Brane Formation and Cosmological Constraint on the Number of Extra Dimensions

Special relativity is generalized to extra dimensions and quantized energy levels of particles are obtained. By calculating the probability of particles' motion in extra dimensions at high temperature of the early universe, it is proposed that the branes may have not existed since the very beginning of the universe, but formed later. Meanwhile, before the formation, particles of the universe may have filled in the whole bulk, not just on the branes. This scenario differs from that in the standard big bang cosmology in which all particles are assumed to be in the 4D spacetime. So, in brane models, whether our universe began from a 4D big bang singularity is questionable. A cosmological constraint on the number of extra dimensions is also given which favors $N\geq 7$.Comment: 11 pages, no figures. To appear in IJT

Multi-wavelength observations of the binary system PSR B1259-63/LS 2883 around the 2010-2011 periastron passage

We report on broad multi-wavelength observations of the 2010-2011 periastron passage of the gamma-ray loud binary system PSR B1259-63. High resolution interferometric radio observations establish extended radio emission trailing the position of the pulsar. Observations with the Fermi Gamma-ray Space Telescope reveal GeV gamma-ray flaring activity of the system, reaching the spin-down luminosity of the pulsar, around 30 days after periastron. There are no clear signatures of variability at radio, X-ray and TeV energies at the time of the GeV flare. Variability around periastron in the H$\alpha$ emission line, can be interpreted as the gravitational interaction between the pulsar and the circumstellar disk. The equivalent width of the H$\alpha$ grows from a few days before periastron until a few days later, and decreases again between 18 and 46 days after periastron. In near infrared we observe the similar decrease of the equivalent width of Br$\gamma$ line between the 40th and 117th day after the periastron. For the idealized disk, the variability of the H$\alpha$ line represents the variability of the mass and size of the disk. We discuss possible physical relations between the state of the disk and GeV emission under assumption that GeV flare is directly related to the decrease of the disk size.Comment: accepted to MNRA

Effects of temperature on thick branes and the fermion (quasi-)localization

Following Campos's work [Phys. Rev. Lett. 88, 141602 (2002)], we investigate the effects of temperature on flat, de Sitter (dS), and anti-de Following Campos's work [Phys. Rev. Lett. \textbf{88}, 141602 (2002)], we investigate the effects of temperature on flat, de Sitter (dS), and anti-de Sitter (AdS) thick branes in five-dimensional (5D) warped spacetime, and on the fermion (quasi-)localization. First, in the case of flat brane, when the critical temperature reaches, the solution of the background scalar field and the warp factor is not unique. So the thickness of the flat thick brane is uncertain at the critical value of the temperature parameter, which is found to be lower than the one in flat 5D spacetime. The mass spectra of the fermion Kaluza-Klein (KK) modes are continuous, and there is a series of fermion resonances. The number and lifetime of the resonances are finite and increase with the temperature parameter, but the mass of the resonances decreases with the temperature parameter. Second, in the case of dS brane, we do not find such a critical value of the temperature parameter. The mass spectra of the fermion KK modes are also continuous, and there is a series of fermion resonances. The effects of temperature on resonance number, lifetime, and mass are the same with the case of flat brane. Last, in the case of AdS brane, {the critical value of the temperature parameter can less or greater than the one in the flat 5D spacetime.} The spectra of fermion KK modes are discrete, and the mass of fermion KK modes does not decrease monotonically with increasing temperature parameter.Comment: 24 pages, 15 figures, published versio

Performance of a small size telescope (SST-1M) camera for gamma-ray astronomy with the Cherenkov Telescope Array

The foreseen implementations of the Small Size Telescopes (SST) in CTA will provide unique insights into the highest energy gamma rays offering fundamental means to discover and under- stand the sources populating the Galaxy and our local neighborhood. Aiming at such a goal, the SST-1M is one of the three different implementations that are being prototyped and tested for CTA. SST-1M is a Davies-Cotton single mirror telescope equipped with a unique camera technology based on SiPMs with demonstrated advantages over classical photomultipliers in terms of duty-cycle. In this contribution, we describe the telescope components, the camera, and the trigger and readout system. The results of the commissioning of the camera using a dedicated test setup are then presented. The performances of the camera first prototype in terms of expected trigger rates and trigger efficiencies for different night-sky background conditions are presented, and the camera response is compared to end-to-end simulations.Comment: All CTA contributions at arXiv:1709.0348

Development of a strategy for calibrating the novel SiPM camera of the SST-1M telescope proposed for the Cherenkov Telescope Array

CTA will comprise a sub-array of up to 70 small size telescopes (SSTs) at the southern array. The SST-1M project, a 4 m-diameter Davies Cotton telescope with 9 degrees FoV and a 1296 pixels SiPM camera, is designed to meet the requirements of the next generation ground based gamma-ray observatory CTA in the energy range above 3 TeV. Silicon photomultipliers (SiPM) cameras of gamma-ray telescopes can achieve good performance even during high night sky background conditions. Defining a fully automated calibration strategy of SiPM cameras is of great importance for large scale production validation and online calibration. The SST-1M sub-consortium developed a software compatible with CTA pipeline software (CTApipe). The calibration of the SST-1M camera is based on the Camera Test Setup (CTS), a set of LED boards mounted in front of the camera. The CTS LEDs are operated in pulsed or continuous mode to emulate signal and night sky background respectively. Continuous and pulsed light data analysis allows us to extract single pixel calibration parameters to be used during CTA operation.Comment: All CTA contributions at arXiv:1709.0348

Control Software for the SST-1M Small-Size Telescope prototype for the Cherenkov Telescope Array

The SST-1M is a 4-m Davies--Cotton atmospheric Cherenkov telescope optimized to provide gamma-ray sensitivity above a few TeV. The SST-1M is proposed as part of the Small-Size Telescope array for the Cherenkov Telescope Array (CTA), the first prototype has already been deployed. The SST-1M control software of all subsystems (active mirror control, drive system, safety system, photo-detection plane, DigiCam, CCD cameras) and the whole telescope itself (master controller) uses the standard software design proposed for all CTA telescopes based on the ALMA Common Software (ACS) developed to control the Atacama Large Millimeter Array (ALMA). Each subsystem is represented by a separate ACS component, which handles the communication to and the operation of the subsystem. Interfacing with the actual hardware is performed via the OPC UA communication protocol, supported either natively by dedicated industrial standard servers (PLCs) or separate service applications developed to wrap lower level protocols (e.g. CAN bus, camera slow control) into OPC UA. Early operations of the telescope without the camera were already carried out. The camera is fully assembled and is capable to perform data acquisition using artificial light source.Comment: In Proceedings of the 35th International Cosmic Ray Conference (ICRC2017), Busan, Korea. All CTA contributions at arXiv:1709.0348

Brane matter, hidden or mirror matter, their various avatars and mixings: many faces of the same physics

Numerous papers deal with the phenomenology related to photon-hidden photon kinetic mixing and with the effects of a mass mixing on particle-hidden particle oscillations. In addition, recent papers underline the existence of a geometrical mixing between branes which would allow a matter swapping between branes. These approaches and their phenomenologies are reminiscent of each other but rely on different physical concepts. In the present paper, we suggest there is no rivalry between these models, which are probably many faces of the same physics. We discuss some phenomenological consequences of a global framework.Comment: 9 pages. Typo corrected. Published in European Physical Journal

Software design for the control system for Small-Size Telescopes with single-mirror of the Cherenkov Telescope Array

The Small-Size Telescope with single-mirror (SST-1M) is a 4 m Davies-Cotton telescope and is among the proposed telescope designs for the Cherenkov Telescope Array (CTA). It is conceived to provide the high-energy ($>$ few TeV) coverage. The SST-1M contains proven technology for the telescope structure and innovative electronics and photosensors for the camera. Its design is meant to be simple, low-budget and easy-to-build industrially. Each device subsystem of an SST-1M telescope is made visible to CTA through a dedicated industrial standard server. The software is being developed in collaboration with the CTA Medium-Size Telescopes to ensure compatibility and uniformity of the array control. Early operations of the SST-1M prototype will be performed with a subset of the CTA central array control system based on the Alma Common Software (ACS). The triggered event data are time stamped, formatted and finally transmitted to the CTA data acquisition. The software system developed to control the devices of an SST-1M telescope is described, as well as the interface between the telescope abstraction to the CTA central control and the data acquisition system.Comment: In Proceedings of the 34th International Cosmic Ray Conference (ICRC2015), The Hague, The Netherlands. All CTA contributions at arXiv:1508.0589

DigiCam - Fully Digital Compact Read-out and Trigger Electronics for the SST-1M Telescope proposed for the Cherenkov Telescope Array

The SST-1M is one of three prototype small-sized telescope designs proposed for the Cherenkov Telescope Array, and is built by a consortium of Polish and Swiss institutions. The SST-1M will operate with DigiCam - an innovative, compact camera with fully digital read-out and trigger electronics. A high level of integration will be achieved by massively deploying state-of-the-art multi-gigabit transmission channels, beginning from the ADC flash converters, through the internal data and trigger signals transmission over backplanes and cables, to the camera's server link. Such an approach makes it possible to design the camera to fit the size and weight requirements of the SST-1M exactly, and provide low power consumption, high reliability and long lifetime. The structure of the digital electronics will be presented, along with main physical building blocks and the internal architecture of FPGA functional subsystems.Comment: In Proceedings of the 34th International Cosmic Ray Conference (ICRC2015), The Hague, The Netherlands. All CTA contributions at arXiv:1508.0589

Using muon rings for the optical throughput calibration of the SST-1M prototype for the Cherenkov Telescope Array

Imaging Atmospheric Cherenkov Telescopes (IACTs) are ground-based instruments devoted to the study of very high energy gamma-rays coming from space. The detection technique consists of observing images created by the Cherenkov light emitted when gamma rays, or more generally cosmic rays, propagate through the atmosphere. While in the case of protons or gamma-rays the images present a filled and more or less elongated shape, energetic muons penetrating the atmosphere are visualised as characteristic circular rings or arcs. A relatively simple analysis of the ring images allows the reconstruction of all the relevant parameters of the detected muons, such as the energy, the impact parameter, and the incoming direction, with the final aim to use them to calibrate the total optical throughput of the given IACT telescope. We present the results of preliminary studies on the use of images created by muons as optical throughput calibrators of the single mirror small size telescope prototype SST-1M proposed for the Cherenkov Telescope Array.Comment: In Proceedings of the 34th International Cosmic Ray Conference (ICRC2015), The Hague, The Netherlands. All CTA contributions at arXiv:1508.0589