Effect of Al doping on the optical phonon spectrum in Mg(1-x)Al(x)B(2)

Raman and infrared absorption spectra of Mg(1-x)Al(x)B(2) have been collected for 0<x<0.5 in the spectral range of optical phonons. The x-dependence of the peak frequency, the width and the intensity of the observed Raman lines has been carefully analized. A peculiar x-dependence of the optical modes is pointed out for two different Al doping ranges. In particular the onset of the high-doping structural phase previously observed in diffraction measurements is marked by the appearence of new spectral components at high frequencies. A connection between the whole of our results and the observed suppression of superconductivity in the high doping region is established

Optical study of the vibrational and dielectric properties of BiMnO3

BiMnO3 (BMO), ferromagnetic (FM) below Tc = 100 K, was believed to be also ferroelectric (FE) due to a non-centro-symmetric C2 structure, until diffraction data indicated that its space group is the centro-symmetric C2/c. Here we present infrared phonon spectra of BMO, taken on a mosaic of single crystals, which are consistent with C2/c at any T > 10 K, as well as room-temperature Raman data which strongly support this conclusion. We also find that the infrared intensity of several phonons increases steadily for decreasing T, causing the relative permittivity of BMO to vary from 18.5 at 300 K to 45 at 10 K. At variance with FE materials of displacive type, no appreciable softening has been found in the infrared phonons. Both their frequencies and intensities, moreover, appear insensitive to the FM transition at Tc

Optical Properties of (SrMnO3)n/(LaMnO3)2n superlattices: an insulator-to-metal transition observed in the absence of disorder

We measure the optical conductivity of (SrMnO3)n/(LaMnO3)2n superlattices (SL) for n=1,3,5, and 8 and 10 < T < 400 K. Data show a T-dependent insulator to metal transition (IMT) for n \leq 3, driven by the softening of a polaronic mid-infrared band. At n = 5 that softening is incomplete, while at the largest-period n=8 compound the MIR band is independent of T and the SL remains insulating. One can thus first observe the IMT in a manganite system in the absence of the disorder due to chemical doping. Unsuccessful reconstruction of the SL optical properties from those of the original bulk materials suggests that (SrMnO3)n/(LaMnO3)2n heterostructures give rise to a novel electronic state.Comment: Published Online in Nano Letters, November 8, 2010; http://pubs.acs.org/doi/abs/10.1021/nl1022628; 5 pages, 3 figure

Infrared study of the charge-ordered multiferroic LuFe(2)O(4)

The reflectivity of a large LuFe(2)O(4) single crystal has been measured with the radiation field either perpendicular or parallel to the c axis of its rhombohedral structure, from 10 to 500K, and from 7 to 16000 cm-1. The transition between the two-dimensional and the three-dimensional charge order at T_(CO) = 320 K is found to change dramatically the phonon spectrum in both polarizations. The number of the observed modes above and below T_(CO), according to a factor-group analysis, is in good agreement with a transition from the rhombohedral space group R{bar 3}m to the monoclinic C2/m. In the sub-THz region a peak becomes evident at low temperature, whose origin is discussed in relation with previous experiments.Comment: Physical Review B in pres

Design of a beamline for soft and deep lithography on third generation synchrotron radiation source

ELETTRA is a third generation synchrotron radiation source. The energy spectrum allows the design of beamlines suitable for x-ray lithography from soft to hard x-ray wavelengths. An appropriate lithographic window for micro- and nanofabrication can be obtained by a combination of selected filters and mirrors. As the beamline is interfaced to a vertical x-ray stepper, a uniformity in the beam intensity better than 3% (3σ) in the horizontal direction has to be reached. The present beamline is designed by taking into account the main factors which can affect the beam quality, namely, thermal loading on mirrors and filters, slope errors, and surface roughness of the mirrors. The resulting lithographic resolution at soft x-ray wavelengths is better than 100 nm

Effect of Mn substitution by Ga on the optical properties of a metallic manganite

In a metallic manganite like La(2/3)Sr(1/3)MnO(3), the substitution of Mn(+3) by Ga(+3) dilutes the ferromagnetic order and locally cancels the Jahn-Teller distortion, without heavily affecting the crystal structure. One can thus follow the changes in the charge dynamics induced by Ga, until the ferro-metallic manganite is turned into an insulator. Here this phenomenon is studied in detail through the infrared reflectivity of five samples of La(2/3)Sr(1/3)Mn(1-x)Ga(x)O(3), with x increasing from 0 to 0.30 and for 50 < T < 320 K. A simple model which links the measured optical parameters to the magnetization M(x, T) well describes the behavior of the plasma frequency, the scattering rate, and the mid-infrared absorption along the metal-to-insulator transition.Comment: 8 pages including 7 figure

Observation of charge-density-wave excitations in manganites

In the optical conductivity of four different manganites with commensurate charge order (CO), strong peaks appear in the meV range below the ordering temperature T_{CO}. They are similar to those reported for one-dimensional charge density waves (CDW) and are assigned to pinned phasons. The peaks and their overtones allow one to obtain, for La{1-n/8}Ca{n/8}$MnO{3} with n = 5, 6, the electron-phonon coupling, the effective mass of the CO system, and its contribution to the dielectric constant. These results support a description of the CO in La-Ca manganites in terms of moderately weak-coupling and of the CDW theory.Comment: To be published on Phys. Rev. Let