 2) The 2004 stipulation stating that fertilized ovum (embryo) "must be used for normal implantation and must not be deliberately destroyed" is absent from the 2009 guidelines; 3) The option to donate "unused fertilised ova" (embryos) is omitted from the 2009 guidelines; 4) The 2009 guidelines state that ART should be offered only by "suitably qualified professionals, in appropriate facilities, and according to the international best practice"; 5) The 2009 guidelines introduce criteria that donations as part of a donor programme should be "altruistic and non-commercial". These last two points represent original regulatory efforts not appearing in the 2004 edition. The Medical Practitioners Act 2007 reduced the number of physicians on the Medical Council to 6 (of 25) members. The ethical guidelines from 2004 preceded this change, while the reconstituted Medical Council published the 2009 version. Between 2004 and 2009, substantial modifications in reproductive health policy were incorporated into the Medical Council's ethical guidelines. The absence of controlling Irish legislation means that patients and IVF providers in Ireland must rely upon these guidelines by default. Our critique traces the evolution of public policy on IVF during a time when the membership of the Medical Council changed radically; reduced physician contribution to decision-making was associated with diminished protection for IVF-derived embryos in Ireland. Considerable uncertainty on IVF practice in Ireland remains
    • 

    corecore