Shot Noise with Interaction Effects in Single Walled Carbon Nanotubes

We have measured shot noise in single walled carbon nanotubes (SWNT) with good contacts at 4.2 K at low frequencies ($f=600 - 850$ MHz). We find a strong modulation of shot noise over the Fabry-Perot pattern; in terms of differential Fano factor the variation ranges over 0.4 - 1.2. The shot noise variation, in combination with differential conductance, is analyzed using two (spin-degenerate) modes with different, energy-dependent transmission coefficients. No power law dependence of shot noise, as expected for Luttinger liquids, was found in our measurements.Comment: 5 pages, 4 figure

High-Yield of Memory Elements from Carbon Nanotube Field-Effect Transistors with Atomic Layer Deposited Gate Dielectric

Carbon nanotube field-effect transistors (CNT FETs) have been proposed as possible building blocks for future nano-electronics. But a challenge with CNT FETs is that they appear to randomly display varying amounts of hysteresis in their transfer characteristics. The hysteresis is often attributed to charge trapping in the dielectric layer between the nanotube and the gate. This study includes 94 CNT FET samples, providing an unprecedented basis for statistics on the hysteresis seen in five different CNT-gate configurations. We find that the memory effect can be controlled by carefully designing the gate dielectric in nm-thin layers. By using atomic layer depositions (ALD) of HfO$_{2}$ and TiO$_{2}$ in a triple-layer configuration, we achieve the first CNT FETs with consistent and narrowly distributed memory effects in their transfer characteristics.Comment: 6 pages, 3 figures; added one reference, text reformatted with smaller addition

CVD Synthesis of Hierarchical 3D MWCNT/Carbon-Fiber Nanostructures

Multiwalled carbon nanotubes (MWCNTs) were synthesized by CVD on industrially manufactured highly crystalline vapor-grown carbon fibers (VGCFs). Two catalyst metals (Ni and Fe) and carbon precursor gases (C2H2 and CO) were studied. The catalysts were deposited on the fibers by sputtering and experiments carried out in two different reactors. Samples were characterized by electron microscopy (SEM and TEM). Iron was completely inactive as catalyst with both C2H2 and CO for reasons discussed in the paper. The combination of Ni and C2H2 was very active for secondary CNT synthesis, without any pretreatment of the fibers. The optimal temperature for CNT synthesis was 750 ∘C, with total gas flow of 650 cm exp 3 min exp -1  of C2H2, H2, and Ar in 1.0:6.7:30 ratio.Peer reviewe

Robust Bessel-function-based method for determination of the (n, m) indices of single-walled carbon nanotubes by electron diffraction

We report a calibration-free method for the determination of chiral indices (n,m) of single-walled carbon nanotubes from their electron diffraction patterns based on Bessel function analysis of the diffracted layer lines. An approach has been developed for confident identification of the orders of the Bessel functions from the intensity modulations of the diffraction layer lines, to which (n,m) are correlated. In particular, we critically evaluate the effect of nanotube inclination on the validity of the method and show that the layer lines governed by high-order Bessel functions tolerate higher tilt angles than those of low-order Bessel functions and thus are favored for (n,m) evaluation. The method is of particular significance in that it considerably enhances the precision of chiral indexing and makes possible the analysis of high-order Bessel functions, especially when EDPs are of relatively low pixel resolution. The technique can be extended to structural analysis of double-walled carbon nanotubes.Peer reviewe

Influence of nanotube length and density on the plasmonic terahertz response of single-walled carbon nanotubes

We measure the conductivity spectra of thin films comprising bundled single-walled carbon nanotubes (CNTs) of different average lengths in the frequency range 0.3-1000 THz and temperature interval 10-530 K. The observed temperature-induced changes in the terahertz conductivity spectra are shown to depend strongly on the average CNT length, with a conductivity around 1 THz that increases/decreases as the temperature increases for short/long tubes. This behaviour originates from the temperature dependence of the electron scattering rate, which we obtain from Drude fits of the measured conductivity in the range 0.3-2 THz for 10 $\mu$m length CNTs. This increasing scattering rate with temperature results in a subsequent broadening of the observed THz conductivity peak at higher temperatures and a shift to lower frequencies for increasing CNT length. Finally, we show that the change in conductivity with temperature depends not only on tube length, but also varies with tube density. We record the effective conductivities of composite films comprising mixtures of WS$_2$ nanotubes and CNTs vs CNT density for frequencies in the range 0.3-1 THz, finding that the conductivity increases/decreases for low/high density films as the temperature increases. This effect arises due to the density dependence of the effective length of conducting pathways in the composite films, which again leads to a shift and temperature dependent broadening of the THz conductivity peak.Comment: Submitted to Journal of Physics D. Main manuscript: 9 pages, 8 figures. Supplementary material: 5 pages, 6 figure

Determination of helicities in unidirectional assemblies of graphitic or graphiticlike tubular structures

Here we propose a universal method for the determination of all helicities present in unidirectional assemblies of hexagon-based graphitic or graphiticlike tubular structures, e.g., multiwalled or bundled carbon nanotubes(CNTs) or boron-nitride nanotubes and their structural analogs. A critical dimension characteristic of a fundamental structural property, i.e., the atomic bond length, is discerned from electron diffraction patterns by which all helicities present in the assemblies are identified. Using this method, we determine the helicity population in a single-walled CNT sample produced by laser ablation technique.Peer reviewe

Atomistic mechanism of friction force independence on the normal load and other friction laws for dynamic structural superlubricity

We explore dynamic structural superlubricity for the case of a relatively large contact area, where the friction force is proportional to the area (exceeding $\sim 100\,nm^2$) experimentally, numerically, and theoretically. We use a setup comprised of two molecular smooth incommensurate surfaces -- graphene-covered tip and substrate. The experiments and MD simulations demonstrate independence of the friction force on the normal load, for a wide range of normal loads and relative surface velocities. We propose an atomistic mechanism of this phenomenon, associated with synchronic out-of-plane surface fluctuations of thermal origin, and confirm it by numerical experiments. Based on this mechanism, we develop a theory for this type of superlubricity and show that friction force increases linearly with increasing temperature and relative velocity, for velocities, larger than a threshold velocity. The MD results are in a fair agreement with predictions of the theory.Comment: Accepted to Physical Review Letters on November 14, 202

Influence of the diameter of single-walled carbon nanotube bundles on the optoelectronic performance of dry-deposited thin films

The optoelectronic performance of thin films of single-walled carbon nanotubes (SWCNTs) was studied with respect to the properties of both individual nanotubes and their bundles. The SWCNTs were synthesized in a hot wire generator aerosol reactor, collected by gas filtration and dry-transferred onto various substrates. By thus completely avoiding liquid dispersion steps, we were able to avoid any artifacts from residual surfactants or sonication. We found that bundle lengths determined the thin-film performance, as would be expected for highly resistive bundle–bundle junctions. However, we found no evidence that contact resistances were affected by the bundle diameters, although they did play a secondary role by simply affecting the absorption. The individual SWCNT diameters and their graphitization level as gauged by the Raman D band intensity did not show any clear correlation with the overall performance.Peer reviewe