Inhaled Lavender Effect on Anxiety and Pain Caused From Intrauterine Device Insertion

Introduction: Intrauterine device (IUD) is the most common reliable, effective and reversible contraceptive method used worldwide and in areas with high growth rate is of particular importance. IUD insertion is associated with high anxiety in most people that causes pain and discomfort. The aim of this study was to determine the effects of aromatherapy on anxiety and pain caused by IUD insertion. Methods: This study was conducted on 106 women in a health care center located in Ardebil, Iran. Participants were divided into two groups by randomized blocks of 4 and 6. In the experimental group lavender scent was inhaled and in the control group the placebo was inhaled 30 minutes before IUD insertion. The anxiety of the participants was measured by Spielberger questionnaire, and the pain of IUD insertion was measured immediately after the insertion using visual analog scale (range 0-10). Results: The mean score (standard deviation) of anxiety before intervention was 43.2 (9.2) in the experimental group that decreased after intervention to 39.0 (10.5) (p < 0.001), while this score was 42.2 (9.0) and 41.5 (8.4) before and after the intervention in the control group (p = 0.21). Mean differences of anxiety in both groups was statistically significant (p < 0.001). The pain score after intervention did not show significant difference between two groups (p = 0.51). Conclusion: Aromatherapy with lavender inhalation was effective in decreasing anxiety in IUD procedure, and this method can be used in health care centers as complementary treatments

Diagnostics of Oil-Impregnated Paper Insulation Systems by Utilizing Lightning and Switching Transients

Development of the power gridtowards a more reliable and smarter system requires frequent on-line monitoring of the power components. Power transformers and their bushings are particularly important components in a power transmission system and their insulation degradation may lead to catastrophic failures. Time consuming and costly replacement of these components raise the importance of their frequent monitoring. A fault in a power transformer bushing can also involve in the failure of the transformer. Therefore, on-line diagnostics of power transformers and their bushings is of great interest. Several methods exist for diagnostics of these components. However, some of them can only be done off-line in maintenance periods, and the existing on-line methods generally provide less information, especially on the internal solid insulation parts. In this project, a new technique for on-line diagnostics of the power transformer and the bushing insulation is proposed. In this technique, natural transients happening in the power system such as lightning and switching surges can be used as stimuli for on-line dielectric response measurements. This technique can provide information on insulation close to what Dielectric Spectroscopy offers in off-line measurements. The wide-ranging frequency content of power system transients is their advantage for being usedas stimuli when measuring the Dielectric Response. The response can have particular signatures due to different types of defects in the insulation varying with frequency. Oil-impregnated paper as a major insulation component in power transformer and its bushing has been investigated in this project. Moisture content and temperature, as two important degradation factors in this type of insulation, have been studied to evaluate the performance of the proposed technique in the diagnostics of the oil-impregnated paper. The results are verified with the dielectric response obtained through commercial instruments. The results show that the proposed technique has the ability to track the changes in dielectric response due to the moisture content and temperature. Measurements were done at both highvoltage (40kV) and low voltage (10V) levels, and the corresponding circuit models to achieve reasonable accuracy for the results are discussed. Moving on from the material samples, a further study was done on three service-aged 150 kV bushings to investigate the feasibility of the technique on the diagnostics of power transformer bushings. Their dielectric response measured by the transient stimuli showed good agreement with their response obtained by the commercial instruments. The effect of the transformer winding on the transient response of the bushing is a further aspect of the real conditions for on-line diagnostics. This has been investigated through the simulation of transient models for transformers and bushings, and possible solutions for distinguishing the responses are presented. The proposed new on-line diagnostics technique by utilizing natural transients can provide information about the insulation system in a certain range of frequency without interrupting the operation or requiring an external voltage source. However, the validity range of the results depends on the bandwidth of the applied transients and other measurement considerations. This approach can be valuable in frequent monitoring of dielectric properties of the power transformers and their bushings as a complement to the other available on-line techniques.QC 20140409</p

Dielectric Response and Partial Discharge Diagnostics of Insulation Systems by Utilizing High Voltage Impulses

In this thesis, power system transients are considered as an opportunity for development of on-line diagnostics of power components and specifically the insulation systems of power transformers and bushings. A new technique for on-line dielectric response measurement of power transformer bushings is proposed which utilizes natural transients in the power system, such as lightning and switching surges, as stimuli. Laboratory investigations are done on implementation of the proposed technique. Measurement considerations, data acquisition and processing involved in achievement of reasonable accuracy in the Dielectric Response (DR) are presented. Capability of the technique in tracking of the degradation signatures such as moisture content in the insulation has been evaluated and it has shown a good level of accuracy by being compared to the Frequency Domain Spectroscopy (FDS).  The proposed technique is tested on the service-aged 150 kV bushings and feasibility of the technique for monitoring of dielectric properties of power transformer bushings has been assessed; the results are promising for the technique to be used in the real application.  Partial Discharges (PD) behavior under transients has been also studied for different materials in this project. PD behavior of different defects, at different insulation condition, responding to the overvoltage transients in form of superimposed impulses on ac voltages was investigated and it was perceived how their distinctive response and the interpretation of  that, can be useful for their identification. Besides the conventional materials, surface ac PD properties of modified paper with silica and zinc oxide nanoparticles under the superimposed impulses have been assessed in this project. Proper type and optimum concentration level of nanoparticles in the paper are the factors that lead to the improvement of PD behavior in the modified paper under overvoltage transients.QC 20160525</p

Effect of Dielectric Material on Decay of Surface Charge Deposited by Corona Discharge

This work investigates the effect of different dielectric barriers on coronadischarge in the needle-plane geometry, where a layer of dielectric material was placedover the surface of the plane electrode. Different dielectric materials used werepolytetrafluoroethylene (PTFE), polyethylene (PE), polycarbonate (PC), polyvinylchloride(PVC), epoxy and pressboard. The discharges were generated by the application ofperiodic negative step voltage pulses. The results show that the evolution of coronapulses over time depends on the dielectric properties of the barriers. Unlike pressboardwith a higher conductivity, the dielectric materials with a lower conductivity such as PTFEand PE would have more surface charges deposited on its surface during the firstcharging period of 100 ms, and the charges would not disappear during the relaxationperiod of 10 s, therefore, the discharge activities can be reduced significantly after thefirst charging period.QC 20150518</p