Novel Tunnel-Contact-Controlled IGZO Thin-Film Transistors with High Tolerance to Geometrical Variability.

Thin insulating layers are used to modulate a depletion region at the source of a thin-film transistor. Bottom contact, staggered-electrode indium gallium zinc oxide transistors with a 3 nm Al2 O3 layer between the semiconductor and Ni source/drain contacts, show behaviors typical of source-gated transistors (SGTs): low saturation voltage (VD_SAT ≈ 3 V), change in VD_SAT with a gate voltage of only 0.12 V V-1 , and flat saturated output characteristics (small dependence of drain current on drain voltage). The transistors show high tolerance to geometry: the saturated current changes only 0.15× for 2-50 µm channels and 2× for 9-45 µm source-gate overlaps. A higher than expected (5×) increase in drain current for a 30 K change in temperature, similar to Schottky-contact SGTs, underlines a more complex device operation than previously theorized. Optimization for increasing intrinsic gain and reducing temperature effects is discussed. These devices complete the portfolio of contact-controlled transistors, comprising devices with Schottky contacts, bulk barrier, or heterojunctions, and now, tunneling insulating layers. The findings should also apply to nanowire transistors, leading to new low-power, robust design approaches as large-scale fabrication techniques with sub-nanometer control mature

Photoconductive laser spectroscopy as a method to enhance defect spectral signatures in amorphous oxide semiconductor thin- film transistors

Defects in semiconductor thin-films often leave optical spectral signatures that can be used for their identification. In this letter, we report on spectrally resolved photoconductivity measurements of amorphous oxide semiconductor thin-film transistors. In contrast to previously reported photoconductive spectroscopy measurements recorded using spectrally filtered broadband light sources, we used a wavelength tunable picosecond laser to illuminate the thin-film. We extracted the absorption coefficient as a function of wavelength from the photocurrent measurement and showed that it followed the typical characteristic behaviour previously reported for amorphous oxide semiconductor thin-films. However, in addition, we observed several sharp spectral peaks in the photoconductivity spectrum which can be associated with sub-bandgap defects. These enhanced peaks are not normally visible in previously reported photoconductivity spectra. Furthermore, we show that we can control the sensitivity of our measurement by changing the applied gate bias voltage when the thin-films were fabricated into transistors. The enhancement achieved by using the wavelength tunable laser makes this a particularly sensitive characterisation tool and can additionally be used to discriminate between defects which have been incorporated after device fabrication

Tail state mediated conduction in zinc tin oxide thinfilm phototransistors under below bandgap optical excitation

Abstract: We report on the appearance of a strong persistent photoconductivity (PPC) and conductor-like behaviour in zinc tin oxide (ZTO) thinfilm phototransistors. The active ZTO channel layer was prepared by remote plasma reactive sputtering and possesses an amorphous structure. Under sub-bandgap excitation of ZTO with UV light, the photocurrent reaches as high as ~ 10−4 A (a photo-to-dark current ratio of ~ 107) and remains close to this high value after switching off the light. During this time, the ZTO TFT exhibits strong PPC with long-lasting recovery time, which leads the appearance of the conductor-like behaviour in ZTO semiconductor. In the present case, the conductivity changes over six orders of magnitude, from ~ 10−7 to 0.92/Ω/cm. After UV exposure, the ZTO compound can potentially remain in the conducting state for up to a month. The underlying physics of the observed PPC effect is investigated by studying defects (deep states and tail states) by employing a discharge current analysis (DCA) technique. Findings from the DCA study reveal direct evidence for the involvement of sub-bandgap tail states of the ZTO in the strong PPC, while deep states contribute to mild PPC

Role of ALD Al2O3 Surface Passivation on the Performance of p-Type Cu2O Thin Film Transistors

High-performance p- type oxide thin film transistors (TFTs) have great potential for many semiconductor applications. However, these devices typically suffer from low hole mobility and high off-state currents. We fabricated p-type TFTs with a phase-pure polycrystalline Cu2O semiconductor channel grown by atomic layer deposition (ALD). The TFT switching characteristics were improved by applying a thin ALD Al2O3 passivation layer on the Cu2O channel, followed by vacuum annealing at 300 degrees C. Detailed characterization by transmission electron microscopy-energy dispersive X-ray analysis and X-ray photoelectron spectroscopy shows that the surface of Cu2O is reduced following Al2O3 deposition and indicates the formation of a 1-2 nm thick CuAlO2 interfacial layer. This, together with field-effect passivation caused by the high negative fixed charge of the ALD Al2O3, leads to an improvement in the TFT performance by reducing the density of deep trap states as well as by reducing the accumulation of electrons in the semiconducting layer in the device off-state.Peer reviewe

Research data supporting “Spectroscopic ellipsometry characterization of ZnO:Sn thin films with various Sn composition deposited by remote-plasma reactive sputtering”

Data generated in the characterization and analysis of the Zinc Tin Oxide thin films (as shown in the Figures in the manuscript)EPSRC [EP/M013650/1

Spectroscopic ellipsometry characterization of ZnO:Sn thin films with various Sn composition deposited by remote-plasma reactive sputtering

AbstractZnO:Sn thin films were deposited onto thermally oxidized silicon substrates using a remote plasma reactive sputtering. Their optical constants (refractive index n and extinction coefficient k) were determined from ellipsometric data recorded over a wide spectral range (0.05–6eV). Parametrization of ZnO:Sn complex dielectric permittivity consists of a parameterized semiconductor oscillator function describing the short wavelength absorption edge, a Drude oscillator describing free carrier absorption in near-infrared part of spectra and a Lorentz oscillator describing the long wavelength absorption edge and intra-band absorption in the ultra-violet part of the spectra. Using a Mott-Davis model, the increase in local disorder with increasing Sn doping is quantified from the short wavelength absorption edge onset. Using the Wemple-DiDomenico single oscillator model for the transparent part of the optical constants spectra, an increase in the centroid distance of the valence and conduction bands with increasing Sn doping is shown and only slight increase in intensity of the inter-band optical transition due to Sn doping occurs. The Drude model applied in the near-infrared part of the spectra revealed the free carrier concentration and mobility of ZnO:Sn. Results show that the range of transparency of prepared ZnO:Sn layers is not dramatically affected by Sn doping whereas electrical conductivity could be controlled by Sn doping. Refractive index in the transparent part is comparable with amorphous Indium Gallium Zinc Oxide allowing utilization of prepared ZnO:Sn layers as an indium-free alternative

Promoting Low-Voltage Saturation in High-Performance a-InGaZnO Source-Gated Transistors

As oxide semiconductors increase in popularity with emerging flexible electronics, advances in material performance may lead to parasitic and non-ideal effects becoming more prominent. Specifically, in source-gated transistors, and other contact-controlled devices, the influence of the lateral drain field produced by drain bias leads to an overwhelming increase in charge density at the source edge and obliterates their signature flat saturation at low drain voltages. Here, we present high current density amorphous InGaZnO (a-IGZO) source-gated transistors (SGTs) in a bottom contact architecture using Pt source and drain electrodes. The devices were fabricated by ensuring an oxygen-rich atmosphere to prevent the formation of oxygen vacancies at the Pt/a-IGZO interface. Incorporating a field relief structure within the source contact improves drain current saturation, towards behavior predicted by the saturation coefficient. In the device architecture considered, the screening was less effective for a field plate insulator thickness under 30 nm, possibly due to increased tunnelling. Field plate incorporation is one of the strategies that ensures flat saturation and the suitability of contact-controlled transistors for a multitude of current driving and amplification applications

Coupled VO2 Oscillators Circuit as Analog First Layer Filter in Convolutional Neural Networks.

In this work we present an in-memory computing platform based on coupled VO2 oscillators fabricated in a crossbar configuration on silicon. Compared to existing platforms, the crossbar configuration promises significant improvements in terms of area density and oscillation frequency. Further, the crossbar devices exhibit low variability and extended reliability, hence, enabling experiments on 4-coupled oscillator. We demonstrate the neuromorphic computing capabilities using the phase relation of the oscillators. As an application, we propose to replace digital filtering operation in a convolutional neural network with oscillating circuits. The concept is tested with a VGG13 architecture on the MNIST dataset, achieving performances of 95% in the recognition task

Compact Source-Gated Transistor Analog Circuits for Ubiquitous Sensors

Silicon-based digital electronics have evolved over decades through an aggressive scaling process following Moore’s law with increasingly complex device structures. Simultaneously, large-area electronics have continued to rely on the same field-effect transistor structure with minimal evolution. This limitation has resulted in less than ideal circuit designs, with increased complexity to account for shortcomings in material properties and process control. At present, this situation is holding back the development of novel systems required for printed and flexible electronic applications beyond the Internet of Things. In this work we demonstrate the opportunity offered by the source-gated transistor’s unique properties for low-cost, highly functional large-area applications in two extremely compact circuit blocks. Polysilicon common-source amplifiers show 49 dB gain, the highest reported for a twotransistor unipolar circuit. Current mirrors fabricated in polysilicon and InGaZnO have, in addition to excellent current copying performance, the ability to control the temperature dependence (degrees of positive, neutral or negative) of output current solely by choice of relative transistor geometry, giving further flexibility to the design engineer. Application examples are proposed, including local amplification of sensor output for improved signal integrity, as well as temperature-regulated delay stages and timing circuits for homeostatic operation in future wearables. Numerous applications will benefit from these highly competitive compact circuit designs with robust performance, improved energy efficiency and tolerance to geometrical variations: sensor front-ends, temperature sensors, pixel drivers, bias analog blocks and high-gain amplifiers